查询词典 surface of contact

The effects of wear on the frictional properties of surface in contact are carried out and analysed by experiments macroscopically and microscopically.

在实验基础上，提出了一个新的基于Bouc-Wen的单状态变量摩擦力模型。

3 Gasket contact surface of girth flange shall have a finish equivalent to the following in μm.

同法兰表面接触的垫片的磨光应符合下列要求，单位μm

The hyperbolic-type nonlinear model and rigid and perfectly-plastic model are usually adopted to simulate the constitutive behavior in tangent direction of contact surface. in fact, however, the hyperbolic-type nonlinear model can not definitely display the plastic flow deformation after shear failure while rigid-perfectly-plastic model can not describe the nonlinear deformation before shear failure.

对于土与结构间接触面的切向本构关系，目前通常采用双曲线非线性弹性模型或刚塑性模型来描述，但是，传统的双曲线非线性模型不能明确地表达剪切破坏后的塑性流动变形特性；而刚塑性模型又无法描述剪切破坏之前的非线性弹性变形。

The corrosion fatigue crack growth and near-threshold characteristcsof high tensile steel HT60 were investigated by using the compact specimens underexposure to synthetic sea water. The da/dN vs △K_ relation in air may be conser-vetivel estimated for that in sea water. In the high △K region with high stressratio, owing to the acceleration of crack growth promoted by stress-induced dissol-ution, the crack opening stress intensity factor K_ represents only the result ofcrack surface in contact with corrosion products, so as to give an overestimation ofK_ at crack tip.

对高拉力钢HT60的腐蚀疲劳裂纹扩展特性和门槛值区域特性，采用紧凑拉伸试件在人工海水中进行了实验和研究，结果表明：在空气中的da/dN与ΔK_关系可以作为在海水中的da/dN与ΔK关系的一个偏保守的预测；在高应力比的高ΔK区域，由于应力诱起溶解促进了裂纹扩展的加速；该裂纹开口应力强度因子K_仅反映了裂纹表面同腐蚀生成物接触的结果，从而导致了K_在裂纹尖端的偏大的估计结果。

The inner layer of the pericardium that is in actual contact with the surface of the heart.AOL's new 4.0 software helped turn around the company's image as an unhip online crutch for neophytes.

美国在线服务公司新开发的4.0软件使整个公司的形象有了一个大的转变，人们不再认为aol公司是一家跟不上时代潮流的、联机操作方面的新手了。

The frictional heat energy was concentrated on the thermal effect layer with the thickness of 4 mm, The temperature gradient of contact surface is the highest, and decreased rapidly with the radius direction of the lining's groove. The temperature gradient and TEL's thickness increased with the increasing of the sliding speed. The temperature decreased rapidly with the radius direction and also with the increasing of center angle of the lining's groove. The sliding speed and distance are obtained under two sliding conditions when the lining fails, which supply the theoretical basis with the antislip design of friction hoist.

摩擦热量集中在热影响表面层，其厚度仅为4mm，接触表面温度梯度最大，沿绳槽径向迅速减小；温度梯度和热影响表面层厚度随相对滑速的增大而增大；衬垫温度沿径向急剧降低且随圆心角增大而减小；并得到了2种滑动工况下衬垫失效时的相对滑速和滑动距离，为摩擦提升防滑设计提供理论依据。

The contact tooth surface of the cylindrical gear with symmetrical arcuate tooth trace is analyzed with this method, and the results are compared with those got with the traditional TCA method.

用此法对弧形齿线圆柱齿轮进行了实例分析，分析结果表明此方法是正确可行的。

Being Compared contact angle changes of various adhesives on different surface of Moso bamboo and Chinese fir with the coefficients of penetrability, it was found that wettiability of polymeric diphenylmethane diisocyanate adhesive was much better than emulsion polymer isocyanate adhesive, wettiability of phenol-formaldehyde adhesive and urea-formaldehyde adhesive were in the middle of above two adhesives.

通过研究不同胶粘剂在毛竹表面的接触角变化，并结合胶粘剂渗透扩散系数，发现聚异氰酸酯胶在竹材表面的润湿性较好，而双组分乳液型聚异氰酸酯胶的表面润湿性较差，酚醛树脂胶和脲醛树脂胶润湿能力处于二者中间。

The light curve is analyzed by means of theWilson-Devinney code, and the present photometric solution reveals that BL And is a marginal contact binary system with a dark spot on the photospheric surface of the second component.

用 WD程序对BL And进行了解轨后，发现该系统是一个临近相接的双星系统，且其G型次子星上存在一个低于环境温度790K的黑子。

The electronic structure of contact between Ti surface and a semiconducting carbon nanotube is also investigated.

我们还研究了半导体碳纳米管在Ti表面的稳定性和电子结构性质。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。