查询词典 surface coating
- 与 surface coating 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
This research explored the possibility and the biological effects of construction of a electro-bioactive coating on the dental implant surface using electrically conductive polymer-polypyrrole . This paradigm proved to be very powerful in combining the principles of surface engineering with electromagnetic therapy in promoting dental implant osseointegration.
本研究探索了利用PPy构建钛基金属种植体表面电生物活性层的可行性,并研究了其对体外培养成骨细胞生物学特征的影响,为钛基种植体的表面改性和生物活性设计提供了一种新思路。
-
Such as angle grinder, wire brush, needle beam pneumatic rust, and wind knock rust hammers, gear-type rotary rust, etc., are semi-mechanized equipment, tools, light, mobility, and to more thoroughly to rust , old coatings, the coating can be played on the shelf hair treatment, significantly more efficient than manual derusting increased up to 1 ~ 2m2 / h, but can not remove the oxide skin, the smaller surface roughness and can not achieve high-quality surface to deal with quality, ergonomic handle lower than the jet.
如角向磨光机、钢丝刷、风动针束除锈器、风动敲锈锤、齿型旋转除锈器等,属于半机械化设备,工具轻巧、机动性大,能较彻底去除锈、旧涂层等,能对货架涂层进行打毛处理,效率比手工除锈大大提高,可达1~2m2/h,但不能除去氧化皮,表面粗糙度较小,不能达到优质的表面处理质量,工效较喷射处理低。
-
With the electrical connections at the top and bottom side of the wafer-level IC packaging Lead-frame structure and composition of the surface-mount semiconductor package structure Multi-layer printed circuit board Antifuse and its formation method and with the anti-fuse non-volatile memory device unit cell Tandem electric signal processing circuit and electronic device Light-emitting diode packaging structure and encapsulation method Electronic Packaging Structure Flip-chip high-speed optoelectronic components and structure Pairs of piezoelectric friction side by side to promote the three-step device and scanning probe microscope Light-emitting diode and its manufacturing method, the production base of light-emitting diode method Three or four parallel advance of stepping piezoelectric device and scanning probe microscope lens body Silicon substrate and its manufacturing method Semiconductor device and voltage-divider A polysilicon layer and the microcrystalline silicon layer of the double-substrate active layer structure, methods and devices The edge of the thickness of silicon controlled Of a lateral semiconductor devices and high-voltage devices With a vertical-channel transistors semiconductor device Of a memory array and for the manufacture of a memory array method Read-only memory cell array structure Active-matrix substrate and display device High-voltage semiconductor integrated circuit devices, dielectric isolated type semiconductor device Image sensing devices Lens module and its manufacturing methods Solid-state imaging device and camera Injection angle for the trench isolation Organic Light-Emitting Display Device Organic light-emitting display device Bipolar transistor structure of the surface passivation Double-triggered silicon-controlled rectifier HFET Metal-oxide semiconductor transistors Self-aligned trench accumulation mode field effect transistor structure Thin-film transistors and Display Devices TFT Lead Diode Low-frequency, low noise, low-flashing diode Used for thin-film solar cells trap light structure Transparent sun solar cells Quaternary semiconductor heterojunction photovoltaic cells heat Si nano-pillar array heterojunction thin-film solar cells GaN-based micro-composite solar cells isotope Optical sensor Semiconductor by optical components Imaging Detector Transparent conductive oxide coating Silicon-based high-performance dual-junction solar cells Thin-film solar cells Alien LED Devices
非专业,不在行,求高手帮忙。谢谢!具有顶部及底部侧电连接的晶片级集成电路封装导线架结构及其构成的表面黏着型半导体封装结构多层印刷电路板反熔丝及其形成方法和具有该反熔丝的非易失性存储器件的单位单元串联用电式信号处理电路及电子装置发光二极管的封装结构及其封装方法电子封装结构高速光电组件及其芯片倒装结构双压电体并排推动的三摩擦力步进器与扫描探针显微镜发光二极管及其制作方法、发光二极管的底座的制作方法三或四压电体并行推进的步进器及其扫描探针显微镜镜体硅衬底及其制造方法半导体装置与分压电路具多晶硅层及微晶硅层的双底材主动层结构、方法及装置硅晶片的受控边缘厚度一种半导体横向器件和高压器件具有垂直沟道晶体管的半导体器件一种记忆体阵列及其用于制造一记忆体阵列的方法只读内存单元阵列结构有源矩阵基板和显示装置高耐压半导体集成电路装置、电介质分离型半导体装置图像感测装置透镜模块及其制造方法固态成像装置和照相机用于沟道隔离的斜角注入有机电致发光显示装置有机发光显示装置双极晶体管的表面钝化结构双触发型可控硅整流器异质结场效应晶体管金属氧化物半导体晶体管自对准沟槽累加模式场效应晶体管结构薄膜晶体管及显示器件薄膜晶体管无铅二极管低频、低噪音、低闪烁的二极管用于薄膜太阳电池的陷光结构透明遮阳太阳能电池片四元半导体的异质结热光伏电池硅基纳米柱阵列异质结薄膜太阳能电池氮化镓太阳能同位素复合型微电池光学传感器半导体受光元件成像探测器透明导电氧化物涂层硅基高效双结太阳能电池薄膜太阳能电池异形LED器件
-
The relationship between physico-chemical properties of nano-CaCO〓 and surface treating technology was studied. The results showed the coating model of micron CaCO〓 was not suitable to nano-CaCO〓. The influence of dosage of treatment agent on nano-CaCO〓 dispersion degree in matrix was studied, the results indicated it only need to passivate some active zone on nano-CaCO〓 surface.
