查询词典 surface resistance

Compounded surfactant in combination ; surfactant for EOR ; surface/interfacial tension ; heat resistance ; calcium/magnesium tolerancy ; oil displacement efficiency ; surfactant flooding systems

复合表面活性剂；驱油用表面活性剂；表面/界面张力；耐温性；抗钙镁性能；驱油效果；表面活性剂；驱油体系

Under the condition of two bodies abrasive wear, the wear resistance of the wear resistant composite with the bionic unsmoothed surface is 29 times as much as that of 45 steel.

仿生非光滑耐磨复合层具有很高的韧性和塑性，且可根据需要调节复合层的厚度，为提高地面触土机械部件的抗磨性开辟一条新的途径

Joining of alloy white cast iron, as an unsmoothed surface material, and steel is one of the key techniques in study of the reduction of soil adhesion and resistance of bionic unsmoothed surfaces.

仿生非光滑表面减粘降阻研究的关键技术是非光滑单元体材料与钢的连接。

Aluminizing the fine copper ' s surface could enhance its strength, rigidity, abrasion resistance and corrosion-resisting properties.

对纯铜表面进行渗铝，可以提高其强度，硬度，耐磨损性和耐蚀性能。

Aluminizing the fine copper ' s surface may enhance its strength, rigidity, abrasion resistance and corrosion-resisting properties.

对纯铜表面进行渗铝，可以提高其强度，硬度，耐磨损性和耐蚀性能。

Studies on mechanism of Biosorption and toxicity of chromium indicated that Biosorption was contained of surface adsorption, transport across cell wall and membrane, and bioaccumulation. Further more, bioaccumulation played significant role in total Biosorption capacity, it attainted 70.6%. And the resistance on chromium of cell wall was perfect, breakage exceeded of 0.1 nm was not conduced by 300 mg/L chromium. Detoxifcation ability would be facilitated by activated sludge.

对吸附机理和毒性的初步探讨结果表明，菌体对铬的吸附由表面吸附、跨壁膜运输和体内积累组成，其中体内积累对吸附的贡献值最大，达到总吸附量的70.6%；细胞壁对铬毒性的抗性理想，300mg/L铬不会对细胞壁产生0.1nm以上的形态破坏；活性污泥的联合使用有助于铬的还原。

Lithologies are mostly sand and carbonate rocks, caps are mud rock, shale and magmatite. Entrap types are anticline, fault block rebuilt by breaking and the screened entrap diapered rock mass. The composition is CO_2, N_2, CH_4, C_2H_6 and He etc. It is magma air source body and its geologic fashions are intrusion and buried volcanic conduit. The relations between gas reservoirs and gas source bodies have three types: magma intrusion-breaking-communicated gas reservoir, magma intrusion-contacted CO_2 reservoir and buried volcanic conduit-contacted gas reservoir. The CO_2 migration in magma intrusion is consisted of fusing and crystallizing phases;it in volcanic conduit is consisted of near-surface effusion and crystallizing phases.The buoyancy of CO_2 in water far more than migration resistance in breaking or chink, CO_2 is easy float upward, the floating can results in differentiation of different density gases and concentration of sealed gas. The gas in sand reservoir firstly migrate into the higher porosity and coefficient of permeability sand, and along with the pressure going up it migrate into the lower. In magma intrusion-breaking-reservoir migration, CO_2 firstly migrate into watered breaking, began gravity differentiation and concentrate, the gas pressure time and again go up, CO_2 migrate into reservoir and concentrate under expansibility as the pressure reach upward a given extend. The CO_2 in reservoir experience four breaking modes: chemistry deposition, dissolution, diffusion and mechanic breaking, the pressure balance can be broken by faulting and the CO_2 will further migrate and form new reservoir.

济阳坳陷已发现的八里泊、阳25、平方王、平南、高青、花17 CO_2气藏主要储集层位有奥陶系、中生界、沙四段、沙三段、沙一段、馆陶组和明化镇组，储集层岩性以砂岩和碳酸盐岩为主，盖层以泥质岩、页岩和岩浆岩为主。；圈闭类型主要为受断裂改造的背斜、断块及刺穿岩体遮挡圈闭。；气体成分主要有CO_2、N_2、CH_4、C_2H_6、He等。；主要气源体为岩浆气源体，气源体的主要地质形式为侵入体和埋藏的火山通道。；气藏和气源体的空间关系有岩浆侵入体一断裂一气藏沟通型、岩浆侵入体-CO_2气储集层接触型和埋藏火山通道-气储集层接触型三种类型。；岩浆侵入体CO_2气运移分为熔融运移阶段和结晶运移阶段，火山通道中CO_2气运移分成近地表喷发阶段和结晶运移阶段。；断裂中，CO_2在水中的浮力远大于运移阻力，CO_2气容易上浮，CO_2在断裂中的易浮性导致不同密度气体的分异和走向上封闭的断裂气体相对富集。；气体在砂岩储集层运移聚集具有选择性，会优先进入孔隙度和渗透率较高的砂岩，随着压力增加，才会进入孔隙度和渗透率较低的砂岩；在岩浆气源体-断裂-储集层空间输导格架下，CO_2气在膨胀力的驱动下，首先进入含水的断裂并重力分异而聚集，气体压力会不断增高，当压力增至一定程度，CO_2气会向高孔隙度、渗透率的储集层运移并聚集。；在岩浆气源体-储集层接触空间输导格架下，CO_2气受膨胀力的驱动直接向储集层运移并聚集。；成藏的CO_2气会经历化学沉淀、溶解、扩散和机械破坏四种破坏方式，会受断裂切割而打破压力平衡，沿断裂进一步运移和聚集成藏。

The results show that the coating surface of electrodeposited pretreatment powder is uniform, and the wear resistance is improved.

结果表明，电镀Cu预处理粉末的喷涂层表面较为均匀，耐磨性约为粘结破碎法预处理粉末喷涂层的2倍。

Surface modification by electrodeposited nickel coating is an important technology which has been widely used in practical applications due to their good appearance and corrosion resistance.

由于镍镀层具有良好的外观和耐腐蚀性能，利用其进行表面改性是一项重要的应用技术。

This paper analyzed SEM characteristics, surface roughness and micro-hardness of electroformed composite electrode materials, and studied their electrical erosion resistance .

通过复合电铸技术，在耐电蚀性强的铜主体中引入抗电蚀性能优异的石墨微粉，制备了铜-石墨复合电极材料，探讨了复合电沉积条件与石墨含量的关系，用扫描电子显微镜分析了复合铸层的形貌特点，测定了表面粗糙度和显微硬度，试验研究了复合电极材料的抗电蚀能力。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。