查询词典 temperature

Systemic studies environment temperature how to influence construction control, finds out linear regularity and function formula of the arch rib, selects optimal closure time, then fully meets requirements of closure precision and linear. By testing a lot of data on temperature and strain and adopting least squares collocation, this dissertation deduces the strain calculate formula that is amended by joining temperature factor, then improves accuracy of stresses testing data.

系统地研究外界温度变化对施工监控的影响，找出了拱肋变化的线性规律和函数式，选择出最佳合龙时机，保证了拱肋的合龙精度和线形要求；测试了大量温度与应力对应关系的实验数据，采用最小二乘拟合推估法，推导出温度修正后的应变计算公式，从而提高了应力测试数据的准确性。

Both the interactions of haplotype vs. food (R0: P=0.038; rm: P=0.027) and that of haplotype vs. temperature (R0: P=0.006; rm: P=0.000) had obvious effect on growth reponses of the clonal groups. Moreover, there was significant interaction of haplotype vs. temperature (lorica length: P=0.033; lorica width: P=0.000) and haplotype vs. temperature (lorica length: P=0.027; lorica width: P=0.000) on body size of the clonal group.

生命表实验结果显示，单倍型与食物浓度的交互作用（R0：P=0.038；rm：P=0.027）以及单倍型与温度的交互作用（R0：P=0.006；rm：P=0.000）对种群增长均有显著影响，这4个单倍型克隆群对环境条件具有不同的偏好，并且各个克隆群对于环境变化有不同的生殖反应。

The influence of the asphalt high temperature paving on temperature effect for the reinforced concrete box girder and the temperature difference distribution rule of the measuring points in box girder were investigated.

对沥青高温摊铺给钢筋混凝土箱梁造成的影响及其引起的截面温差分布规律进行了研究。

The impact of critical technology parameters which were cooking temperature?cheddar pH and stretching temperature on full fat Mozzarella cheese textural properties(TPA Hardness?TPA Cohesiveness?TPA Springness)and functional properties(Meltability?Free oil)was studied in this peaper by using currency three factors quadratic rotation design. It came to the conclusions that TPA Hard and Free Oil were increased properly with cooking temperature increased,the formation of free oil was increased with stretching t...

采用三因素二次通用旋转组合设计，研究热缩温度、堆酿pH、拉伸温度等关键工艺参数对全脂Mozzarella干酪的质构特性和功能特性的影响规律，结果表明提高热缩温度可增加干酪硬度及干酪的油脂析出性；提高拉伸温度也可增加干酪的油脂析出性；堆酿pH对干酪的弹性有较大影响，随着堆酿pH的降低，干酪的弹性增大，并与热烫拉伸温度之间有交互作用，即低的堆酿pH和高的拉伸温度时干酪的弹性大。

The detailed procedures of the method are as follows: the charging material of Ti-6Al-4V alloy is put into the crucible of an induction skull melter, heated and melted under the environment of high-purity argon and 400-700Pa pressure; pre-coated bars with the TiH2 of the weight accounting for 0.09 to 0.2 percent of the charging material are added in; when the hydrogen-contained titanium alloy in the crucible cools and the temperature drops below 300 DEG C, the charging material is vented off and cooled until the temperature equal to room temperature.

它的具体方法为：将Ti-6Al-4V合金的炉料装入感应凝壳熔炼炉的坩埚中，在压力为400～700Pa的高纯氩气环境中进行加热熔化；然后熔入含炉料质量0.09％～0.2％的TiH2的预制棒；当坩埚中含氢的钛合金逐渐冷却凝固并降温至300℃以下后，破真空，进一步冷却至室温。

The millivolt signal outputted by temperature transducer is sent to PLC through temperature transmitter; it can get every temperature value by computer data processing.

温度传感器输出的毫伏级信号经温度变送器输出给PLC的模拟模块，经由计算机运算得到各处的温度值。

The optimum reaction conditions were found finally. The results showed that the suitable conditions are under methanol solvent reaction temperature 40℃,the concentration of catalyzer TS-1 0.6%.,reaction time 60 minutes,propylene pressure 0.4Mpa under methanol solvent.Under Supercritical fluid system,the reaction temperature was 33.7℃(supercritical and near critical temperature),the reaction pressure was 7.58Mpa(near critical pressure and critical pressure range. propylene ), propylene pressure 0.65Mpa, reaction time 45min, cosolvent molality 4%.

而超临界体系下反(来源：4e56ABC论文网www.abclunwen.com)应温度适宜在近超临界和临界温度(33.7℃)以上，反应压力也是接近临界压力或者处于临界压力范围(7.58Mpa)，丙烯压力是0.65Mpa，反应时间45min，共溶剂甲醇摩尔浓度4%，在此反应条件下，反应的转化率98%，选择性96%，收率94%，与传统条件相比较，收率提高了20%左右。

From monomial mensurated results, we can see that the sequences of the low temperature stress tolerance of several lines are different, but the low temperature stress tolerance of some lines is steady, such as 24, 14 and etc, So we can account for the trend of the low temperature stress tolerance of lines.

在上述各单项指标测定结果间比较可以看出，部分品系耐低温能力在排序中位次有一定差异，但其中有一些品系的耐低温能力总体上还是比较稳定的（如24、14等），可以说明耐低温能力的趋势。

Based on the characteristic of temperature variation in plate rolling process, a monotone function of control temperature and finish temperature can be got.

温度对TMCP工艺影响很大，其中控温温度和终轧温度又相互影响，为此分析了中厚板轧制过程中温度的变化特点，将控温温度与终轧温度之间的关系转化成一个单调增函数，然后提出了相应的优化算法，以避免该单调增函数的不连续性，并利用二分法快速求出控温温度的具体值。

This article introduces the function, structure and principle of temperature measurement of digital temperature sensor and its application in multipoint temperature measurement system .

本文阐述了数字温度传感器DS18B20的功能、结构、测温原理以及在多点温度测试系统中的应用。

The production moved off-Broadway to New York City, where she won the Joseph E. Calloway award for her performance, and was profiled in American Theater Magazine as one of ten young theater artists to watch.

生产提出过百老汇的新的纽约市，在那里她赢得了约瑟夫calloway奖，她的表现，并于异型在美国的战区杂志之一， 10战区的青年艺术家观赏。

It's a risk tradeoff, and I believe that adding test support code usually wins.

这是一个风险的权衡，我相信添加测试代码通常会占上风。