查询词典 temperature

The results showed that the calcined bone ash obtained at 1200℃ had clear outline, spherical and mode-ratesize particles. These characteristics were benificial to improve the slurry fludity, broaden the sintering temperature range and increased the whiteness of bone china bulk. It is concluded that the moderate calcining temperature range of bone china bulk is 1200-1300℃.

实验结果表明，在1200℃下对骨灰进行煅烧，可获得轮廓清晰、周球形和颗粒尺寸适中的煅烧骨灰，有利于提高骨质瓷坯体浆料的流动性，扩大坯体烧结温度范围，并且能提高坯体的白度。

Now disk use on bookbinder of EVA hotmelts, gummed general control temperature of 160 ° c-38, 180, the side between the partⅱ temperature general control in 90 ~ 110 ° c, before using the left and right must be warming up to 2 hours to give them good mobility.

现在圆盘胶订机上使用的EVA热熔胶，背胶的温度一般控制在160～180℃之间，侧胶的温度一般控制在90～110℃之间，使用前必须预热2小时左右，使其有良好的流动性。

The effect of treating condition (form of boron used, the concentration, temperature of the solution of boride, the heat-treatment temperature) on the mechanical properties of the resulting carbon fibers was investigated.

研究了处理液组份、浓度、温度和石墨化热处理温度对最终碳纤维力学性能的影响。通过力学性能的变化评价了硼改性的效果。

The influence of those main design parameterssuch as evaporation saturation temperature t_s、heat dissipated power Q and charge ofworking fluid L on the temperature distribution of evaporation"s bottom and boiling heat transfer inside the evaporation has been calculated and analyzed concretely. The method that uses channels to enhance boiling heat transfer of evaporation"s bottom has also been analyzed and calculated preliminarily.

具体计算和分析了蒸发饱和温度t_s、散热功率Q和充液量L等主要设计参数对蒸发段底面温度分布和蒸发段内部沸腾传热特性的影响，对用槽道强化蒸发段底面沸腾换热也做了初步的数值计算和分析。

First, the linear combinations of basic set of solutions to Laplace equation under polar coordinate system are chosen as the approximations for the solution of temperature fields,boundary residual collocation method are applied to calculate the distribution of the temperature fields for single-particle model.

本论文主要完成了两方面的工作，一方面是采用加权残值法和边界元法对不同复合材料模型的2D稳态热传导的温度场进行了求解分析。

Based on the experimental data, all the parameters in the R-G equation are got, which are used to characterize the curve of firstly breaking up and decaying stress of the waxy crude oil at different temperature. The relationship between these parameters and temperature are also studied and made clear.

利用实验数据获得了不同温度下描述大庆原油初次裂降过程的R-G模型方程中的模型参数，对模型中的参数与温度的关系进行了曲线拟合，得到了各参数与温度的关系。

In this foundation, proposed uses the digital temperature sensor examination to transform - the monolithic integrated circuit to pass through the fuzzy PID algorithm control solid state relay breakover cycle way to carry on the Y802 constant temperature oven warm to control the system the improvement design.

在此基础上，提出采用数字温度传感器检测转换-单片机经过模糊PID算法控制固态继电器导通周波的方式进行Y802 型恒温烘箱的温控系统的改进设计。

Effect of polyvinyl alcohol treatment under low temperature(5℃) and normal temperature on seed vigour and seedling emergence of Sea buckthorn was studied.

以沙棘种子为试材，研究聚乙烯醇在5℃低温和常温下处理对种子活力和出苗的影响。

The experiment results prove that the boiler coking is largely reduced and the temperature difference of two sides of horizontal gas-pass is very small, when the 330MW boiler operate, the pressure of primary hot air parison is controlled beyond 12.0～12.5KPa, the O2 content of air pheheater is controlled about 3.0%, the door of OFA is opened to 30%, the buffle of the inner secondary air sleeve is adjusted to the minimum, the outer secondary air swirling strength and the baffle of the outer secondary air sleeve is regulated to the maximum and the outlet temperature of pulvervised mill is kept in 70℃.

试验结果表明，330MW运行时，一次热风母管压力控制在12.0～12.5kPa以上、空气预热器实际氧量控制在3.0％左右、燃尽风门开至30％、内二次风量套筒挡板调整在最小、外二次旋流强度和外二次风套筒挡板调整到最大、磨煤机出口温度维持在70℃，此时锅炉结焦大幅度减轻，水平烟道两侧烟温差非常小。优化试验完成后，进行了单烧灵武烟煤对比，结果是：掺烧高灰熔点的银北煤后，炉膛结焦大幅度减轻，锅炉过热器减温水量较小，主蒸汽压力易提高，带负荷能力正常；再热器烟气挡板开度较大、减温水量较小；风机电耗较小。

When you print, make sure that a clean glass plate burning, no dirt, use a soft, fibrous materials, so as not to scratch the surface of the glass;(2) make sure that the exhaust gas pumping clean to avoid exposure of incomplete, dot ambiguous waste plates;(3) choose to design a reasonable moisture、illumination uniform lighting, General wavelength in the range 450nm 350 MW to 750 MW is the best light source;(4) to determine the reasonable exposure time, you can use transmissional laodelphax wedges or the Chief harunar test to determine the net-point-to-value, select the exposure time; and (5) according to the developering concentration and temperature changes in the regulation of the speed of the treatment of development machine, such as temperature and concentration to speed up the pace of the appearing of the appearing on the other hand reducing speed so as to ensure the quality of the treatment of development; the treatment of development has been completed, plates well-proportioned coating protect the plastic and put it in place with dry.

1晒版时要包管晒版玻璃肮脏，无污物，用质地刚软的纤维货色擦拭，以免划伤玻璃背；(2)抽气时必定不兵气体抽肮脏，制止曝光不彻底，网不背不澄辉而爱惜印版；(3)拔取安排公道、光照平均的灯具，凡是波长在350～450nm边界边为最好光源；(4)猜测公道的曝光工夫，可以用透射灰梯尺或布鲁纳尔尝试条，猜测网不背成数，拔取曝光工夫；(5)根据显影液的浓度和温度改变环境调度显影机的不缓率，如温度和浓度功矮，可不收慢显影不缓率，反之贬低显影不缓率，以包管显影质度；(6)显影达成后，在印版表背平均涂布爱护胶，然后不收在透风处潮湿。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。