英语人>网络例句>temperature conductivity 相关的网络例句
temperature conductivity相关的网络例句

查询词典 temperature conductivity

与 temperature conductivity 相关的网络例句 [注:此内容来源于网络,仅供参考]

It is also found that the temperatures at which the CO2 density, thermal conductivity and viscosity possesses the maximum change are very closer to the pseudocritical temperature.

CO2的密度、导热系数以及粘度变化最大时的温度与准临界温度相当接近。

The most important parameters involved in the design of the hot gas wall on a regeneratively cooled chamber are the thermal conductivity of the material, the strength of the material at elevated temperatures, the material maximum operating temperature and the coolant passage dimensions.

最重要的参数,参与设计的热气体墙就一再生冷却商会是热导率材料,材料的强度在高温下,材料的最高操作温度和冷却剂通过层面。

The results show that the electrical conductivity and the seebeck coefficient of PAn are strongly dependent on the preparation conditions and temperature.

结果表明,聚苯胺的电导率和塞贝克系数强烈依赖于制备条件和温度。

The electrical resistivity,Seebeck coefficient and thermal conductivity of PbTe doped with Bi2Te3 were studied at room temperature.

目前人们正在研究以PbTe为材料,制造利用工业上的废气和汽车废热发电的装置[2]。

The electrical resistivity, Seebeck coefficient and thermal conductivity of PbTe doped with Bi2Te3 were studied at room temperature.

利用高温高压技术,在3GPa、1200K的条件下,对PbTe进行了Bi2Te3的掺杂,并在室温下对其进行了电阻率、赛贝克系数、热导率的测试。

Relationship between Microstructure and Thermoelectric Properties in the Skutterudite Compounds Abstract Filled skutterudite compounds are a family of high performance thermoelectric materials whose ZT (figure of merit, where T is temperature and Z is a function of the Seebeck coefficient, electrical resistivity, and thermal conductivity) values as high as 1.0 at round 973 K.

方钴矿化合物中微观组织结构和热电性能的关系稀土填充的skutterudite化合物具有优良的热电性能,在室温到773K范围内,其热电优值高于1,是目前已发现的具有最高热电性能的材料之一,有望在废热发电及制冷等热-电转换场合得到实际应用。

Are used to study the structure, crystallograph quality, surface structure, conductivity and chemical status of grown films. The minimum full width at half maximum of XRD rocking curve of CdTe, ZnSe and ZnTe epilayers are 630, 133, 110 arcsec respectively. Compared to MBE and MOVPE, ICB allows the epitaxy at lower temperature onto various substrates with higher deposition rates.

实验在GaAs等衬底上分别生长了CdTe、ZnTe、ZnTe单晶薄膜,其X光摆动曲线半高宽分别达到了630、133和110弧秒,与MBE、MOVPE相比,ICB技术外延时,大幅度地降低了生长温度,提高了生长速率,在实际应用方面具有特别重要的意义。

With some Chinese traditional medicine pharmacy business uses the oiliness water put oneself in another's position that place of vapor distill craft amasses to be experimental system, determine around of the membrane separation below different temperature the index such as the PH value of each medicine fluid, electrical conductivity, salinity, turbidity, viscosity.

以某中药制药企业采用水蒸气蒸馏工艺所收集的含油水体为实验体系,测定不同温度下膜分离前后各药液的pH值、电导率、盐度、浊度、粘度等指标。

Results demonstrate that the electrical conductivity is promoted companied with the increasing of heat treatment temperature.

研究结果表明,随热处理温度的提高,导电性能提高,尤其在400—800℃热处理阶段,导电性能提高迅速。1000℃以上热处理后的粘接样品具有良好的导电性能,继续提高热处理温度,导电性能的提高程度降低。

The compound solution performs as pseudo-fictile fluid, and its visual viscosity is reduced when the shearing velocity increases. The higher the cationic degree of CPAM, the more apparent the rarefying behavior of the polymer-surfactant complex, but it still is pseudo-fictile fluid. In addition, such factors as the molecular weight of CPAM, temperature and PH value etc, have different effect on the properties of the mixed solution, including its visual viscosity, conductivity, rheological behavior and so on.

CPAM/SDS复合体系的表观粘度随剪切速率的增大而下降,即具有剪切变稀行为的特性,表现为拟塑性流体:CPAM的阳离子度越高,它与SDS形成复合体系剪切变稀的行为越明显,但体系的流动类型不发生变化,仍为拟塑性;随着CPAM分子量的提高,复合体系的非牛顿性增强;温度的升高将导致复合体系的粘度显著降低,非牛顿性减弱;对于SDS用量低于等电荷当量的复合体系,pH值的变化对其流变性的影响不显著。

第16/20页 首页 < ... 12 13 14 15 16 17 18 19 20 > 尾页
推荐网络例句

However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.

然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。

A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.

付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。