查询词典 surface coating

Films are obtained via dip-coating process. The results show that the isolated and tetrahedrally coordinated Ti(superscript 4+) which formed Ti-O-Si bondon the pore inner surface of the framework.

实验结果表明，多孔薄膜中的钛离子形成了Si-O-Ti键的孤立四配位形态，使薄膜具有复合型钛离子的催化效果，并且有介孔结构。

The carbon steel pipe was lined with a uniform dense and thick ceramic coating on its inner surface by the thermite reaction fusion adhesion process.

采用铝热反应熔附成型技术在普通碳素钢管内壁涂覆一层较为均匀致密的陶瓷层。

With about 2-3 monolayers of pure ZnSe on the surface, the PL of d-dots was actually enhanced upon thiol coating.

约2-3单分子膜的纯ZnSe的表面上，临时立法会的D - DOTS策略，实际上是增强后，巯基涂层。

The surface turns brown as the organic solvent and surfactant dries and burns off to produce a white or green titanium dioxide coating.

表面变成褐色的有机溶剂及表面活性剂干燥和烧伤过产生白色或绿色的二氧化钛涂层。

A type of coating applied to the substrate surface to improve adhesion of a subsequent topcoat.

一种用于涂装基材表面改进顶涂附着力的涂层，改进耐腐蚀性能，遮盖力，表面平整度。

When the above phosphating process was used on the weld joint of wire, the result showed that the phosphate coating can eliminate surface transverse cracks.

生产性磷化试验表明，采用低温快速磷化工艺对盘条焊接区进行磷化处理，能有效地防止表面横向裂纹的产生。

Urushiol compositions of Chinese lacquer samples from 60 single trees were determined by GC. Film properties including surface drying time, luster value, shock strength, adhesion and flexibility were tested according to standard methods for coating.

本文作者用气相色谱法测定了约60个单株生漆样品的漆酚组成；同时用涂料标准方法测定了这些样品的漆膜的表干时间、光泽值、冲击强度、附着力、柔韧性等。

Liquid oils or finish in the finishing process, between about viscosimetry, 0.03－0.07pa.s, liquid varnish coating in the packaging business card printing and membership card making products surface, at the start of the wet-membrane "" viscosimetry is very low, and to become a good mechanical properties "" dry film, that is, when the oil or oil "" all dry stage, at least to achieve here 10Mpa.s viscosimetry.

液体底油或上光油在整饰加工中，粘度约在0.03－0.07pa.s之间，因此，液体光油涂布在包装制卡和会员卡制作制品表面后，开始时的"湿膜"的粘度是很低的，而要成为具有一定机械性能的"干膜"时，即常说的底油或面油的"全干"阶段时，这里粘度至少要达到10Mpa.s以上。

From the "" to wet-membrane "" viscostty dry film evolves, you can see any of the oils or gloss drying or curing process must go through the process of viscosimetry products, that is solid oils or varnish, mostly due to its own power, but was decoratine adhensive in coated packaging business card printing and membership card making products surface, it is not possible to immediately contiguous becomes solid continuous gloss films, only up to a certain conditions in order to complete all of the varnish coating to the drying process of prefilming.

从"湿膜"到"干膜"的粘度变化过程中，可以看到：任何一种的底油或光油的干燥或固化过程必然都要经历该产品粘度的变化过程，即是固体的底油或光油，由于其本身多为粉末状，但在装饰粘附在被涂布的包装制卡和会员卡制作制品表面后，还不可能立即就形成连续进行变成为固体连续光油薄膜的过程，只有达到一定条件才能完成全部的由光油涂布到干燥成膜的过程。

Enamel is a high silica content of the vitreous enamel coating on the metal surface, many times at 900 high temperature sintering to form a dense metal surfaces in the vitreous glaze, which has a metal strength and excellent corrosion resistance and electrical properties.

搪瓷是将高二氧化硅含量的釉瓷喷涂于金属表面，经900℃高温多次烧成，使之形成密着于金属表面的玻璃质釉，而具有金属的强度和优良的耐腐蚀及电性能。

I didn't watch TV last night, because it .

昨晚我没有看电视，因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来，在北京的很多小区里，电梯液晶电视被撤了下来。