查询词典 surface

This article mainly introduced the theory,the classification of COONS surfuce and the analysis of the surface ,in view of each type of COONS surface's insufficiency, KongSi etc took the improvement of its methods and in accordance with the different requirements of continuity of surface, COONS surface will be divided into three Categories.

本文主要介绍了COONS曲面的理论、分类及曲面分析，针对每类COONS曲面的不足，孔斯等人采取一定的方法对其进行改进，并按照曲面连续性的不同要求，将COONS曲面分为了三大类。

The results show that the surface layer of the air-exposed ZrVFe getter is covered with H20, CO2 and hydrocarbons, both Zr and V exist in the oxidized state, and vanadium oxide starts to reduce at 200℃. The activation results in the enrichment of Zr on the getter surface and the formation of the metallic carbides. H2O, CO2 and hydrocarbons sequentially desorb from the surface with the increase of temperature. H2 is the main gas which desorbs above 200℃ and O2 is not discovered. ZrO2 is reduced to near-metallic or metallic state because O in ZrO2 leaves the getter surface through diffusing into getter bulk.

结果表明：暴露于过大气的吸气剂表面覆盖着H2O、CO2及碳氢化合物等，Zr和V主要以氧化态存在；在吸气剂加热激活过程中，V的氧化物在200℃开始还原；激活过程导致表面近金属态Zr的富集以及部分金属碳化物的生成；随着温度的升高，H2O、CO2及碳氢化合物逐渐从吸气剂表面脱附，在200℃以上，主要脱附气体为H2，整个激活过程未发现O2；ZrO2还原为近金属态或金属态，主要是由于ZrO2中的O通过向吸气剂内部扩散而离开吸气剂表面所致。

For example: Corrosion polishing false enamel surface, beer Shuimo convex surface, corrosion Diwen fine print face, flat enamel surface, stickers foot without nails surface.

腐蚀抛光假搪瓷面、啤凸水磨面、腐蚀底纹精细印刷面、平面搪瓷面，贴无脚钉表面等。

The plant ventilation status under different conditions is calculated with steady k-ε turbulence model. Results show that different surface has a different impact on natural ventilation. The ground surface constructed with some good heat-absorbing materials will have an enhanced surface effect. The surface effect is fully put into effect at the maximum outdoor windspeed of 1.5m/s.

在稳态条件下，采用k-ε湍流模型，计算了不同工况下的厂房通风状况，结果表明，不同的地表对自然通风的影响是不同的，厂房内的地面采用吸热性能好的材料构筑，会增强地表效应；地表效应得以充分体现的最大室外风速为1.5m/s。

2 C节,原文为: The coupons shall be removed so that the specimens shall have their longitudinal axes at a distance below the nearest heat treated surface equivalent at least to the greatest distance that the indicated high tensile stress surface will be from the nearest surface during heat treatment and with the mid-length of the specimen at a minimum of twice this distance from the second heat treated surface.

建议译为：试件的切取应使试样的纵轴在最近的热处理表面以下，其距离至少等于从表明的高拉伸应力面到热处理时最近表面的最大距离，且试样的一半长度应位于离第二热处理表面这一距离（指从表明的高拉伸应力面到热处理时最近第二表面的最大距离—译注的至少二倍。

The rules of fluid rate with different technical parameters: the increase of electromagnetic force causes the increases of the fluid rates at S/L interface and free surface, the decrease of skin depth, the increase of electric current density which will make the fluid at free surface flowing faster, while it doesnt affect the fluid rate at S/L interface. When the height of melt increases, the both of fluid rates will increase too. The increase of the width-thickness ratio augments the fluid rates along the wider edges at S/L interface evidently, while the rates along the narrow edges will have little change, and the rate at free surface has little change too. The increase of overheat degree minishes the range of mush zone, while the fluid rates at S/L interface and free surface will increase evidently.

流速的大小随各种不同工艺因素的变化呈现出一定的变化规律：随电磁力的增大，固液界面以及自由表面处的流速都会增大；集肤层渗入深度变薄，电流密度增大，会导致自由表面上流动的加强，但对固液界面处的流动速度影响不大；熔区高度的增加，也会使固液界面及自由表面处的流动增强；宽厚比增大时，固液界面上沿宽面方向的流动显著增强，但窄面方向流速变化不大，同时自由表面上流速变化也较小；过热度及温度梯度的增大，使糊状区减小，导致固液界面及自由表面处的流速显著增大。

By means of equalizing the histogram, the contrast of original thermal image is enhanced; then image region of the disc surface of insulator is intercepted manually; through the envelope of the smoothened histogram of thermal image the segmentation threshold is extracted and the morphological filtering is applied to the threshold- segmented binarized image to obtain insulator disc surface image and background image, and then 10 infrared image features of insulator disc surface image and background image, such as the highest temperature, the lowest temperature, mean temperature, variance of temperature distribution of both kinds of images, as well as maximum temperature rise and mean temperature rise of insulator disc surface relative to background, are extracted; finally, the good and bad features are discriminated by single factor variance analysis, thus the feature selection is implemented.

