查询词典 tensile strength

In this paper,a two dimension variation method is applied to compute tensile fracture surface fractal dimensions of a grain composite material LDPE/CaCO 3,and set the relationship of tensile fracture surface fractal dimensions and tensile ultimate stress and material filler weight content percent .

应用计算断口表面分形维数的二维变差法，计算了颗粒复合材料LDPE／CaCO3拉伸断口的分形维数，并且建立了断口分形维数与强度极限和填料颗粒含量之间的关系。

Positive tensile stress on iron undersurface relaxes to the inner of iron and negative tensile stress on iron undersurface concentrates on the side of iron as the temperature declining, so cracks easily appear at the site where positive and negative tensile stress cross.

在冷却过程中，铸铁下表面的拉应力逐渐向铸铁内部释放；同时，压应力逐渐向铸铁的两侧端面集中。因此在拉应力和压应力的交界处，容易产生裂纹。

RESULTS:①There was higher tensile stress at the ingual side of symphysis, inside of molar and outside of condyle under the impact of chin.②There was higher tensile stress at the lingual side of symphysis, inside of contralateral molar, outside of contralateral angle, outside of homolateral angle and inside of homolateral body under the impact of body.③There was higher tensile stress at the inside of angle, inside of homolateral condyle, lingual side of symphysis, outside of contralateral condyle and inside of homolateral molar under the impact of angle.

结果：①撞击颏部，其舌侧区，磨牙后区内侧面、髁状突颈外表面以及下颌角外表面具有较高的张应力；②撞击下颌体部，颏部舌侧区，对侧磨牙后区内侧面、对侧下颌角外表面、撞击侧下颌角外侧面、撞击侧体部内侧面具有较高的张应力；③撞击下颌角，其内侧面、撞击侧髁状突颈内侧面、颏部舌侧面、对侧髁状突颈外表面以及撞击侧磨牙后区内侧面具有较高的张应力。

These will provide theoretical guides for the design and the exploit of new products; By means of tensile testing of large number of the bi-axial warp-knitted fabrics, this paper delineated the inherent law of tensile properties especially in the relationships between the ground structures, materials and the fabric tensile properties; This paper also explained the problems existing in the domestic testing standard and measurement method of the warp-knitted grid products.

这个理论模型将为经编双轴向立体骨架织物的性能设计及生产提供很好的理论保证；本文通过对大量经编双轴向立体骨架织物拉伸性能的测试，了解掌握了该类织物拉伸性能的内在规律，为该类织物的性能设计打下了坚实的基础。

FIGS. 1 and 2 show the influence of billet temperature and time on ultimate tensile strength and tensile yield strength.

图1和2示出了坯料温度和时间对极限拉伸强度和拉伸屈服强度的影响。

The in-plane equivalent elastic modulus and tensile strength of stitched composite laminates are studied, and its found that the in-plane equivalent elastic modulus decreases with the increase of stitch density, stitch thread diameter, maximal misalignment angle and the distortion width, and the range is about 5%. The tensile strength of stitched composite laminate increases with the increase of stitch step and decreases with the stitch space.

研究结果表明：随着缝纫密度、缝纫线直径、最大纤维偏转角和缝纫变形区宽度的增加，缝纫复合材料层合板面内等效模量逐渐降低，最大降幅一般在5%左右；缝纫复合材料层合板的拉伸强度随缝纫针距的增加而增大，随缝纫行距的增加而降低，因此缝纫密度对拉伸强度的影响程度要看具体的缝纫针距和行距。

Numerical calculation of FEM and experimental investigations are used in the present research. The influence of loading condition and size of indenter on the tensile strength of rock has been investigated. The results obtained by numerical calculation and experiments show that tensile strength of rock will increase with the increase of indenter size.

通过有限元数值计算与理论分析相结合的方法，对不同载荷接触条件和接触面宽度角下的岩石抗拉强度进行了深入分析，结果表明，在圆弧形和平台加载条件下计算的岩石抗拉强度随载荷接触宽度角α的增大而增大。

The results showed the specimens by vacuum sintering had a typical Widmannstatten microstructure, which possessed coarser prior β-grains and secondary platelet α+β-phase, but the alloy had a more microporosity and a lower tensile strength and ductility. After HIP treatment, prior β-grains and secondary platelet α+β-phase became fine and uniform, and the alloy possessed a less microporosity and a higher tensile strength and ductility.

结果表明：真空烧结Ti-6Al-4V合金具有典型的魏氏体组织，其初始的β晶粒粗大，β晶粒内为次生片状α和薄β相片，空隙较多，合金的强度和塑性较低；合金经热等静压处理后，组织明显细化且均匀，空隙很少或几乎没有，从而强度和塑性都有所提高。

The results showed that the influence of the percentage of the needle-shaped fiber on the impact strength of NF-WPC was significant, while much more significant on the bending and tensile properties. The percentage of MAPE influenced significantly to the tensile strength and toughness of NF-WPC. In the conditions of this paper the dimension of wood fiber and the percentage of lubricant paraffin had a minor influence on the mechanical properties of NF-WPC.

结果表明：针状木纤维的含量对NF-WPC冲击强度影响显著，对弯曲性能和拉伸性能的影响高度显著；偶联剂马来酸醉接枝聚乙烯的添加量对NF-WPC的拉伸强度、断裂伸长率和冲击强度影响显著；在本文的试验范围内，木纤维尺寸和润滑剂石蜡的含量对NF-WPC力学性能的影响不显著。

The results show that the hydraulic fracturing pressure is intimately related with tensile strength and tridimensional stress state of the soil. With the increase of tensile strength and minor principal stress, the fracturing pressure is enhanced.

土体发生水力劈裂时的劈裂压力与土的抗拉强度和土体所处的应力状态之间有着密切的关系，劈裂压力随着土的抗拉强度和小主应力的增加而增加。

"Yes, now you can give yourself airs," she said, you have got what you wanted.

"对了，您现在高兴了，"她说道，这是您所期待的。

Then the LORD said to me: Rebel Israel is inwardly more just than traitorous Judah.

上主于是对我说：＂失节的以色列比失信的犹大，更显得正义。