查询词典 temperature

While 30-year mean temperature data from 624 meteorological stations in China was spatialized, the temperature was divided into regular component, which is affected by longitude, latitude and altitude, and irregular component affected by other local factors. They were spatialized with multiple variable regression and inverse distance weighted interpolation respectively. There was a correlation ratio of R=0.98 between temperature and geographical factors including longitude, latitude and altitude.

在对中国624个气象站多年平均气温数据空间化过程中，通过30秒分辨率的数字高程数据，把气温分解为受经纬度、海拔高度影响的规律性成分和受其它因素影响的非规律性成分两部分，并分别用多元回归和反距离权重内插方法对二者实施空间化，最后将空间化结果进行合成得到基於栅格的中国多年平均气温分布数据。

The results show the inwall temperature of closed bomb can be measure with the given model and its solution. The obtained curve of the inwall temperature vs time before the peak value is smooth. It is very important for further study on the maximum temperature.

结果表明：给出的软测量模型以及解法可以实现爆发器内壁温度的测量；获得的内壁温度曲线在峰值之前的部分具有很好的光滑性，这对于进一步研究峰值问题具有重要意义。

Thereby the stable temperature field is analyzed by using the finite element method, and the mean temperature, temperature difference between the inwall and outer wall of the tube sheet and cylinder are worked out, which is taken as the heat load for an analysis of the stress field.

为此， 运用有限元法对稳态温度场作了计算，求得管板、筒体等部件的平均温度、内外壁温差，并将这些参数作为应力场分析的热载荷；将废热锅炉离散为由板壳元和杆单元组成的空间结构，对自重、压力、温度组合的4 种工况进行计算，得到管板、筒体等部件的应力场分布规律。

Schapery model can be used to calculate the CTE of composite when temperature is lower(50-100C) and Kerner model can be used when temperature is higher (300-450C). The CTE of composite will increased more quickly than that by three models when temperature is between(100-300C).

复合材料的热膨胀系数在温度较低(50～100℃)时可用Schapery模型计算，在高温(300～450℃)时可用Kerner模型计算，在100～300℃之间则随温度升高增加的很快，且与所有模型分析结果不一致。

The result show that computational temperature lapse rate by sounding temperature reflect the vertical variation of air temperature of high-cold arear, could be used in runoff simulation to inland river lack of data.

结果表明：由探空气温计算出的气温直减率在一定空间范围内可以反映高寒区气温的垂直变化规律，可用于资料缺乏区内陆河径流模拟。

By using the air temperature measured by thermocouples and the glass temperature measured by infrared thermometer as the training sample, a model for prediction of the temperature parameters for the float glass in lehr was created based on the ameliorated BP neural network.

摘要利用热电偶测得的退火窑中空气温度和红外测温仪测得的玻璃表面温度作为训练样本，建立了基于BP神经网络的玻璃温度预测模型。

In the range from 0 to 25MPa, the linear degree of pressure-cavity length curve is 0.99996 and the sensitivity is 2nm/MPa . The temperature dependence effect of this sensor is small. In the temperature range from 22℃ to 200℃, the temperature sensitivity of the F-P cavity is about 0.03nm/℃.

实验结果表明，本文设计的微型EFPI光纤压力传感器性能良好，在0～25MPa范围内，压力—腔长关系曲线的线性度达0.99996，腔长一压力灵敏度为2nm/MPa；该传感器温度敏感性小，在22～200℃的温度范围内，腔长的温度敏感性约为0.03nm/℃。

The heat generation curves of seven rubber materials used in tires with the changes of temperature have been obtained by using Dynamic Mechanics Analysis technique on NETZSCH DMA242 instrument, knowing that the heat generation of every other rubber materials except inner liner rubber changes lightly alone with the temperature within 10℃～80℃. According to the Fourier law, the heat transfer coefficients of tire rubber are measured by stable method on self-made experiment instrument. The coefficients changes lineally within 20℃～80℃ and the relation formulas λ=λ〓+bt are given out attached with λ〓 and b. The specific heat of tire rubber are measured on Differential Scanning Calorimeter NETZSCH DSC204 and the relations with temperature are linear and the formula is c=c〓+bT, where c〓 and b gained from experiment result data are presented in the paper. The heat convection coefficients on the surface of rolling tire are measured according to the principle of heat-mass transfer analogy principle after simplifying rolling tire into rotating disk with straight movement on wind channel. The relation with rotation speed of disk is linear as h=5. 399+0.0258n and the relation with straight line speed of tire is linear too, h=

论文采用动态力学分析技术，使用NETZSCH DMA 242型实验仪，获得了轮胎用七种胶料的生热率随温度变化曲线，确知除内衬层胶以外，其它各种胶料在一般胎温范围内（10℃～80℃）的生热率随温度变化不大；轮胎胶料的导热系数根据傅立叶定律的基本原理，采用稳态法在自行搭建的实验台上进行测试，结果表明，材料的导热系数在20℃～80℃的温度范围内随温度呈线性变化，论文给出了各种材料导热系数的线性变化的关系式λ=λ〓+bt及其λ〓和b的值；轮胎胶料的比热运用差式扫描量热原理，在NETZSCH DSC204型DSC实验仪上进行测试，结果表明，胶料的比热随温度的变化呈线性变化，其关系可用c=c〓+bT表示，文中给出了根据实验数据拟合的c〓、b的值；对轮胎表面的对流换热系数的测定，本文先将滚动的轮胎简化为有直线运动的旋转圆盘，而后采用萘升华热质比拟技术，在风洞中测量了滚动轮胎表面的对流换热系数，结果表明，圆盘表面对流换热系数与转速呈线性关系，即h=5.399+0.0258n，轮胎表面对流换热系数与其直线运动的速度呈线性关系，即h=

Systemic studies environment temperature how to influence construction control, finds out linear regularity and function formula of the arch rib, selects optimal closure time, then fully meets requirements of closure precision and linear. By testing a lot of data on temperature and strain and adopting least squares collocation, this dissertation deduces the strain calculate formula that is amended by joining temperature factor, then improves accuracy of stresses testing data.

系统地研究外界温度变化对施工监控的影响，找出了拱肋变化的线性规律和函数式，选择出最佳合龙时机，保证了拱肋的合龙精度和线形要求；测试了大量温度与应力对应关系的实验数据，采用最小二乘拟合推估法，推导出温度修正后的应变计算公式，从而提高了应力测试数据的准确性。

Both the interactions of haplotype vs. food (R0: P=0.038; rm: P=0.027) and that of haplotype vs. temperature (R0: P=0.006; rm: P=0.000) had obvious effect on growth reponses of the clonal groups. Moreover, there was significant interaction of haplotype vs. temperature (lorica length: P=0.033; lorica width: P=0.000) and haplotype vs. temperature (lorica length: P=0.027; lorica width: P=0.000) on body size of the clonal group.

生命表实验结果显示，单倍型与食物浓度的交互作用（R0：P=0.038；rm：P=0.027）以及单倍型与温度的交互作用（R0：P=0.006；rm：P=0.000）对种群增长均有显著影响，这4个单倍型克隆群对环境条件具有不同的偏好，并且各个克隆群对于环境变化有不同的生殖反应。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