查询词典 temperature

Through the comparison of the growth status of both the two strains under different environmental conditions (different temperature, pH values, high alcoholicity, high sugar content, and high salinity), it was reveal that UT1 strain has better tolerance to the change of temperature, acidity and salinity, which suggested that strain with stronger stress resistance is helpful to achieving higher alcohol yield.

比较两者分别在不同温度和不同pH，以及在高酒精度、高糖分和高盐分的环境下的生长状况，发现UT1对温度、酸度和盐度变化的耐受力更好，说明生长耐受能力强有助于酵母在高温下提高产酒率。

The results showed:(1) Through glycosylated orthogonal test, When the substrate concentration is 1:2, glycosylated temperature is 60℃, the enzyme dosage is 0.5%and glycosylated time is 6 hours, glycosylating was at best, and the sugar concentration was 33%(2) through fermentation orthogonal test, when adding the yeast is 2.0%, proportion of Rhodiola and glutinous rice is 1:1, the temperature is 28℃, and fermentation time is seven days, alcoholicity of the wine was the highest and sensory evaluation was the best..

本文立足加工高品质的红景天糯米保健酒，主要对糖化条件，发酵工艺参数的确定，后发酵温度的确定，稳定性试验，膜过滤试验条件，营养成分分析等方面进行系统的研究，结果表明：(1)通过糖化正交试验，在底物浓度1∶2、糖化温度60℃、酶用量0.5％、糖化6h时糖化效果最好，糖液浓度33％；(2)通过发酵正交试验，在酵母添加量2.0％、红景天糯米比1∶1、发酵温度28℃、发酵时间7天生成的酒度最高，感官评价最好；(3)通过后发酵试验，选择10～15℃温度下后发酵，酒体澄清，感官评价最好；(4)从对红景天糯米酒稳定性分析中得知：酒体在低于-6℃时略有絮状物出现，酒体混浊沉淀的主要原因可能是蛋白质。

Alcohol ferment control in first pol 16°Bx and yeast inoculation quantity 10%, ferment temperature is 28 ℃, first acidity in enzyme untie the natural acidity of persimmon juice take off , ferment 3 days,and then filtrate; the acetic acid ferment select the first alcoholicity of 8v/v ,the inoculation quantity of 14%, ferment temperature is 30 ℃, ferment 5 days had better.

酒精发酵在酶解柿子浆自然酸度下，控制初糖度16°Bx，酵母接种量10%，发酵温度28℃下发酵3天后过滤去渣取上清液进行醋酸发酵。醋酸发酵选择初始酒精度为8v/v，14%接种量，发酵温度30℃，发酵5天为好。

Alcohol ferment control in first pol 16°Bx and yeast inoculation quantity 10%, ferment temperature is 28 ℃, first acidity in enzyme untie the natural acidity of persimmon juice take off , ferment 3 days,and then filtrate; the acetic acid ferment select the first alcoholicity of 8vv ,the inoculation quantity of 14%, ferment temperature is 30 ℃, ferment 5 days had better.

酒精发酵在酶解柿子浆自然酸度下，控制初糖度16°Bx，酵母接种量10%，发酵温度28℃下发酵3天后过滤去渣取上清液进行醋酸发酵。醋酸发酵选择初始酒精度为8vv，14%接种量，发酵温度30℃，发酵5天为好。

The red of Aldebaran is typical of the lower surface temperature of an older star, whereas the blue of the Pleiades reveals their high surface temperature and young age.

毕宿五的红色是典型的表面温度低的老年星，而昴宿星团的蓝色则表明他的年轻和很高的表面温度。

In this paper, through a series of experiments, two series of quaternary-ammounium Gemini surfactants were synthesized, namely the pair alkylene double quaternary ammonium salt surfactant m-s-m·2Br and the pair the alkylene double quaternary ammonium salt surfactant -s-·2Br. We has carried on the attribute with the infrared spectrum to its structure, and to affected the factor which the synthesis pair the alkylene double quaternary ammonium salt surfactant responded to carry on the discussion. We has discovered the synthesis pair the ethylene double quaternary ammonium salt surfactant m-2-m·2Br optimum condition: The bromo alkane and a tetramethyl ethylene diamine mole of ratio is 3.0: 1.0, makes the solvent by the ethyl alcohol, 80℃ under responds for 48 hours in the backflow temperature; Synthesis pair alkylene double quaternary ammonium salt surfactant 12-S-12 ·2Br optimum condition: 12 tertiary amine and 1, 3- propylene dibromide (1, 4- two bromines butane) a mole of ratio is 2.2: 1.0, makes the solvent by the ethyl alcohol, responds for 48 hours in the constant temperature 80 ℃ under backflow.

本文通过一系列的实验，合成了两个系列的Gemini型表面活性剂，即双烷撑双季铵盐表面活性剂m-s-m·2Br和双烷撑双季铵盐表面活性剂-s-·2Br，用红外光谱对其结构进行了表征，并且对影响合成双烷撑双季铵盐表面活性剂反应的因素进行了讨论，找出了合成双乙撑双季铵盐表面活性剂m-2-m·2Br的最佳条件：溴代烷与四甲基乙二胺的摩尔比为3.0：1.0，以乙醇作溶剂，在回流温度80℃下反应48小时；合成双烷撑双季铵盐表面活性剂12-s-12·2Br的最佳条件：十二叔胺与1，3-二溴丙烷(1，4-二溴丁烷)摩尔比为2.2：1.0，以乙醇作溶剂，在恒温80℃下回流反应48小时。

Marc was used to calculate the temperature distribution of All-metal radiation shields and uniformity of furnace temperature.

利用MSC.Marc有限元软件对真空热处理炉各层间的温度分布和炉温均匀性进行了计算。

Through simulation in computer using the all-purpose computer simulation software secondary cooling in slab continuous casting and test results, the influence of the factor such as casting speed, casting temperature, shell thickness and secondary cooling system are analyzed. The secondary cooling system is evaluated, the reasons of crack are analyzed. And the solution scheme is obtained. Strand temperature is measured on site in Basteel.

应用仿真软件和实验数据对宝钢1930铸机进行了仿真计算，分析了拉速、配水制度、过热度对铸坯温度场和坯壳厚度的影响；对宝钢1930铸机的二冷制度进行了评估，分析了产生裂纹的原因；并对二冷制度进行优化，提出了改进建议。

Any case, the element of metal surface temperature shall not exceed the allowable temperature of steel.

任何情况下，元件金属的表面温度不得超过钢材的允许使用温度。

Heating promoted a remarkable decrease in aloin and protein contents depending on temperature and time, higher temperature and longer heating time, more loss.

两种芦荟汁中芦荟苷和蛋白质对热都不稳定，温度越高，稳定性越差。

The witness also told the jury at the Royal Courts of Justice in London that he saw a paparazzo fighting with a member of the public who was trying to stop him taking pictures in the minutes before the emergency services arrived.

他还告诉在伦敦皇家法庭的陪审团，在急救服务到来之前，他当时看见一个狗仔队正和一群阻止他拍照的人打架。

The entire N／C program on a tape is made up of an accumulation of these successive data blocks.

纸带上的整个数控程序由这些连续数据单元连接而成。