查询词典 temperature curve

On the basis of study on hydrates phase equilibrium and the GHSZ affecting factors, the potential planar distribution of gas hydrates is determined by studying the temperature and pressure conditions in the sea bottom with different water depth, and the thickness of GHSZ is attained by solving the hydrates phase boundary curve equation and geothermal gradient curve equation.

在充分研究水合物相平衡和水合物稳定带影响因素基础上，通过建立水深和海底温度的关系，确定了不同气体成分和孔隙水盐度情况下，水合物稳定带在南海的分布范围，并根据水合物相平衡曲线方程和温度-深度方程计算了水合物稳定带的厚度。

Based on the computer graphics,a set of graphic processing software has been developed which can display distinctly the temperature distribution of any calculation time with continuous transitional colors,draw the solidification processing curve,draw cooling curve and print the technique card and so on.

本文借助计算机图形学，进行温度场的后处理显示，能对任意计算时刻的温度分布进行颜色过渡逼真显示，能进行凝固进程曲线的绘制，冷却曲线的绘制和打印铸造工艺卡等，为用户优化工艺设计提供良好的分析工具。

The text analysed the characteristic of the wet desulfurated flue gas on the base of the research of grand old man, educed the connection and protracted the curve between the temperature and humidity of wet flue gas in the condition of being saturated. The characteristic of the wet desulfurated flue gas is analysed thoroughly according to the curve.

本文在前人研究的基础上，分析了湿法烟气脱硫之后的湿烟气的特性，推导得出湿烟气温度与湿烟气饱和含湿量之间存在着一一对应的关系，并据此绘制了饱和状态下烟气含湿量与烟气温度之间的关系曲线。

As temperature rose,turbidity of protein solution increased by s-shape curve and climbed quickly at 48 ℃; Viscosity decreased by inverse s-shape curve and greatly declined at 46 ℃; Ca2+-ATPase activity decreased gradually with a slight increase from 36 to 42 ℃ and reduced to blank at 46 ℃; Total sulfhydryl group...

结果表明：随着温度的上升，浊度呈S型曲线增加，48℃时上升迅速；黏度呈反S型曲线下降，46℃时下降剧烈；Ca2+-ATPase活性下降，在36～42℃略有上升，46℃时完全失活；总巯基含量从40℃开始显著下降，60～70℃时下降显著。

The normal overload can be used frequently , its permissible value shall be determined according to the load curve of the transformer, the temperature of cooling medium and the load of the transformer before the overload takes place, etc.; The characteristic curve of overload of the transformer shall be supplied by the manufacturer.

正常过负荷可以经常使用，其允许值根据变压器的负荷曲线、冷却介质的温度以及过负荷前变压器所带的负荷等来确定；制造厂家提供变压器的过负荷特性曲线。

Based on the qualitative interpretation,the effect of transition segment of a stress-strain curve has been emphasized;phenomenon relating to strain rate effect have been adequately discussed,such as the stress-strain curve of a given strain rate, the increase of strain rate sensitivity of a metal with temperature,the decomposition of strain rate effect and strain hardening and multi-step loading tests.The analyses agree with the existing experimental results and update the knowledge on strain rate effect.

对材料应变率敏感性随温度变化的现象进行了分析，所得结论与现有试验结果相符；对晶体材料在恒应变率加载下的应力应变曲线进行了分析，明确提出了应力应变曲线中受应变率直接影响部分—过渡段的概念；结合位错运动分析，对恒应变率加载下晶体材料的应力应变曲线进行了解释，深化了对应变率效应的认识；提出了应变率效应与应变硬化效应可分别研究的观点，完善了对应变率效应细观机理的认识。

By synthetically analysizing the physical and chemical properties of all components and particle size, the content of F2641 in the JOB-iC is determined by gravimetric analysis after F2641 is seperated from HMX,TATB and PNP through ? alkali reflux. Determination conditions is set as follows the sample is boilingly refluxed for six hour in a constant temperature bath after adding lOOm! 8.0 ?? 0.1% NaOH. The solvent DMF saturated by TATB is used for extracting HMX,F21 and PNP from the sample and TATB is seperated by crucible filter G4. The mass precent of TATB is determined by extraction fractionation. The mass percent of PNP is measured by multiwavlength linear regression ultraviolet spectrophotometry. The testing conditions are set as follows:multiwavlength constitution: X=267nxn, 275nm, 283nm, 29mm, 299nm,the application scope of the Lambert-Beer law: the concentration of PNP is O.005?0.O25mgIml, the concentration of HMX is 0.060.3Omg/ml,absorption coefficents of PNP and HMX are solved by the slope of linear regression curve of absorbency- concentration of standard solution of PNP and HMIX for measuring wavelengthes,on the basis of the Lanibert-Beer law and absorbancy additivity principle, the slope of linear regression curve of A/E(1) and E1 of PNP and HMX solution is regarded as the concentration of PNP in the solution.

