查询词典 temperature

Regression analysis indicates, the major factors ingrowing season are: radiation, soil moisture, relative humidity, air temperature and surface temperature; the factors in non-growing season are: radiation, surface temperature and wind speed.

回归分析表明影响生长季主要因素有：净辐射、土壤含水量、相对湿度、气温和地表温度；影响非生长季主要有：净辐射、地表温度和风速。

The result indicates that the potential-pH equilibrium diagram, solution's practical pH and metal corrosion's measured potential at corresponding temperature must be used when potential-pH equilibrium diagram is used. And also the potential-pH equilibrium diagram in Fe—H〓O system at different temperature is gathered and classified. According to thermodynamics data, the relation equation of water ionization equilibrium constant K〓 and of ammoniac equilibrium constant K〓 to temperature T is respectively derived.

二、高温电位-pH平衡图的应用与高温溶液实际pH值的计算对高温电位-pH平衡图的应用方法和溶液的高温实际pH值进行了分析和计算，指出在用电位—pH图进行分析时，必须使用相应温度下的电位—pH图、该温度下溶液的实际pH值和金属腐蚀电位测量值，并对各种温度下Fe—H〓O体系的电位－pH图进行了收集归类。

The results show that the rate of heating decreases due to the growth of oxidation layer in soaking process when the thermal resistance between gas and slab increases. The quantity of loss of iron scale increases with the increase of the coefficient of air consumption under the condition of certain soaking temperature. When the coefficient of air consumption is certain, the quantity of loss of iron scale increases with the increase of soaking temperature rapidly. The results of numerical simulation is consistent with experimental ones, and the error is very small within the range of soaking temperature in CSP line.

研究结果表明：在加热过程中生成的氧化层增大了换热热阻，使钢坯的加热速度减小；钢坯氧化烧损量随加热速度的增大而减小；当达到同一特定的均热温度时，钢坯氧化烧损量随空气消耗系数的增大近似呈线性递增；当空气消耗系数一定时，钢坯氧化烧损量随均热温度的提高而急剧增加；数值计算结果与实验结果变化趋势一致，并在CSP均热温度范围内较吻合。

The results show that the spreading area of series Ni-P filler metal increases with the increase of brazing temperature, and the spreading areas of Ni-P filler metal is larger than that of Ni-Cr-P filler metal; the shear strength of the brazed joint at room temperature increases with the increase of temperature from 925℃ to 1000℃, and the shear strength of the stainless steel joint brazed with Ni-P filler metal is superior to that with Ni-Cr-P filler metal by 30~40 MPa in the same brazing technology.

结果表明，Ni-P系钎料铺展面积随钎焊温度的升高而增大，并且相同温度下不含Cr的Ni-P钎料铺展面积大于Ni-Cr-P的铺展面积；钎焊温度从925 ℃升高到1000 ℃过程中，Ni-P、Ni-Cr-P钎料钎焊不锈钢接头的室温剪切强度均增大，并且在相同钎焊工艺下，不含Cr的Ni-P钎料钎焊不锈钢接头室温剪切强度优于Ni-Cr-P钎焊接头强度30~40 MPa；Ni-P系钎料钎焊接头高温强度随温度升高而下降，测试温度超过500 ℃时，相同温度下含Cr的钎料能够提高钎焊接头强度0~30 MPa。

The weld parameters and other process variables (joint mismatch, root gap, thickness of parts, and part composition) effect the pool shape (determined from temperature distribution), the absolute temperature near the pool, and the temperature distribution symmetry around the pool.

焊接参数和其他工艺变量（焊缝的错位、焊根的缝隙、零件的厚度和零件的成份）都会影响熔池形状，熔池附近的绝对温度和熔池周围温度分布的对称情况。

Under the condition of organic chlorine content 0.25-0.53% of the input refuse and the furnace temperature range of 939-1,033℃, rise with furnace temperature, the proportion of lead transferred into gaseous is increased, and the lead content of fly ash and reaction ash increases obviously. It can be expressed as y1 =11.051x－9824.9 and y2 =26.729x－23680, where x is the furnace temperature, y1 and y2 are the content of lead in fly ash and reaction ash.

基於进料综合垃圾有机氯含量0.250.53％之条件下，在9391，033℃之炉温范围内，随著炉温升高，重金属铅由固相转移至气相的比例增加，飞灰及反应生成灰之铅全含量皆有明显上升之趋势，可以回归式表示为y1 = 11.051x – 9824.9以及y2 = 26.729x – 23680，其中x为炉温，y1、y2则分别为飞灰及反应生成灰之铅全含量。

Stress relaxation of delignified and hemicellulose-removed wood was determined during periodic temperature change, and found that after 4-hour relaxation at 25℃ the stress curves hardly level off, at this time when increase temperature the stress immediately sharply fall and whereafter the decrease of temperature make stress rapidly recover again.

通过木材在温度周期变化过程中的应力松弛研究，发现，未处理木材和化学处理木材在25℃松弛4小时后，应力几乎水平下来，升温后，应力立即急剧下降，温度下降时，应力又急剧回复。

Typically, the cast of the long-necked type valve cover has good heat dissipation and high temperature adaptation, be used for high temperature applications; stainless steel valve cover assembly of the long neck has a lower thermal conductivity and good low-temperature adaptation sex, were used in cryogenic applications.

通常，铸造的长颈型阀盖具有较好的散热性和较高的高温适应性，被用于高温应用场合；不锈钢装配的长颈型阀盖具有较低的热传导性和较好的低温适应性，被用于低温应用场合。

The results showed that the developmental threshold of egg, larva and immature periods was 12.67, 13.86 and 13.53℃, respectively. It revealed parabola relationship between temperature and both generation survival and finite increase rates. According to the corresponding parabola functions, the optimal temperature for survival and population increase was 30.2 and 33.7℃, respectively, and the optimal temperature range for growth and development of C. maculates was between 30 and 34℃.

结果表明：四纹豆象卵期、豆内幼虫及蛹期、未成熟期发育点温度分别为12.67，13.86和13.53℃；温度与世代存活率及周限增长率均呈二次抛物线关系，根据相应抛物线方程可知，四纹豆象理论最适生存温度和最适种群增长温度分别为30.2℃和33.7℃，其生长发育繁殖的最适温区为30～34℃。

Analyses of the EAWJ seasonal variation and the atmospheric meridional temperature gradient in the mid-upper troposphere indicate that the EAWJ center always corresponds to the largest meridional temperature gradient in the mid-upper troposphere, suggesting that the seasonal variation of EAWJ is a response to the meridional temperature difference.

分析急流与对流层中上层经向温度梯度的季节变化发现，急流出现的位置总是对应着经向温度梯度较大区域，急流中心有随气温南北差异大值中心移动的趋势，急流中心与最大温差中心相对应，表明急流中心的位置变化是对气温南北差异季节变化的响应。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。