查询词典 surface of contact

Ceilings should be ac-cessible for cleaning, and ideally, the surface should he coved where ceilings and walls meet In many food-production areas, the ceiling must have thermal in-sulation This may be necessary either to prevent surface condensation or to reduce the energy costs of maintaining low environmental temperaturesWalls should also be insulated, to prevent surface condensation They should be free from rising damp and be protected, where appropriate, from damage by forklift trucks, by use of a guard rail In modern factories, there is always a coved surface where walls meet the floor It is also usual for there to be a coved surface where walls join at right angles.

天花板应该交cessible清洗、最理想他表面复岩下天花板和墙壁应满足许多粮食产区，天花要有热的绝缘要么这可能需要防止或者减少表面凝结能源维护成本低，对环境温度也应绝缘墙壁、应防止表面凝结他们免于受到保护和潮湿上涨，酌情从叉车损坏，用现代铁工厂门卫、凡事总有复岩面墙那里迎接地板也是平日没有可能凡参加面复岩墙成直角。

A series of erosion-corrosion test has been done to J55 steel under the influence of current of gas-liquid phase by indoor self-made devices, and the corrosion mechanism of current of gas-liquid phase to oil pipe's inner surface has been got. The results show that oil pipe's inner surface will be corroded fleetly by liquid medium and corrosion products will form on it. But at the same time, the corrosion products or protective layer will be removed from the inner surface of steel pipes under the alternate impact of high speed gas and liquid flow, and on this bare steel surface corrosion film will form again and be removed again. Thus, by these ways the corrosion is exacerbated. Surface erosion-corrosion failure comes into being with the circulation of this process going on.

本文主要在气液两相流作用条件下，通过室内自制装置，对管材钢J55做了系列冲刷-腐蚀试验，结果表明，气液两相流对钢管内表面冲刷－腐蚀的机理是钢管内表面会受到液体介质的快速腐蚀，生成腐蚀产物，同时钢管金属表面不断被具有高流速的气液相交替地冲击，不断地从金属表面脱去保护膜或腐蚀产物，裸露的钢表面又会被介质快速腐蚀形成腐蚀膜后，再被两相流冲掉，如此反复，造成管内金属表面膜的连续破坏，使腐蚀加剧，最终导致钢铁表面的冲刷腐蚀失效。

If an object sliding along the contact surface, the two of the contact surface of the convex part of the collision, a fracture, wear, created obstacles to the movement.

如果一个物体滑动沿接触表面来看，两者的接触面的凸角部分的碰撞，断裂，磨损，制造障碍，把运动。

This method undertakes comparative getting the area between the spare parts to equation of geometry of the face in model of CAD of different spare parts above all - surface contact relation and type, use amount coming back theory general face - the face expresses to be helix; relative to instantaneous motion next, the helix that goes up to many surface contact undertakes making operation,; of helix of the motion when making the opposite very short time between the spare parts is final, according to the spare parts abut concern plan and abut spare parts move relatively helix, undertook an analysis to assembling instantaneous of whole of the spare parts in the model to concern with drive movably, give out not between the method of calculation of helix of opposite instantaneous motion between photograph adjacent spare parts and them but the judgement method of drive sex.

该方法首先对不同零件CAD模型中面几何方程进行比较得到零件之间的面-面接触关系和类型，并应用旋量理论将面-面相对瞬时运动表示为螺旋；然后，对多个面接触上的螺旋进行交运算，生成零件之间的相对瞬时运动螺旋；最后，根据零件邻接关系图和邻接零件相对运动螺旋，对装配模型中零件整体瞬时可动性和驱动关系进行了分析，给出不相邻零件之间的相对瞬时运动螺旋计算方法和它们之间可驱动性的判定方法。

In this paper, a model forwheel/rail with arbitrary profiles contacting in an arbitrary point is built to calculate contact area and contact surface stresses. Then bytakingthe calculated surface stresses as applied load, the stresses inside the railhead are calculated through the three dimensional elastic-plastic finite element method.

建立了一个任意形状钢轨和车轮在任意点接触时，接触面形状和接触面力的计算模型，然后把计算出的接触面力作为外载施加到三维弹塑性有限元模型中，进行轨头内部应力的计算，从而构成一个完整的计算方法。

Mainly introduced in this article 24 playing card and put together the chart game the development, including contact surface design and corresponding contact surface principle of design, but also introduced its development environment.

在本文中主要介绍了24点纸牌游戏的开发，其中包括界面的设计和相应的界面设计原则，还介绍了其开发环境。

Static friction: When objects and other objects along the contact surface tangent direction of movement or relative movement of the trend in the two objects contact surface between the hamper their relative movement of force, this force is friction.

静摩擦力：当物体和其他物体沿接触面切线方向运动或相对运动的趋势，在两个物体接触面之间的阻碍它们相对运动的力量，这股力量是摩擦。

Adhesive forces and contact area between arolium and the target surface were measured when Lycorma delicatula walked on the level and slided on the vertical surface. A model of peeling theory was put forward to give relationship between contact area and adhesive forces.

测量了斑衣蜡蝉在切向和法向两种状态下的抓附力以及在切向和法向两种状态下抓附时中垫与接触面的接触面积，分析了接触面积和力的关系。

The computation results show that under two degree-of-freedom motion, the process of enveloping the worm is of point contact form, and the worm surface is generated by contact points, regardless of the type of generant, such as straight line, plane and disk annular curved surface.

本文又首次提出并建立了在双自由度运动状态下，用平面砂轮和盘状环形砂轮包络加工圆柱蜗杆传动的方案及数学模型，其目的在于拓宽包络圆柱蜗杆传动的应用范围，对此也编制了相应的计算机软件。

matlab sps is used to build a simulink model of single-machine infinite-bus system, and based on the simulink model, simulation on effect of pss suppressing small disturbances low frequency oscillation is carried on, and some methods of improving power system transient stability are simulated, including avr and pss, short circuit cleared rapidly, fault current limiter and single-phase auto reclose. the study unifies the simulink model to realize matlab and vb seamless integration using the activex technology, and demonstrated the matlab simulation result with the vb contact surface. this method of matlab and vb integration can make up the matlab contact surface unfriendly flaw and offers a reference for the design for cai of power system analysis course.

运用matlab电力系统仿真模块集sps构建了单机—无穷大系统simulink模型，对电力系统稳定器抑制电力系统小扰动低频振荡的效果进行了仿真；对提高电力系统大扰动功角稳定性的措施，如自动电压调节器及电力系统稳定器、快速切除故障、故障限流器、自动重合闸等手段的使用效果进行了仿真验证；并结合单机—无穷大系统的simulink模型运用activex 技术实现sps与vb的无缝集成，将sps的仿真结果用vb界面显示，较好地弥补了matlab用户界面不友善的缺陷，为《电力系统分析》课程进行cai设计提供了思路。

Putt your way through 36 fun-filled holes of minigolf on 3D designed courses with elevated greens, bunkers, bridges and water hazards, among other crazy obstacles.

您的推杆方式，通过36个有趣的填孔迷你的三维设计的课程，以提升绿党，掩体，桥梁和水的危害，除其他疯狂的障碍。

Some participles can be used either as attributes or as predicatives.

有些分词既可当定语用，也可当表语用。