查询词典 surface coating

Glazing the essence of the coating process is on the business card printing and membership card making products surface leveling

上光涂布过程的实质，是上光涂料在制卡和会员卡制作品表面流平

The viscosity of coating increased with the increase of the amount of halloysite, and the water retention value becomes a little smaller. The brightness, gloss, surface printing strength increased with the increase of the amount of halloysite, and the smooth, ink absorption also have certain improvement.

涂料的粘度随埃洛石用量的增加而增大，涂料保水值略有减小；使用埃洛石后，涂布纸白度、光泽度、表面印刷强度随着其用量的增加而增大，纸张的平滑度、油墨吸收性也有一定的改善。

Solid brass molded, ceramic headwork, PP knob, epoxy resin powder coating on the surface, strong acid and alkalis resistant and anti-rusty.

采用实验室专用化验龙头，阀体采用全铜铸模工艺制造，高强度陶瓷阀心，手柄为耐酸碱高强度聚炳烯材质，表面经环氧树脂粉末高温烧涂工艺处理，整体具备防酸碱及防锈特性。

Analysis of experimentation results shows that the organic antipollution coating RTV, which has a good hydrophobia and hydrophobia transfer property, can improve the power devices＇ surface resistance and withstanding flashovers performance greatly.

对比试验分析表明，有机防污涂料良好的憎水性和憎水迁移性，使受涂设备的外绝缘电阻及耐闪能力都得到了显著提高，其长效性、良好的适应性以及经济性使其在众多的防污闪措施中具有一定的优势。

Nano- and Micro-Hardness Testers（Nano Indentor/Micro Indentor）- Quantitative measurement of mechanical surface properties: elastic modulus and hardness - Analysis of fracture modes, cracking,… Nano- and Micro-Scratch Testers - Adhesion and anti-scratch properties of coatings and films - Profilometry Tribometers - High Temperature, Vacuum and Nano Tribology - Wear and Friction studies Calotest / Calowear - Coating thickness measurement - Wear rate testing 3D Imaging - Atomic Force Microscope - Confocal Microscope

动态压痕测试仪器为您提供纳米或微米尺度下材料的硬度、弹性模量、蠕变、断裂韧性等性质。我们还为您提供纳米级、微米级摩擦磨损测试仪器，用以测量材料的摩擦系数和磨损率。我们的球磨仪器是测量薄膜厚度最简单准确的工具。我们同时提供光学显微镜、原子力显微镜、白光共焦显微镜成像工具。我们在瑞士的分析测试中心随时准备为您提供高质量测试服务。

Surface of Sn coating. At the same time, the formation of intermetallic compound at the

异，从而导致了在温度循环条件下发生SnO2与Sn的热失配，进而在其界面处产生了极大的

The result shows the tribology properties are good, the kinetic friction coefficient are under 0.1. In the same conditions of wearing test, the weight loss of surface treated with EDC is about one tenth of the weight loss without treatment, and is about one sixth of the weight loss treated with electroless composite coating.

结果表明：在本试验的条件下，涂层的滑动摩擦系数较小，均在0.1以下，说明涂层的摩擦学性能较好；在相同的磨损实验条件下，用液中放电沉积方法处理过的表面磨损失重量是未处理表面的1/10左右，是化学复合镀方法处理表面的1/6左右，说明涂层的耐磨性相对较好。

The results prove that using the laser power P=1.7Kw, scanning velocity V=4mm/s, spot diameter D=3mm, cladding thickness T=0.6mm, 50%: 50% Ni60:Ni-Cr-Cr_3C_2 as laser cladding process can obtain the laser coating with lubricous tight surface, tiny dilution rate ,fining microstructure and higher micro hardness and fine metallurgical-bonding Interface.

试验结果最终证明，激光熔覆工艺参数对熔覆层的宏观形貌、微观组织及涂层性能有极大的影响，在激光熔覆工艺参数为功率P=7Kw，速度Vs=5mm/S光斑直径D=3mm，厚度T=0.6mm，50%；50%的Ni60；Ni-Cr-Cr_3C_2的条件下，所得到熔覆层表面光滑致密、组织细小均匀、稀释率小、硬度高且与基体实现了良好的冶金结合，证明这种方法是一种在提高热锻模寿命方面有前途的方法。

It is introduced the sinter NdFeB permanent magnetic material surface preserative coating technology by writer research and development.

以及作者研究开发的烧结NdFeB永磁材料的表面防护涂层技术。

Now are relatively high-grade display to make it a better display and protection of visual function, and its surface is coated with special coatings, and organic solvents will dissolve the special coating, so that performance degradation or disappearance.

现在的显示器都比较高档，为使之有更好的显示效果和保护视力功能，其表面都涂有特殊的涂层，而有机溶剂则会溶解特殊涂层，使之效能降低或消失。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。