查询词典 temperature curve

In order to use electron beam in brazing of precise structures and thermo-sensitive materials,accommodating every kinds of curve brazing seams,a vacuum electron beam brazing temperature closed loop control system was developed using PID controller,electron beam scanning track editing and on-line adjusting technologies,real-time acquisition and handling of brazing temperature.

为了将电子束应用于精密构件及热敏感性材料钎焊，以适应复杂形状曲线钎焊缝的要求，采用电子束扫描轨迹编辑及在线调节、钎焊温度实时采集及PID控制器构建真空电子束钎焊温度闭环控制系统。

Base on internal energy, the model for average temperature was researched in this article. Through making a proper assumption, the polynomial curve model for temperature distribution and the linear model for specific heat distribution between two nodes were developed.

本文以内能为基础建立平均温度解析模型，通过合理假设建立钢板厚度方向上的多次曲线温度模型和节点间线性比热模型，从而获得任意时刻钢板厚度方向上的平均温度。

Producted RF and CRF aerogels by process of sol-gel technics, dynamic-exchange, CO2 supercritical drying, and procedural increase in temperature carbonization methods, which have eximious capability and nanometer network structure; Systemic analysis various factors which effect gel course, such as ratio of reactants and the dosage of catalyst, and probed into the better experiments conditions(the concentration of resorcinol and formaldehyde is more than 2% and the value of R/C is between 50 and 300); During gel course , primary investigated the viscosity curve and particle size distribution of sol-solution, and analyzed the reason of catalyst dosage effects particle size of gel, and confirmed that the up-growth of gel follows the theory of " polymerize increase ".The experiment results indicated that ultrasonic with unvarying temperature disposal shortened gel time and optimized quality of gels, and the factors of ultrasonic effect gel reaction velocity were analyzed; Prepared organic aerogels using compounds of resorcin and hydroquinone substitute resorcinol reacts with formaldehyde the first time, and also optimized the proportion of resorcinol and hydroquinone (the proportion of hydroquinone in 10%～40%).

采用溶胶-凝胶工艺结合动态溶剂交换、CO2超临界流体干燥与程序升温碳化方法制备出性能优良、具有纳米网络结构的RF与CRF气凝胶；深入研究了反应物配比催化剂用量等条件对凝胶过程的影响，得到了较佳的RF凝胶制备条件(RF浓度应大于2%，R/C值取50～300)；初步研究了凝胶过程中的粘度、粒径变化情况，分析了催化剂用量影响凝胶中粒子尺度的原因，在实验上印证了凝胶生长遵循"聚增长"的理论；通过引入超声波改进了RF气凝胶的制备工艺，缩短了凝胶反应时间，提高了凝胶品质，并探讨了超声波促进RF凝胶反应作用的原因；首次用对苯二酚与间苯二酚复配制备了混合有机气凝胶，优化出复配比(对苯二酚含量为10%～40%)。2。

He TGA curve shows that thermal decomposition temperature of 9518 resin is 260℃, EW220/9518 and SW220/95l8 composites have high mechanical properties at room temperature Compared the mechanical properties of EW220/9518 composites, its retentivity is more than 86% at 150℃.

GA曲线表明9518树脂的起始分解温度为260℃，EW220/9518和SW220/9518复合材料的力学性能良好，150℃下EW220/9518复合材料的力学性能保持率＞86%。

Daily thermal effectiveness was expressed as a sine curve integrating daily temperature effect and temperature sensitivity in relation to wheat development.

每日热效应是指受每日温度和品种温度敏感性影响的生育促进因子，其中温度效应用正弦函数来表达，而曲线的陡度用温度敏感性来调节。

The result shows the temperature of separation point gets lower and lower as the smolder reaction propagates. And the rules of curve slope of separation temperature of the different heat fluxes in steady reaction zone are quite similar.

结果表明：沿着反应进行的方向，分离点的温度越来越低，不同热流条件下的温度分离曲线斜率在实验稳定发展段的变化规律表现得很相似。

The temperature field of the floor and the space and the curve of vertical temperature are obtained, and the relevant analysis for them is done.

使用Airpak2.1软件，选用DO辐射模型，k-ε模型，对某高大空间的辐射采暖系统的应用效果进行模拟研究。

Finally, the curve of between temperature and thermal conductivity at low temperature has been obtained.

根据试验，讨论了低温热导率的影响因素如温度、密度、吸水率等。

Based on an experimental apparatus for paraffin thermal expansion characteristics with water,the influences of cooling means and spring pressure on thermal hysteresis phenomenon in relationship curve of displacement vs.temperature during increasing and decreasing temperature cycles of paraffin have been investigated by experiments.

在水浴加热石蜡热膨胀性能试验装置的基础上，通过实验研究了不同冷却方式、弹簧压力和不同温度测量点下石蜡升温和降温过程中位移-温度关系曲线的"热滞后"的现象，分析了"热滞后"的实际原因。

Our plant develops usualness inter-access technology communication with more than ten international famous electric furnace manufacturing companys,and repeated visits to the foreign advanced electric furnace factories and institutes every year, learning and absorbing foreign advanced industrial furnace manufacturing technology and production processes, technology, special components of electric furnace improving technology, product upgrading technology, it makes our plant keep synchronization with the international advanced industrial furnace manufacturing technology no whether in the type,the updating of furnace, fundation material progress, components manufacturing technology progess , manufacturing automation, and the way the loading of the loading basket manufacturing technology, WDS lining energy saving techniques, ceramic fiber wave of high pressure tied ceiling stack technology, oxidation-free protection atmosphere, carburizing, nitriding, molten, salt bath, nitrate Austempered, precision heat treatment process, equational flow and temperature heat transfer asymmetric quenching tank manufacturing technology, microcomputer program heat treatment technology curve temperature control process , and so on can keep pace with internationa advanced industrial electric furance manfacturing technology.

我厂与国际十多家著名电炉制造公司开展经常性互访技术交流，每年多次前往国外先进电炉制造厂和研究所，学习并吸收国外先进的工业电炉制造技术和生产过程，工艺技术，电炉专用零部件改进技术，产品更新换代技术，使我厂工业电炉产品无论在品种类型，炉种更新，基础材料进步，零部件制造技术进步，制造工艺自动化，装料方式和装料筐制造技术方式，WDS炉衬节能技术，陶瓷纤维波浪叠法高压捆扎吊顶技术，无氧化保护气氛，渗碳，氮化，盐浴，硝盐等温淬火，精密热处理工艺，均流均温换热不对称淬火油槽制造技术，微电脑程序热处理工艺曲线控温等各个方面，能够与国际上先进工业电炉制造技术保持同步。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。