查询词典 surface tension

The basic principle, advantage, disadvantage and the improvement for measuring liquid surface tension with different methods were described. The methods were capillary rise method, Wilhelmy plate method, pendent drop method, drop volume method, maximum bubble pressure method. The problems in the surface tension measurement of wide temperature and pressure range, the chosen of experimental methods and the development tendency of these were introduced especially in this paper.

本文着重介绍了几种液体表面张力的测定方法（包括毛细管上升法、Wilhelmy盘法、悬滴法、滴体积法、最大气泡压力法），包括这几种方法的测定原理、优缺点及改进方法，特别指出了宽温度和压力范围的表面张力测定存在的问题，实验方法的选择及表面张力测定方法的发展趋势。

The basic principle,advantage,disadvantage and the improvement for measuring liquid surface tension with different methods were described.The methods were capillary rise method,Wilhelmy plate method,pendent drop method,drop volume method,maximum bubble pressure method.The problems in the surface tension measurement of wide temperature and pressure range,the chos...

本文着重介绍了几种液体表面张力的测定方法(包括毛细管上升法、Wilhelmy盘法、悬滴法、滴体积法、最大气泡压力法)，包括这几种方法的测定原理、优缺点及改进方法，特别指出了宽温度和压力范围的表面张力测定存在的问题，实验方法的选择及表面张力测定方法的发展趋势。

Adopting 6 standard liquids surface tension values and their corresponding contact angles on top of garlic skin and garlic kernel, solid surface tension were derived as 46 and 34 for garlic skin and garlic kernel, respectively.

采用6种标准溶液之表面张力值，配合在蒜皮与蒜仁上之接触角测量，可计算推导蒜皮及蒜仁固体表面张力值分别为46 和34 。

To improve the surface tension of printer materials, surface tension values required to reach 38 Dyne/cm or more

提高承印材料的表面张力，要求表面张力值要达到38达因/厘米以上

Being different from conventional multimolecular micelle systems, the unimolecular micelle system of P(AMC14AB) not only shows critical micellar concentration (CMC=0),(i.e.once added to pure water, the surface tension decreases immediately in spite how small the density is), but also the surface tension stays almost the same with the concentration increasing.

P(AMC14AB)在溶液表面也发生表面吸附，使水的表面张力下降，即P(AMC14AB)也具有表面活性；随着浓度增大，表面吸附量增大，水的表面张力持续下降；当表面吸附达饱和时，表面张力～浓度曲线上出现突变点，该点定义为饱和的表面吸附浓度，而不应该再称为临界胶束浓度。

The determination of surface tension and surface tension components of porous particle with sub-pores by wicking technique was studied.

研究了用薄层毛细渗透技术测定多孔性颗粒的表面张力和表面张力成分。

The role of surface treatment is to improve the film surface tension so that it is greater than the ink to the surface tension of the ink and the correct filmogen.

表面处理的作用是提高薄膜的表面张力，使其大于油墨的表面张力，从而达到油墨和薄膜材料的正确结合。

The preparation of avermyctin emulsions in water was achieved by mixing the surfactants polyoxyethylene (10) octylphenyl ether (OP10), polyoxyethylene styrenated phenol ether (602), and polyoxyethylene (40) castor oil ether (EL-40) with polyoxyethylene (20) castor oil ether (EL-20), separatively. Emulsion stability was investigated by analyzing the hydrophile-lipophile balance, critical micelle concentration, and surface tension. Then, the surfactants of polyoxyethylene polyoxypropylene styrenated phenol ether (1601), block copolymer (L64), and octyl phenyl polyoxyethylene phosphonate were added to the emulsion made by blending EL-40 and EL-20, separatively. The stability of the emulsions was investigated further and discussed in terms of droplet size, surface tension, and zeta potential.

首先将辛基酚聚氧乙烯醚(OP10)、苯乙烯基酚聚氧乙烯醚(602)和蓖麻油聚氧乙烯(40)醚(EL-40)分别与蓖麻油聚氧乙烯(20)醚(EL-20)复配制备阿维菌素水乳剂，从亲水亲油平衡值、临界胶束浓度、表面张力等方面分析了二元表面活性剂复配对乳液稳定性的影响；其次，在EL-40与EL-20复配基础上，将苯乙烯基酚聚氧乙烯聚氧丙烯醚(1601)，嵌段共聚物(L64)和辛基酚聚氧乙烯醚磷酸酯分别添加到乳液中，从粒径、表面张力和zeta电势等方面考察三元表面活性剂复配对乳液稳定性的影响。

The properties of microcapsules,including the surface morphology,the size and distribution were characterized using optical photographic microscopy.Surface tension of the surfactants and interfacial tension of oil /water for sodium dodecylbenzene sulphonate solutions at different concentrations were determined by ring method.

采用光学显微镜表征微胶囊粒径大小及分布、表面形貌等性质，用圆环法测定表面活性剂溶液的表面张力和不同十二烷基苯磺酸钠浓度水溶液/环氧树脂的界面张力，探讨了表面活性剂种类和浓度对MUF环氧树脂微胶囊粒径和形成过程的影响。

The hydrophobic monomers such as glycidyl octyl dimethylammonium chloride, glycidyl dodecyl dimethylammonium chloride, glycidyl tetradecyl dimethylammonium chloride was applied to the hydrophobic modification of two kinds of sodium cellulose sulfate in isopropyl alcohol under 65℃.The success of synthesis of a kind of novel amphoteric surfactant by FT-IR and NMR. 3. By the measuring surface tension of all kinds of amphoteric polymeric surfactants based on cellulose, the critic micelle concentration was obtained such as 0.4wt%、0.3wt%、0.25wt% and corresponding surface tension was about 30mN/m

通过动态接触角测量仪确定了各种纤维素表面活性剂的表面张力和临界胶束浓度，结果表明该类表面活性剂可与小分子表面活性剂的降低表面张力的能力相媲美，最低可达28.41 mN/m，随着疏水基中碳链的增长，降低表面张力的能力下降，而临界胶束浓度从0.4wt%相应降低0.25wt%；应用环境扫描电镜确定其不同浓度胶束形态，结果表明在较低浓度下形成棒状单分子胶束，随着浓度的升高，单分子胶束逐渐聚集成树枝状胶束，进一步提高浓度，则聚集成网状结构；此外，采用了高级流变仪对其溶液的流变性质进行了研究，结果表明其溶液属于剪切变稀流体，是高分子溶液特有的性质。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。