查询词典 tensile strength

Experiments were arranged by adjusting the thicknesses of flyer and sample to change the tensile strain rate,in order to investigate the effect of the tensile strain rate on the spall strength.

采用轻气炮加载技术和激光速度干涉测速技术相结合，对不同拉伸应变率条件下20钢的层裂特性进行了实验研究。

Tensile strength corresponds to the maximum tensile stress that may be sustained by a specimen.

抗拉强度是指样品可能承受的最大拉伸应力。

The results showed the maximum cyclic stress of CFRP bar should be under 70 percent of ultimate tensile stress; when the maximum cyclic stress decrease 5 percent of ultimate tensile stress, the fatigue life of CFRP bars increase generally 10 times; with the decrease of cyclic ratios, the fatigue life of CFRP bars decrease heavily; for the brittleness, CFRP bar should possess a higher reserve of strength, the margin of safety against failure is a necessity; according to experimental cyclic stress-fatigue life curve, the fatigue behavior of CFRP bar is much better than the fatigue behavior of Q235 steel.

将纤维复合材料用于土木工程结构的研究成果，已应用于实际工程【2j_国外对CFRP筋的一些短期性能以及CFRP筋构件的粘结性能、CFRP加筋混凝土结构的抗弯性能等都做了大量的研究，但对其长国家自然科学基金50278029，50538020和交通部西部交通科技200l431882021资助项目。2OO6年2月13日收到初稿；2006年9月4日收到修改稿。本文联系人：欧进萍，院士期性能如疲劳性能的研究还不够

The synthesized PCU was then characterized by infrared spectroscopy, differential scanning calorimetry, thermogravimetric analysis, small-angle X-ray scattering, and tensile strength measurement. The IR showed that the polymer synthesized by the above two methods both have the polycarbonate-urethane structure and the tensile measurement showed good mechanical performance of the polymer. The DSC and TGA data showed that there is an obvious soft-hard glass transition area, which indicated the existence of the micro-phase separation structure. The extent of the phase separation was affected by the ratio of starting materials, the molecular weight of PCD, and the polymerization method. The decomposition upon heating was observed in two steps. SAXS result showed that the radius (r_2), the distance between domains (d_2), and gyral radius (R_2) of hard segment micro-domain were fairly affected by the starting materials ratio and soft segment content.

IR结果表明两种方法合成的聚合产物均具有聚碳酸酯聚氨酯的结构；拉伸实验表明聚合产物具有良好的力学性能；DSC、TG结果表明，聚合物呈现出较为明显的软硬段玻璃化转变区，表明存在微相分离的结构，相分离的程度受原料配比、软段分子量、聚合方法的影响，其热分解分为明显的两个阶段； SAXS结果表明，聚合物原料配比、软段含量的变化对硬段微区回旋半径R_2，微区间距d_2，微区半径r_2影响不大其值分别为9.5(A|°、29、7.4，但对软段的微区半径及间距影响较大，随着软段含量的增大，软段微区的半径r1和间距d1都增大。

The tensile property was improved and then stable with the increasing content of coupling agent, however, the crupture ratio up and then down. And the tensile strength increase stey by step and electric insulation property is up and then descended with the addition of radiation agents.

结果表明，随着阻燃剂含量的增加和粒径超细化，其阻燃性能不断得到提高；而随着偶联剂含量的增加，其拉伸强度逐渐增大到一定程度后趋向稳定，断裂伸长率则先增大后下降；随着辐照剂量的增大，拉伸强度逐渐增大，电气绝缘性能先上升后下降。

Based on a lot of experiments, it shows the distinct error between classical theory curve which express the relation of cell diameter, cell density and foam tensile strength , tensibility tensile product and re-spring degree and experiment curve. It also can＇t explain the relation of hole degree , area of cell wall with above four mechanics parameter. But the sub-cluster scale theory was demonstrated successfully to explain the relation of cell structure and foam mechanics property on different mold temperature, mold pressure, mold period and different chemical blowing agent, blowing activator content.

通过大量的实验结果理论分析表明：以往的经典理论存在着很多不足之处，它不能有效地解释孔径、泡孔密度与抗拉强度、断裂伸长率、断裂功、及回弹率之间的理论曲线与实验曲线之间的偏差，也不能解释空隙度、泡孔壁厚与上面四者之间的关系，而群子标度理论则成功地论证了在不同模压温度、模压压力、模压时间及不同用量发泡剂、发泡促进剂条件下泡体力学性能与结构之间的相关性。

The results indicate that the formation of loess vertical joints can be divided into two phases:① the formation of inner fissure, i.e. in the beginning of deposition, the undulation of terrain leads to uneven distribution of loess, then when it rains uneven collapsibility generates, which leads to generate inner fissures ;② the stage of fissure extension, namely loess continues deposition after the inner fissures have been formed, the increasing of the top pressure makes the top of inner fissure lie in the state of tensile stress, so, when the stress reaches its tensile strength, the inner fissure extends along the vertical direction and then becomes a vertical joint.

结果表明黄土垂直节理的形成可分为 2 个阶段：①内裂隙形成阶段，开始沉积时，由于地形的起伏导致黄土厚度上的分布不均匀，在降雨时产生不均匀湿陷，从而导致产生内裂隙；②裂隙扩展阶段，内裂隙形成后黄土继续堆积，顶部压力的增长致使裂隙顶部土体受到拉应力作用，当达到其抗拉强度时裂隙就会沿竖直方向产生扩张而形成垂直节理。

It indicates that the damnification morphology of K9 glass is cleavage damage, the reason of which is that the hoop tensile stress overtops materials'tensile strength. And the materials'damage threshold is inversely proportional to irradiation time.The mathematical model of in-band CW laser irradiating optical material is established.

结果表明：K9玻璃材料的损伤形态为解理破坏，破坏的原因是环向拉伸应力大于材料的抗拉强度，且材料的损伤阈值与辐照时间反向相关，即激光功率密度越高，造成破坏所需的时间越短。

In this paper, the mechanical property parameters of the adhesive were gotten by tensile test on standard sample at first. Then the single lap joint test of tensile shearing strength was designed and the loading-displacement curve including the cracking load was obtained. The experimental research provides the certain basis for the further research and application on the automotive structural adhesive.

本文首先制作了结构胶粘剂标准试样，通过拉伸实验测试了胶粘剂的相关力学性能参数；然后设计了单搭接拉伸剪切强度试验，测得该类型试件的载荷－位移曲线以及破坏载荷等重要数据，为今后车用结构胶合技术的进一步研究应用提供一定的实验依据。

A series of spot welding technology and joint tensile-shear tests for uncoated low carbon, electroplated and two kinds of hot dipped zinc-coated steels were made to improve the quality of spot welding joint for zinc-coated steels. The test results were analyzed with computer regressive method. The effects of welding current or time on nugget diameter or joint tensile-shear strength and critical curves in splash generation for spot welding were obtained.

摘 要：为提高镀锌钢板点焊接头的质量，对普通冷轧钢板、电镀锌钢板和两种镀锌层厚度不同的热镀锌钢板进行了一组点焊工艺及接点强度试验，并对试验结果进行了计算机回归分析，分别得出了这几种材料在不同的焊接电流、焊接时间下的点焊熔核直径或接头拉剪强度变化曲线以及点焊飞溅临界曲线。

"Yes, now you can give yourself airs," she said, you have got what you wanted.

"对了，您现在高兴了，"她说道，这是您所期待的。

Then the LORD said to me: Rebel Israel is inwardly more just than traitorous Judah.

上主于是对我说：＂失节的以色列比失信的犹大，更显得正义。