根据传爆药中各组分的物理、化学性质及主体炸药的粒度大小，进行综合分析，确定了采用碱回流重量法测定JOB-1C 中F_(2641)的含量，测定条件：加入100ml浓度为8.0±0.1％的氢氧化钠，在恒温水浴中煮沸回流6h；采用溶剂萃取法测定JOB-1C中TATB的含量，选择TATB饱和的二甲基甲酰胺为萃取溶剂，用G4坩埚式过虑器进行萃取分离；采用多波长线性回归紫外分光光度法测定JOB-1C中PNP的含量，通过实验确定了多波长组合：λ=267nm，275nm，283nm，291nm，299nm；朗波—比耳定律的适用范围为PNP浓度：0.005～0.025mg/ml，HMX浓度：0.06～0.30mg/ml；在测定波长下，对PNP、HMX标准溶液的吸光度—浓度进行线性回归，由回归曲线的斜率得出PNP、HMX的吸收系数；根据朗波—比耳定律和吸光度加和性原理，在测定波长下，对PNP、HMX 两组分混合溶液A_i/E_HMX(i与E_PNP(i/E_HMX(i进行线性回归，回归曲线的斜率即为混合溶液中PNP的浓度。

Meanwhile, the coated surface was hydrophobic with a contact angle of 107.2°since the introduction of methyl groups and methylene groups. Static immersing corrosion test, potentiodynamically polarization curve and electrochemical impedance spectroscopy were conducted to evaluate the film corrosion performances. The results of potentiodynamically polarization curve and EIS in 55wt% LiBr solutions at room temperature in atmospherical pressure indicated that the corrosion current density of BMBSE film coated surface was 4 orders of magnitude smaller than that of bare SUS304 steel, and the impedance was increased by a factor of 10000. Static immersing corrosion test presented that the BMBSE film can significantly increase the corrosion resistance in 55wt%LiBr solution at 180°C compared with stainless steels.

同时由于有机组分甲基和亚甲基的引入，结构均匀致密，并具有一定的疏水性；电化学测试结果表明BMBSE膜的极化阻抗比不锈钢大4个数量级，自腐蚀电流密度也下降低了4个数量级左右，具有良好的耐腐蚀性能；成膜的影响因素优化结果表明BMBSE、EtOH、D.I.water摩尔比为1∶4∶3，热处理温度为200℃时，更有利于制备结构均匀、致密、耐腐蚀性能好的薄膜；静态浸泡腐蚀实验结果说明，在180℃、55%的高温溴化锂溶液中BMBSE膜能起到良好的腐蚀防护作用。

Based on a lot of experiments, it shows the distinct error between classical theory curve which express the relation of cell diameter, cell density and foam tensile strength , tensibility tensile product and re-spring degree and experiment curve. It also can＇t explain the relation of hole degree , area of cell wall with above four mechanics parameter. But the sub-cluster scale theory was demonstrated successfully to explain the relation of cell structure and foam mechanics property on different mold temperature, mold pressure, mold period and different chemical blowing agent, blowing activator content.

通过大量的实验结果理论分析表明：以往的经典理论存在着很多不足之处，它不能有效地解释孔径、泡孔密度与抗拉强度、断裂伸长率、断裂功、及回弹率之间的理论曲线与实验曲线之间的偏差，也不能解释空隙度、泡孔壁厚与上面四者之间的关系，而群子标度理论则成功地论证了在不同模压温度、模压压力、模压时间及不同用量发泡剂、发泡促进剂条件下泡体力学性能与结构之间的相关性。

The independent Agents are adopted to complete the specific tasks from sensing temperature of axles to display curve of axle's temperature and to actions of effectors, so the knowledge distribution and control distribution is implemented in this system. It improves the real-time ability, reliability, maintenance and extendibility. It also realizes the intelligence of temperature's sense and control though the communication, coordination and cooperation among Agents.

该设计采用独立Agent完成了从轴温数据的采集、处理到执行机构产生控制动作再到人机界面的实时显示等一系列任务，实现了轴温监控的知识分布和控制分布，提高了系统的实时性、可靠性、可维护性和可扩展能力，并且通过多Agent间的相互通信、协调与合作实现了轴温监测和控制的智能化。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。