查询词典 temperature

The high specific surface area of the powder can enhance the mechanical performance of the powder in room temperature and high temperature and improve the antienzyme low temperature aging performance of the powder.

由于该粉体具有高比表面性，可提高粉体的室温、高温力学性能和抗低温时效老化能力。

The results show that the liftoff height of the CH4/Air jet flame decreases with the increase of the coflow temperature, and the change of the liftoff height versus the coflow temperature presents the twostages behavior, and the stabilization of lifted flame is dominated by the autoignition of premixed homogeneous mixture in lower coflow temperature range. The phenomena of rapid multipoint autoignition were observed in the experiment of diesel fuel spray issuing into the CATA, and a special lifted flame appeared with a triple flame.

结果表明：甲烷气体燃料火焰起升高度随协流温度的升高而降低，呈现出两阶段变化特点，低温段发生了明显的自燃现象，其火焰稳定由均质混合气自燃所主导；柴油液雾燃烧试验观察到了快速的多点自燃现象，形成了独特的起升火焰，有三重火焰的特征。

Main products: almighty put in intelligent temperature control meter (XMT-808), can put through the computer and has the appearance, program intelligent industries adjustment meter, record meter, a series of temperature and humidity controller (XMT-9007), voltage adjustment instruments (ZK-1, ZK-3), all kings of temperature sensors, time relays, LCD and so on. Wide make use of the plastics, packing, printing, house electric appliance and some other machine field.Also include the textile printing, chemical engineering sprint, dyeing, baccy, oven, air conditioner, make cold and etc. Field. Has variety of products, all standards and directly sales to internal and international market.

主要产品有万能输入型智能温度控制仪表(XMT808)，具有计算机通讯接口及界面、可编程智能工业控制仪、记录仪，温湿度控制仪表(XMT9007)整套，电压调整器（ZK-1、ZK-3），各类温度传感器，时间继电器，液晶显示仪表等；产品品种多，规格全，真接销往国内及国际市场，广泛应用于塑料、包装、食品、印刷、家电等机械行业和轻纺、化工、印染、烟草、烘箱、空调、制冷等领域。

Based on deep understanding on the relation between the properties of biconical fibers and the fusion temperature, a problem of fusion temperature monitoring is solved by means of a ceramic microheater and a fiber pyrometer. Effects of the fusion temperature on optical properties of biconical fibers are studied quantitatively. Biconical fiber devices with various filtering spectra are fabricated. Experimental results agree well with theoretical predictions.

根据对双锥光纤成形及光学特性与加热温度的深入理解，采用陶瓷管辐射加热和光纤高温传感新技术，解决了长期以来熔锥温度不易监测的关键技术难点，定量研究了熔锥温度对双锥光纤光学特性的影响，研制出多种具有不同滤波谱形状的双锥光纤器件，实验与理论模型预测的结果一致。

Russia will be the first American astrophysicists GAMOW theory of general relativity into the universe, the hot big bang model of the universe : the universe began in high temperature, high density of the original material. The initial temperature of over several billion, as the temperature continues to drop, the universe began to expand.

美籍俄国天体物理学家伽莫夫第一次将广义相对论融入到宇宙理论中，提出了热大爆炸宇宙学模型：宇宙开始于高温、高密度的原始物质，最初的温度超过几十亿度，随着温度的继续下降，宇宙开始膨胀。

The highest concentration of bile salt they could tolerate were 0.40% and 0.30% respectively. When BdSA12 was cultivated at different temperature, the survival number was 10~5pfu/mL if temperature ranged from 28 ℃ to 39℃and decreased as the temperature increased beyond 39℃.

在不同温度下培养，28～39℃时，BdSA12的活菌数可达到10~5pfu/mL，然后随着温度的升高而下降，42℃不能生长；109J的活菌数在28℃最高，38℃以上不能生长。

When medical instrument draft condition becomes poor and the internal temperature rises reaching the controlled temperature of bimetallic strip temperature control unit, the normally closed stationary contact and normally closed moving contact disconnect to make main circuit power interruption and instrument stopping work, at the same time normally closed moving contact and normal open stationary contact switching-on, indicating light working, prompting the medical instrument being stopped because of superheating.