利用直方图均衡化增强原始热像图对比度，人工截取绝缘子盘面图像区域；通过平滑后的图像直方图包络线提取分割阈值，对阈值分割后的二值图像进行形态学滤波，得到绝缘子盘面图像和背景图像，提取2者的最高温度、最低温度、平均温度、温度分布方差以及盘面相对于背景的最大温升和平均温升共10个红外热像特征；应用单因素方差分析甄别特征优劣，实现特征选择。

Connecting sand body migration systems may controls the forming of oil-gas reservoir due to bottom bed overlap. lithologic pinch out, and/or the fault barrier. The migration system consisting of unconfornfity surface, sand bodyunconformity surface, and/or unconformity surface-fault, may control the forming of the bedrock weathered crust type oil-gas reservoir. The migration system consists of fault, sand body-fault, and/or sand body-unconformity surface, may control formation of oil-gas reservoir due to fault block, anticline, structure-lithologic, and/or fault-lithology.

连通砂体输导系统可控制底层超覆、岩性尖灭、断层遮挡油气藏的形成；不整合面、砂体-不整合面、不整合面-断层组成的输导系统可控制基岩风化壳油气藏的形成；断层、砂体-断层、砂体-不整合面-断层组成的输导系统可控制断块、背斜、构造-岩性和断层-岩性油气藏的形成。

A magnetic source and condenser for protecting a pipe, ionizing any fluid flowing therein, and ionizing any dissolved and suspended solids in such fluid, comprising:a magnetic source including a magnet having a pair of opposed planar major faces and a planar minor face extending between said major faces and perpendicular to said major faces,said magnet being charged so that one of said major faces is a south pole and the other of said major faces is a north pole,a magnetic condenser a pair of pole pieces, each of said pole pieces having a pair of opposed planar major faces, one of which is an inner major face and the other of which is an outer major face, the area of said inner major faces being equal to that of the major faces of said magnet, the area of said outer major face being larger than each of said major faces of said magnet,said pole pieces being positioned on opposite sides of said magnet such that said pole pieces sandwich said magnet, said inner major face of each pole piece is contiguous with and completely covers an entire major face of said magnet, and said outer major face of each pole piece faces away from said magnet,each pole piece having an integral foot extending perpendicularly to said inner major face of each pole piece such that said pole pieces have two respective integral feet which extend toward each other and are substantially coplanar, each foot having a distal and a proximal surface with respect to said magnet, each foot having an end which is spaced from the end of the opposite foot,said distal surface of each foot having a predetermined concave curvature which will conformingly mate with an outside surface of a pipe having a predetermined convex curvature,said proximal surface of each foot being contiguous with said minor face of said magnet

我要求： 1。一台磁性来源和冷凝器为保护管子，电离任何流体流动在其中，和电离任何被溶化的和暂停的固体在这样的流体里，包括：一个磁性来源包括磁铁有一对被反对的平面主要面孔和一张平面较小面孔延伸在前述主要面孔和垂线之间对前述主要面孔，前述磁铁被充电以便前述主要面孔的当中一个是南极并且其他前述主要面孔是北极，一台磁性冷凝器每对杆片断，每个前述杆片断有一对被反对的平面主要面孔，其中之一比每个是是一张外面主要面孔的一张内在主要面孔和其他，前述内在主要面孔区域是相等的与那前述磁铁，前述外面主要面孔区域的主要面孔大的前述磁铁的前述主要面孔，前述杆片断被安置在前述磁铁的反面这样，前述杆片断三明治认为磁铁，各个杆片断的前述内在主要面孔是接触的与和完全地包括前述磁铁的一张整个主要面孔，和各个杆片断面孔的前述外面主要面孔从前述磁铁，各个杆片断有一只缺一不可的脚垂直地延伸对各个杆片断的前述内在主要面孔这样，前述杆片断有延伸往彼此和极大地coplanar 的二各自缺一不可的英尺，各只脚有末端和接近表面谈到前述磁铁，各只脚有被间隔从相反脚的末端的末端，各只脚前述末端表面有与管子一个外表面conformingly 将联接有被预先决定的凸面曲度的被预先决定的凹面曲度，各只脚前述接近表面是接触的与前述磁铁的前述较小面孔

During the course of the initial 1.5ML layer-by-layer growth, the first 0.5ML silver atoms fill in the missingrow sites of the Pt (110)-(1×2) surface and form a pseudo Pt (110)-(1×1)-0.5ML Pt0.5ML Ag surface structure, then the subsequent 0.5ML and the last 0.5ML silver atoms locate on the silver sites and the platinum sites of the pseudo (1×1) surface, respectively. At 600K, the formation of AgPt surface alloys follows the layer-bylayer growth of Ag thin film up to 2.25ML.

Ag原子在表面的定位非常有序，当0≤θ〓≤0.5ML，Ag原子填充Pt(110)-(1×2)表面的&missing-row&位并形成Pt(110)-(1×1)-0.5ML Pt-0.5ML Ag表面结构；当0.5ML≤θ〓≤1.0ML，Ag原子生长在Pt(110)-(1×1)表面的Ag位；当1.0ML≤θ〓≤1.5ML，Ag原子生长在Pt(110)-(1×1)表面的Pt位。600KAg薄膜在Pt(110)-(1×2)表面层层生长至2.25ML，然后形成表面合金。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了