查询词典 te-hee

Materials and Methods:236 pathology-confirmed breast lesions(155 malignanty,81 benignancy) and 221 disease-free contralateral breast tissues were examined using EPI-DWIb values=0,1000 s/mm~2TR/TE=8400ms/93.8ms; FOV=30×30cm;matrix=128×128;ASSET=2,slice thickness=4mm.DCE-MR imaging was also performed for accurate location of the lesion using VIBRANT sequence.The mean ADC values of malignant and benign lesions and the disease-flee contralateral breast tissues were calculated from the ADC map for each patient.One-way analysis of variance was applied to compare the mean ADCs of malignant lesions with benign lesions and disease-flee contralateral breast tissues.The threshold ADC value for malignant lesion was determined using a receiver operating characteristic(ROC curve analysis.Each lesion was classified into two major types:mass and non-mass lesion.The diagnostic performance of DWI was compared in breast mass and non-mass lesions.Results:155 malignant and 81 benign lesions were confirmed in 236 lesions.

材料与方法：搜集术前行乳腺MR检查并经穿刺或手术病理证实的236例乳腺病变，以对侧正常乳腺腺体作为正常对照，采用横轴位的平面回波-扩散加权成像序列，TR=8400ms，TE=93.8ms，层厚=4mm，激励次数=2：视野=30×30cm，矩阵=128×128，ASSET=2，b值=0和1000s/mm~2；参考动态增强图像准确定位，测量病变区和对侧正常乳腺腺体的ADC值，应用t检验比较良、恶性病变及正常腺体ADC值的差异，采用接收者工作特征曲线(receiver operating characteristic curve，ROC)确定良恶性病变的ADC界值；根据BI-RADS MRI将乳腺病变按照形态学表现分为肿块性病变和非肿块性病变两组，比较ADC值在肿块和非肿块性病变中定性诊断的效能。

In this paper, the model of cylindrical coordination system for Hg〓Cd〓Te crystal growth with Bridgman method in magnetic field has been established.

本文完成了圆柱坐标系下磁场中Bridgman法生长Hg〓Cd〓Te晶体多场量数值模拟的模型建立工作。

The gene of ESAT-6 from genome of bovine mycobacterium tuberculosis strain that from cervine tuberculosis was amplified by polymerase chain reaction and inserted into pGEM-TE vector. After sequencing, we analyzed the gene encoding ESAT-6 protein with molecular biologic software.

从患结核病鹿的肺组织中粗分离牛分支杆菌制备DNA模板，用PCR对牛分支杆菌ESAT-6基因进行了扩增，将扩增的产物连接于测序载体pGEM-TE上克隆，经测序确定无误；并使用分子生物学软件对ESAT-6基因进行了分析。

Two-dimensional finite difference time domain simulation results show that, in a wide angle range (about 20 degrees), in a normalized circular frequency range of , the transmission intensity can reach over 98% for both TE and TM polarization.

二维有限时域差分模拟结果显示，在较宽的角度范围内（约20度），约化圆频率处在范围内，分束器对TE和TM偏振光的透射强度都能达到95%以上。

We transformed eccentric coaxial line cross-section into rectangular area by hyperbolic cotangent transformation, transformed the FDTD difference expressions into CM-FDTD difference formula, calculated the cutoff wavenumbers of higher order TE and TM modes in eccentric coaxial line.

本文用双曲余切变换将偏心同轴线截面变换为矩形区域，相应地将FDTD差分格式变换为保角变换FDTD差分格式，计算了偏心同轴线TE、TM高阶模的截止波长。

With the increment of the Se mol ratio in the systems, the volume of unit cell is reduced , the energy of the system is increased, and the covalence bond component of Te(1)-Bi,Se(2)-Bi,Se(1)-Bi is gradually enhanced.

随着体系中Se原子摩尔比的增加，晶胞的体积减小，体系的能量增加，Te(1)-Bi键、Se(2)-Bi键、Se(1)-Bi键的共价键成份逐渐增强。

A numerical simulation by program computation was presented to study electron cyclotron resonance master of TE's mode,which was applied particle-in-cell method and a electromagnetic mode based on theoretical analysis.

采用等离子体粒子模拟的方法，在理论研究基础上应用电磁模型，编写了TE模式的电子回旋脉塞等离子体粒子模拟程序并进行了数值模拟。

The power-dependent complex dispersion relations for TE and TM waves in a lossy nonlinear guiding system with a wide range of absorption coefficients are simulated and analyzed.

模拟和分析了很宽吸收系数范围内非线性有损耗波导系统TE和TM波与功率有关的色散关系。

It is shown that the complex dispersion relations, for both TE and TM waves, are strongly power dependent and most importantly, the bistability phenomena will no longer exist if the absorptive loss is high enough.

表明TE和TM波的色散关系都与功率密切相关，尤其重要的是，如果吸收损耗足够大，双稳现象就不再存在。

The results showed that,two reaction mechanisms of enzyme-catalyzed reaction and thermal-hydrolyzed reaction were involved in the S-TE process,which began with depolymerization of sludge flocs by exoenzyme s including proteases and amylases,followed by cell-walls and organic matters disintegration and hydrolyz.

结果表明，S-TE污泥溶解存在2种反应和2个过程：嗜热菌胞外酶首先解聚污泥胶团，进而溶解细菌的细胞壁，水解胞内有机物质。

This paper discusses design and realizable methods of remote test output interface from logical design angle.

本文从逻辑设计的角度讨论遥测输出接口的设计及实现方法。

This also 星体投射plies to buildings, structures and geological features.

这也适用于建筑物和地质特征。