查询词典 tangent

Setting out the main way to coordinate, polar coordinate method, angle of law, such as tangent offset method.

放样的方法主要要坐标法、极坐标法、偏角法、切线支距法等。

The difficulties during developing this technique is that dielectric loss tangent measured is very small, and many factors influence the high-precision measuring, such as the excursion of the primary wave on power line, the existence of the harmonious wave, and the electromagnetic interference in the field and so on.

该检测技术的难点在于待测介质损耗角很小，电网基波频率不稳、高次谐波的存在以及现场电磁干扰等因素都会影响测量准确度的提高。

In chapter 4, some vector mathematical definitions are first given to position tolerance zones; second, the principle of variation geometry is introduced, and the mathematical foundation of automatic generation of a approximate linear equation of tolerance design function by variation geometry is first proven; tangent method and two-point slope method based variation geometry are main studied.

第四章首先对一些位置公差带给出了矢量化的数学定义；然后介绍了变动几何的原理，首次论证了变动几何能产生近似线性公差设计函数的数学依据，并着重研究了基于变动几何的切线法和二点斜率法。

The computational methods of line element conic curve s tangent point decided by any line on projective plane is presented on the basis of this study.

从实际计算的角度出发，使用N矢量表示视平面上的点和直线，并由线素二次曲线的射影定义推导出线素二次曲线的N矢量方程；在此基础上，给出了射影平面上任意一条直线所确定的线素二次曲线切点的N矢量的计算方法。

To the tangent distance minimization method,it's quadratic convergence for zero residual problems may not convergence at all.

对于切线距离最小方法，它是接近二次相交零余留的问题，也有可能没有相交。

Consistent tangent modulus matrices with consideration of the fully coupled effects are derived to preserve the quadratic rate of convergence of the global Newton iterative procedure.

损伤耦合分析的一致性切线模量矩阵。

Returns the tangent of a radian angle x .

返回 x 的正切值。

Put forword the determine a method on the direction of the tangent and the radius of the curvature.

指出了在自然坐标系中应用动力学方程解题的问题所在，提出了自然坐标系中切向及曲率半径的确定方法，并通过例题，说明理论的应用。

First, a smooth curve is obtained from the data by curve fitting with the method of non-linear least squares fit. Then the tangent vector and the radius of curvature of each point on the curve can be calculated for the error evaluation. With the fitted curve, the focusing state of the aspheric lens can be obtained by the method of ray tracing.

主要过程为首先采用非线性最小二乘拟合的方法进行曲线拟合，并计算出曲线上各点的切矢量和曲率半径，分析它们的误差，最后对拟合后的曲线用光线追迹的方法得到非球面镜的聚焦情况。

The methods above are used in practical data-processing. The errors of the tangent vector, the radius of curvature and the focusing are obtained through curve fitting and ray tracing. Finally, the charts are ploted by the matlab emulation.

将以上方法用于实际数据的处理中，对一组透镜表面数据进行拟合、分析，最终得出透镜的表面形状误差、各点的切矢、曲率半径误差以及光线的聚焦误差，并用matlab仿真出曲线图。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