查询词典 temperature spot

There are other factors to influence the occurrence of trace elements. The higher gasification temperature, the higher the relative enrichments of As, Cd, Co, Cr, Cu, Mg, Ni, Pb, Se and the lower of Zn in the high temperature coke and the low temperature coke. The RRE of Mn, Hg, V, Sr are not affected by gasification temperature in the high temperature coke and the low temperature coke.

痕量元素在高、低温焦中受气化温度影响变化趋势相同，即随着气化温度的升高，As、Cd、Co、Cr、Cu、Mg、Ni、Pb、Se的相对富集系数增加，Zn的相对富集系数减小，Mn、Hg、V、Sr的相对富集系数变化很小。

On-line real-time monitoring for temperature overcome the difficulties of high temperature, high voltage and high magnetic field, to be a new method of checking up the Metal-clad switchgear. It can show the temperature of the spot of being monitored, judge the temperature and give an alarm. The system saves lots of resource and improves the veracity.

开关柜过热故障在线监测系统不仅克服了开关柜内高温、高压、强磁场环境下温度不易监测的难题，而且通过监控软件实时显示开关柜内测点的当前温度值，并做出报警处理，节省了大量人力、物力，提高了事故预判的准确性、实时性。

The system can acquire the signal of real-time temperature on spot by data acquisition card, then analyze and process the signal in software platform. PID neural network control algorithm was used for the real-time temperature control on spot.

该系统通过数据采集卡对现场的温度进行实时采集，并由软件开发平台进行信号的分析处理和显示，然后使用PID神经网络控制算法对现场温度进行实时控制。

The simulation was conducted by using steel 25 powder. Results show that great temperature gradients exist in the front of laser spot, and phase transformation temperature of powder around laser spot is higher than the powder's melting point.

以25号钢粉末为烧结材料进行了数值模拟，模拟结果表明：激光烧结过程中，在光斑中心的前端存在着极大的温度梯度；光斑中心的温度高于金属粉末的熔点，烧结过程中存在液相。

The result shows that the highest temperature is about 2.8×103℃ at the spot and the temperature declines gradually along the radius with the center of the spot.

模拟结果表明光斑中心处温度最高，为2.8×103℃，并以光斑为中心逐层降低，等温线近似椭圆形，椭圆中心位于光斑后方。

According to the relationship between temperature and the focal spot of lens antenna, the focal spot size of homemade millimeter wave dielectric lens antenna was measured by infrared temperature measurement technology. The experimental result, which was regard as the actual value, was achieved through analyses and calculations, and its designed value was corrected with it, then the exact radiation of millimeter wave was achieved.

摘 要：根据温度与透镜天线焦斑之间的对应关系，用红外热像测温方法对自行设计的毫米波介质透镜天线的焦斑进行了测量，经分析计算，得到了透镜天线焦斑的实测值，对透镜天线焦斑焦距的设计值进行了修正，实现了毫米波的定位定功率密度辐射。

In traditional design for a wire-tube type condenser, the air's temperature around it is considered to be the ambient temperature. In fact, the air's temperature is affected by the distance between the refrigerator's back and the wall and is heated by the compressor and condenser, so its temperature is not equal to the ambient temperature. In this case, the traditional design method is not accurate.

传统的设计冷凝器的方法，是把丝管式冷凝器周围空气的温度当作环境温度，而实际上，由于受压缩机散热、冷凝器加热、冰箱后壁和墙壁之间的间距的影响，冷凝器周围空气的温度并不等于环境温度，因而传统的设计方法并不精确，为了保证设计的精确性，有必要对冷凝器周围空气的温度进行研究。

Many influential factors of this method were analyzed. The experimental results indicated: the mole ratio of urea, sodium hypochiorite and sodium hydroxide was controlled within the range of (1.10~1.12):1:(2.30~2.42), the temperature of low temperature reaction must be controlled under 20℃, the high temperature should intensify fast to backset current temperature while reacting and the time for raising temperature only within 5min, and the yield of hydrazine hydrate can be reach about 75.1%.

实验分析了尿素法生产水合肼的各种影响因素，实验表明，尿素、次氯酸钠与氢氧化钠的摩尔比为(1.10~1.12)：1：(2.30~2.42)，低温反应温度控制在20℃以下，高温反应阶段快速升温至回流后反应5min左右时，水合肼收率可达75.1%左右。

The proposed method has the merit that the numerical characteristics of stochastic temperature field response can be obtained by analyzing the random temperature field just in one time.3. Perturbed numerical algorithm of nonprobabilistic convex set theoretical models on the temperature fieldThe uncertain parameters of physical parameters and initial boundary conditions of heat conduction are described by the convex model. The perturbation formulas of the upper and lower bounds of temperature field response with unknown-but-bounded parameters are given via the combination of matrix perturbation theory and the convex set theory model.4. Numerical analysis for transient temperature field with interval parametersConsidering the uncertainties of the transient heat transfer, the physical parameters and initial boundary conditions are regarded as interval variables.

该方法具有只进行一次随机温度场分析便可以获得其响应的数字特征的优点。3、温度场的非概率凸集合理论模型的摄动数值解法将结构导热的物理参数、温度场的初始和边界条件等不确定性参数以凸模型加以描述，基于矩阵摄动理论和处理不确定问题的凸集合理论模型的结合，导出有界不确定参数瞬态温度场响应所在集合的上、下界摄动计算公式。4、具有区间参数的瞬态温度场数值分析考虑结构瞬态热传导问题的不确定性，将结构各物理参数和温度的初、边值条件均视为区间变量。

Some parameters such as Indoor radiation heat transfer, convective heat transfer, MRT, OT, radiation heat transfer coefficient, convective heat transfer coefficient, and PMV-PPD were calculated under a steady condition. From the result, we can conclude, when operation under the combination system and worst-case test, if floor temperature is about 21℃, supply air temperature is 21℃, air velocity is 1m/s, the equlvalent coefficient of heat transfer between floor temperature and OT is 13.6w/m2k, where 5.68w/m2k is equlvalent coefficient of radiant heat transfer, 9.48w/m2k is convective heat transfer coefficient. And when air velocity is higher, supply air temperature is lower, the radiant heat transfer between floor and others is lower. In the whole experiment, the floor temperature was keeping above the indoor air dew point, and condensation was not appeared.

通过分析计算，在复合式系统运行中，最不利室外环境下，当地面温度维持在21℃左右，送风温度21℃，送风风速1m/s，此时地板对作用温度的当量综合换热系数为13.6w/m2k，其中当量辐射换热系数为5.68w/m2k，对流换热系数为9.48w/m2k，并且送风速度越高、送风温度越低，地板与其他壁面的辐射换热量有一定程度的降低，但总供冷量增加；在整个实验中地板温度始终高于地板上层空气的露点温度，并未发现有结露现象；室内空气温度梯度能满足0.1m-1.1m的温差小于3℃的要求，并且适当提高送风温度可以进一步提高人体的热舒适性。

So far, progress in more than three months of repurchase operations halted.

到目前为止，超过3个月的回购行动停止进展。

Now that petrol prices have fallen down to their pre-spike levels and is once again cheaper than diesel, it doesn't make economic sense for Ford to introduce a new diesel engine for the F-150 and thus plans for the oil-burning truck have been delayed.

现在，汽油价格下跌至前扣球水平和再次低于柴油，它不经济意义，福特推出了新的柴油发动机的F - 150 ，因此计划的燃油车已经被推迟。