查询词典 surface resistance
- 与 surface resistance 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
From FT-IR we think that the hydrogen bond between the polar oxygenous group on the thin film surface treated with plasma and acetone molecules would enlarge the distance between the carbon black particles, resulting in the addition of the electrical resistance, then the response behavior of the thin film to acetone was improved greatly.
我们通过FT-IR研究认为,等离子体处理后,薄膜表面引进的极性含氧基团与丙酮分子之间氢键的形成会增大炭黑粒子之间的距离,导致了薄膜电阻的极大增加,使薄膜对丙酮蒸气的响应得到很大改善。
-
Quantitative analysis can be divided into 50-350g/m2, with no degradation of thin-film, anti-false, easy to use design-pattern, the paper surface gloss over foil, aucilisty, ployster polychloride membrane mirror paper, cards and membership cards make good adaptability, coating and pictorial proof alkali resistance, high alcohol being polished, scrap rate and business card printing and membership card making difficult well below the foil and polished to a mirror of paper.
定量可分为50-350g/m2,无薄膜、易降解、防伪图案采用隐含式设计,该纸表面光泽度超过铝箔纸、pET、聚酯聚铝膜镜面纸、制卡和会员卡制作适应性好,涂层和图案耐酸碱、耐汽油、耐酒精擦拭,废品率和制卡和会员卡制作难度大大低于铝箔纸和镜面纸。
-
While the average bulk pore diameters which were measured by porosimeter were 0.33μm and 0.24μm for NMP and TEP system, respectively. It revealed that the permeate resistance was in the inner surface.
但利用孔隙测定仪所量测之平均孔洞直径分别为0.33μm与0.24μm,相近於内表面平均孔洞直径,表示内表面为主要透过阻力。
-
Meanwhile, the surface layer gets fine crystal grain with dispersive and homogeneous distribution of WC grains and Co binder from rapid melting and resolidification during HIPIB irradiation. Minimizing the mean free path in Co binder by decreasing the WC grain size leads to an increase in resistance to plastic deformation in the binder.
HIPIB强烈非平衡作用下的重熔和再结晶使WC晶粒细化且分布更均匀,同时,表层析出弥散分布的Co_3w_9C_4相,使Co粘结相产生强化,导致Co粘结相的平均自由程降低,从而增强了Co粘结相抵抗塑性变形的能力,提高了辐照硬质合金的耐磨性能。
-
The surface tension coefficient of water and alcohol experiment is conducted by using Si-resistance-strain gauge and ringlike slice.
通过用万能试验机的加载部分对试件加力来进行材料的拉伸实验,用硅压阻式力敏传感器及环状吊片来进行液体表面张力系数的测定的实验,分析、比较了塑性固体材料和液体在拉伸过程中的共同点。
-
The above facts indicated that silicon accumulation in the rice leaf sheath inside, the leaf surface and the sclerenchymatous cell, played the physical barrier role, delayed the hypha of sheath blight expansion.5、Analysing the physiological and biochemical mechanism of the resistance to rice sheath blight improved by silicon application in several respects.(1) After being inoculated with R.solani, O2 and POD activities disordered, CAT activities obviously declined. O2 producingvelocity in 91SP\'s leaves and leaf sheaths of Si+ rice plants were lower than those of Siriceplants, MDA content in leaves and leaf sheaths of Si+ rice plants were lower thanthose of Si- rice plants significantly in three days after inoculating, SOD、POD、CATactivities in leaf sheaths of Si+ rice plants were higher than those of Si- rice plantssignificantly in one day after inoculating, SOD、POD、CAT activities in leaves ofSi-treatment were higher than those of Si- rice plants significantly in three days afterinoculating. O2 producing velocity and MDA content in Lemont\'s leaves and leafsheaths of Si+ rice plants were lower than those of Si- rice plants significantly afterinoculating, and SOD、POD、CAT activities of Si+ rice plants were higher than those ofSi- rice plants significantly.
说明硅在水稻叶鞘内侧、叶表和厚壁细胞积累,起到了物理屏障的作用,延缓了纹枯病菌的扩展。5、阐明了施硅增强水稻抗纹枯病的生理生化机制(1)接种纹枯病菌后,两个水稻品种91SP和Lemont的叶鞘和叶片超氧阴离子自由基O2性紊乱,CAT活性明显下降;抗病品种91SP叶鞘和叶片施硅处理的O2产生速率小于缺硅处理,叶鞘和叶片MDA含量在接种第3 d后显著低于缺硅处理,叶鞘SOD、POD、CAT活性在接种1 d后一直显著高于缺硅处理,叶片SOD、POD、CAT活性在接种3 d后显著高于缺硅处理;感病品种Lemont叶鞘和叶片施硅处理的O2产生速率、MDA含量始终显著小于缺硅处理,SOD、POD、CAT活性始终显著大于缺硅处理。
-
First, the thermal resistance of three heat sink related to Re and H / D was obtained separatively, and the average Nusselt number equation of the simulated chip surface under the three heat sinks related to Re and H / D was got separatively by least square method too.
首先,分别获得了这3个热沉的热阻随 Re 数及 H / D 变化的实验数据和对应这3个热沉的模拟芯片表面的平均努塞尔数随 Re 数及 H / D 变化的实验数据;其次,选用合适的函数形式对实验数据采用最小二乘法拟合,得到了此实验条件下关于 Re 、 H / D 及肋片高度 Hf 的准数方程。
-
The requirement here is that chippings exposed at the surface should help to provide adequate skidding resistance.
此处的要求是暴露于表面的碎片应该有助于提供足够的防滑阻力。
-
The requirement here is that chippings exposed at the surface should help to provide adequate skidding resistance.
这里是chippings要求暴露于表面应该帮助提供足够的滑动阻力。
-
The effect of TiC coating in electrode tip surface on spheriform electrode degradation during resistance spot welding zinc coated steel was investigated by SEM,EDX and XRD.
利用SEM、EDX和XRD等方法分析了在点焊镀锌钢板时球形电极表面熔敷TiC涂层对电极失效的影响。
- 推荐网络例句
-
According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.
曝气设备的动力效率在叶轮转速为120rpm~150rpm时取得最大值,此时氧利用率和充氧能力也具有较高值。
-
The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.
稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世,形体几无变化。
-
When I was in school, the rabbi explained everythingin the Bible two different ways.
当我上学的时候,老师解释《圣经》用两种不同的方法。