当医用仪器通风条件变差，内部温度上升，达到双金属片温控器的控制温度时，常闭静触点和常闭动触点断开，主电路供电中断，仪器停止工作，同时常闭动触点与常开静触点接通，指示灯工作，提示医用仪器因过热而停机。

Discover the 3Cr23Ni8Mn3MoN organizes of indoor temperature after passing by the heat temperature , the mechanics function of the heat temperature bottom and the anti-corrosion the function is better than the 4Crl4Nil4W2Mo and 5Cr21Mn9Ni4N.

研究发现3Cr23Ni8Mn3MoN钢经热处理处理后的显微组织、常温及高温下的力学性能和钢的抗燃气腐蚀性能均优于4Cr14Ni14W2Mo及5Cr21Mn9Ni4N钢，能较好地满足排气阀的性能要求。

Based on the simulation model theory of temperature and stress fields presented in this article, a large simulating program for high RCCD has been developed, which can numerically simulate all kinds of temperature control measures, including water pipe cooling, heat insulating in winter, reducing place temperature of concrete, spraying water brume, and long interval over-watering surfaces overflowing in flood season..

基于本文提出的温度场和徐变应力场仿真模型理论，编制了高碾压混凝土坝的三维有限元仿真计算程序，在程序中考虑了各种温控措施的数值模拟，包括：水管冷却、冬季保温、降低混凝土的浇筑温度、夏季混凝土表面喷水雾、施工汛期坝顶面过水等。

The main object of this research is to investigate synthesis of Cu23Cl Cu and CuO nanoparticles through electrospinning and heat-treated method The research is mainly focused on preparative parameter and the change of heat-treated temperature to form the nanoparticles inlaid in silicon fibers the shape and color change are dicussed First of all to prepare the Polyvinyl butyral and silica dioxide complex nanofiber by electrospinning and then to investigate different heat-treated temperature and reactive time to being an influence on the products The results detected by SEM XRD TEM EDS FTIR combined sol-gel process and electrospinning can prepare Polyvinyl butyral and silica complex nanofiber The experimental result is found when heat-treated temperature is 100~4750C it can produce Cu23Cl nanoparticles; Above 4750C~ 4900C it can produce Cu nanoparticles; Above 450~7000C it can produce CuO nanoparticles And the viscosity is lain between 20~40cp and the sol-gel process time is 3hr it can produce the thinner fibers The average diameter of the fibers are 107 88±21 01nm;Due to the nanoparticles inlaid in the silica fibers the thinner fibers can be inlaid the smaller nanoparticles so this is the result that the experiment is expected To calcine the complex fibers is to produce surface silica fibers contain Cu23Cl Cu and CuO nanoparticles due to surface plasma resonance it make the color of the fibers become yellowish green from light white green turn into the red nuclear finally As the experimental result to utilize sol-gel process combine electrospinning can produce porous silica fibers contain Cu23Cl Cu and CuO nanoparticles

本研究旨在探讨「利用放电纺丝和热处理法来合成Cu23Cl、Cu和CuO奈米粒」之研究，实验著重在制备参数与热处理温度变化对所形成的奈米粒镶嵌在二氧化矽纤维中的形态与颜色变化探讨。首先，利用放电纺丝法制备出聚乙烯醇缩丁醛及二氧化矽之奈米纤维，比较不同的热处理温度与反应时间的改变对产物生成产生影响，进而研究不同热处理温度和时间对生成奈米粒的影响。产物经由SEM、XRD、TEM、EDS和FTIR等仪器分析结果显示，结合溶胶-凝胶法(sol-gel process)和放电纺丝法可产生聚乙烯醇缩丁醛及二氧化矽复合奈米纤维。实验结果发现，若热处理温度在100~4750C下可得到Cu23Cl奈米粒，475~4900C 可得Cu奈米粒，450~7000C以上可得 CuO奈米粒。而黏度介於20~40cp间和溶胶-凝胶时间为3hr时，可产生直径比较细的纤维，纤维直径为107 88±21 01nm；且由於奈米金属颗粒镶嵌在二氧化矽纤维中，直径比较细的纤维，可以得到比较小的奈米金属颗粒，这与实验预期相符。而锻烧此复合物产生多孔的二氧化矽纤维并包含Cu23Cl、Cu和CuO奈米微粒时，由於表面电浆子共震关系，而使纤维颜色由淡白黄绿色变成黄绿色，再变红褐色。由实验结果得知，利用溶胶-凝胶法(sol-gel process)结合放电纺丝法和不同热处理温度，可产生Cu23Cl、Cu和CuO奈米粒镶嵌在二氧化矽纤维。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。