查询词典 temperature conductivity

Aiming at some defects existing in PMN ferroelectric ceramics, such as excessive sintering temperature and lower curie temperature, this paper gives an introduction to various kinds of dopings, such as rare earth, alkaline earth and transition metal, which have effects on dielectric properties, sintering temperature and microstructure of PMN-typed ferroelectric ceramics.

针对PMN铁电陶瓷存在烧结温度过高、居里温度较低等缺陷问题，分别介绍了稀土、碱土、过渡金属等掺杂对PMN铁电陶瓷介电性能、烧结温度及微观结构等的影响。

Consideration of microstructure, the metal material has a face-centered cubic lattice of the austenitic steel, Reducing Valves copper and aluminum do not appear in the low temperature low temperature brittleness, but the hardness of aluminum and aluminum alloys is not high, the sealing surface of the wear-resistant aluminum , anti-scratch performance is poor, so the use of low-temperature valves have certain limitations, only used in low voltage and small-caliber valve.

从金相考虑，金属材料中具有面心立方晶格的奥氏体钢、铜和铝在低温状态下不会出现低温脆性，但因铝及铝合金的硬度不高，铝密封面的耐磨、耐擦伤性能差，所以在低温阀门中的使用有一定的限制，仅用于低压和小口径阀门中。

Synthesized all above, the heat and mass transfer of charge bed is discussed in detail. After choosing seriously the former study results in this field, a whole temperature range process model for firing iron ore pellets containing solid fuel is established as well as its software is edited. The main physical chemistry reaction process within pellets and the heat statement can be calculated exactly with the process as long as the physical and chemical parameters of raw material are obtained through basic experiments. After finding out the reason of"temperature hysteresis"and"heat inertia"of the experimental induration device, a new kind of experimental induration device is designed. The"temperature hysteresis"of hot gas flow in the new device is avoided.

综合以上对焙烧球团矿时球团矿内各种物理化学反应过程的分析与研究的结果，仔细地分析研究了球团矿料层中的传热质现象，认真筛选了前人对填充床的传热传质的研究结果，提出了全温度范围球团矿焙烧过程模型，并编制了相应的计算机软件，只要通过基础实验，获得原燃料的基本物性参数（如化学反应速度常数，矿粉、煤粉的粒度及此表面积以及球团矿的导热性等），利用这一软件就能准确地计算出焙烧球团矿时球团矿内各种物理化学反应过程和料层内的热工状态。

Accordingly, the improvement of those apparatus and the application of the techniques such as low temperature pit entry fermentation, fixed-temperature distillation, maintenance of adequate condensation temperature, and periodic washing of distillator and condenser etc. could effectively prevent lead content above standards.

改进蒸馏器、冷凝器、导管和贮酒容器等生产设备，采取低温入池发酵、定温蒸馏、保持适宜冷凝温度，定期刷洗蒸馏器、冷却器等方法可有效预防铅含量超标。

Product variety: There are high-temperature laser Glitter, Glitter temperature color, colorful flash chip series high temperature resistant products.

产品多样：有高温镭射金葱粉，高温彩色金葱粉，七彩闪光片等系列耐高温产品。

The relationship between the apparent viscosity and temperature can be expressed by Arrhenius Equation. But there is a flex point during heating, and the viscous flow activation energy at the low temperature is greater than that at the high temperature.

液化残渣的黏度－温度关系符合Arrhenius关系式，但在升温过程中出现了拐点，低温段的黏流活化能比高温段的要大。

The temperature curve of flue gas was fitted by the least square methods during the sintering process, and then 4 flexions of the temperature curve were calculated by solving a two-order derivative of the temperature curve.

提出利用最小二乘法拟合烧结废气温度曲线，求曲线方程的二阶导数计算出烧结废气温度的四个拐点。

The isothermal anneal at an elevated temperature of 1150℃ ramped up from a starting temperature （600-1000℃） was employed to enable the growth of the grown-in oxygen precipitates that are larger than the critical size at the starting temperature. Flourier transformation infrared spectroscopy and scanning infrared microscopy are used to measure the amount of precipitated oxygen and the oxygen precipitate density in a 300mm nitrogen-doped Czochralski silicon wafer, respectively.

文章摘要：采取从某一温度（600-1000℃）开始缓慢升温至高温（1150℃）并保温若干时间的方法，使得直拉si片中大于起始温度对应的氧沉淀临界尺寸的那一部分原生氧沉淀得以长大，然后通过傅里叶红外光谱测量氧浓度变化以及利用扫描红外显微术测量氧沉淀密度。

Furthermore,the influences of hot working parameters,such as friction factor,the top die speed and initial die temperature,on the temperature distribution had been investigated,and the temperature distribution in different deformation zones was analyzed.

同时由于坯料与模具和环境之间存在着温度差，以及坯料和模具接触面上的摩擦功不断转化为热量，使得坯料在变形的同时，将以各种形式和模具及周围环境进行热交换，增加了坯料内部温度场分布的不均匀性。

The temperature response and sensitivity enhancing technology concerning fiber Bragg gratingis analyzed.A special kind of heat-resistant polymer is used to coat FBG to enhance the temperature sensitivity of FBG sensor.The polymer coating and solidifying process of FBG is improved.A kind of heat-conducted adhesive is used to reduce the friction between tube and polymer,and eliminate the chirp effect of FBG caused by the asymmetric shrinkage of polymer during the package process.The experimental results show that the FBG sensor can measure temperature from 20℃to 180℃.

简要分析了光纤布拉格光栅的温度响应及增敏原理，采用特殊耐高温有机聚合物对光纤光栅进行温度增敏封装，并通过改进光纤光栅的聚合物封装固化工艺，使用某种有机硅导热胶减小有机聚合物与套管材料的粘合度，消除了封装过程中由于聚合物材料不均匀收缩引起的光纤光栅反射谱啁啾化，实现20~180℃范围内光纤光栅传感器对温度高灵敏度测量。

Diabetes is a social disease that affects several million people worldwide.

糖尿病是一个社会性疾病，全世界有数百万人罹患此病。

I'll call you on Friday to see if we can reschedule our luncheon meeting at your convenience.

我星期五会给您打电话在您方便的时候我们重新安排我们的午餐约会。