查询词典 teeth-grinding

The areas of root concavity in most of teeth will cover the cervical third and middle third of the root.

大部份的牙齿其牙根面凹陷的范团均涵盖了齿颈部及中央三分之一的牙根。

Pharmacologicasl: the dog's teeth are concavo-convex srrangement.

狗牙：狗的牙齿是凹凸交错的。

A concretion of mineral salts and organic matter deposited on the surface of the teeth.

在各种潮湿的或腐烂的有机物质表面生长的菌类。

Methods: 60 patients with isolated anterior teeth used zinc oxide paste and iodoform gutta-percha point for lateral condensation, then the experimental group had the root canal filling pressure into FRC pile nail, the control group would no longer be dealing with, two groups had apical dye leakage test.

选60例离体前牙，采用碘仿氧化锌糊剂及牙胶尖做侧压充填，然后实验组在已充填的根管内加压插入FRC桩，对照组不再做处理，对两组做根尖染色渗漏试验。

It is determined that the pitch cone of honing wheel depends on the number of teeth in the honing wheel and the angle between the common normal of pitch cones and the plane parallel to both gear and honing wheel axes.

论文摘要：分析了基于交错轴传动的珩齿原理，导出珩磨轮与被珩齿轮在啮合点处的相对滑动速度的数学模型，根据该数学模型可以判定，珩磨轮的节锥面由珩磨轮齿数以及公法线和与珩磨轮及被珩磨齿轮的轴线平行的平面的夹角两个参数所确定。

Analyzing the honing principle of spiral bevel gears based on crossing-axis transmission, the mathematical model of the relative sliding speed of the contact point between honing wheel and gear is achieved. It is determined that the pitch cone of honing wheel depends on the number of teeth in the honing wheel and the angle between the common normal of pitch cones and the plane parallel to both gear and honing wheel axes.

分析了基于交错轴传动的珩齿原理，导出珩磨轮与被珩齿轮在啮合点处的相对滑动速度的数学模型，根据该数学模型可以判定珩磨轮的节锥面是由珩磨轮齿数、公法线和与珩磨轮轴线平行的平面夹角所确定。

My mouth is full of sharp, cone-shaped teeth.

我的口中满是尖尖的锥形牙齿。

After finish congee, clean his teeth with cooked water then give him some water to drink.

在食完 粥以后，用已煮熟的水清洗他的牙然后给他饮一些水。

The ideal rock sample is the conical surface rock sample that can joint crest of teeth in single row drilling experiment.

在单齿圈破岩试验中，理想的岩样是与牙齿齿顶线相贴合的锥面岩样。

This dissertation first puts forward the model of driving force transformation which the contact region of stator and rotor is divided into three relative sliding areas such as braking—driving—braking by means of research on vibration characteristics of USM stator surface points and micro driving course to rotor, this model can explain variation regularity of USM load characteristics, moreover, simplified calculation formula of rotor driving force concerned with stator teeth is set up.

本文通过对行波超声马达定子表面各点的振动特性和定子对转子微观驱动过程的研究，首次提出将定子和转子接触区划分为制动区—驱动区—制动区三个相对滑动区的驱动力转换模型，这一模型能够解释超声马达负载特性变化规律，并建立了计及定子齿的转子驱动力计算简化公式，该式能应用于多于两个定子齿驱动的转子驱动力计算。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。