研究结果表明,微米粒子的表面包覆活化理论不适宜用来指导纳米粒子的表面处理,在对纳米碳酸钙进行表面处理时,不需要在纳米碳酸钙表面形成完整的包覆层,只需对纳米粒子表面的部分活性点进行钝化即可,即纳米碳酸钙表面有限钝化。
-
First, to clean and dry the surface, no oil slicks, no dust. Second, to paint the surface where prevent from plating or pickling next (The corresponding additives can be used to dilute the product); painting by screen printing, pad printing, scratch, dipping, or spraying. Then 160-200OC heat cured in 20-30 minutes. To clean the coating with the corresponding removers after anodizing.
先清洁并干燥工件表面,确定无油污、无灰尘;再将阻镀漆涂于需保护位置(可用相应稀释至需要稠度);可丝印、移印、刮涂、浸涂、喷涂等;然后160至200摄氏度烘干,即可进行氧化加工;氧化处理后,请用相应清洁剂除去涂层。
-
Fresh Squid tentacle sections, mashed yellow croaker and pollution-free cubed carrot and green string bean sections are selected as raw materials which are then added, mixed and stirred with an adhesive, a seasoning agent and a tenderizer in proper amount to form fillings; the fillings are then moulded into caked filling cores which are steamed and cooled; the outer surface of the filling core is evenly coated with a layer of stiff paste, the outer surface of which is evenly attached with a layer of puffed outer coating so as to form a caked quick-frozen squid and vegetable steak which takes the shape of a puffed powder slice and is internally provided with a filling core wrapped with the stiff paste; after being quick-frozen, the squid and vegetable steak can then be made into the quick-frozen squid and vegetable steak food.
其是以新鲜的鱿鱼脚段、黄花鱼泥和无公害的胡萝卜丁、青刀豆段作为原料,加入适量的粘合剂、调味剂、嫩化剂搅拌调和成馅料,由该馅料模制的饼状馅芯经蒸制、冷却后,在该馅芯外表面均匀挂有一层浆料,所述的浆料外表面均匀粘有一层蓬松的外裹料,形成一饼状的、外表为蓬松的粉片状物、内面由浆料包裹馅芯的鱿鱼蔬菜排,该鱿鱼蔬菜排速冻后即成速冻鱿鱼蔬菜排食品。
-
What is business card printing and membership card making light of the so-called business card printing and membership card production, is in complete Teletext business card printing and copies made for Club membership card, use the collesting surface of the plate or printing graphics and text printing plate once or twice on, so that the business card printing and membership card making products surface UV coating on intermediatein.
什么是制卡和会员卡制作上光所谓制卡和会员卡制作上光,就是在完成图文制卡和会员卡制作的复制品表面,用实地印版或图文印版再印一次或两次上光油,使制卡和会员卡制作品表面获得光亮的UV膜层。
-
After SBF solution cultivation for some days, the Ca/P coating was very easily deposited on the porous surface that was constituted of cystiform polygon made up with irregular nanometer circles like honeycomb. The energy spectrum showed that n/n atom ratio is about 1.61:1 which is very similar to that of HA and human bone. The active surface of the porous titanium after acid-alkali treatment and SBF solution condition which calcium-phosphorus ions was supersaturated induced the formation of Ca/P deposition layer.
SBF溶液培养后发现沉积层由蜂巢状多边形胞状物组成,这些胞状物是由网状纳米环无规则排列构成,能谱测定钙、磷元素原子比n/n约为1.61∶1,与HA和人骨中的钙磷原子比很接近;通过对沉积机理的分析,认为微孔钛的活性表面和SBF溶液过饱和离子浓度的环境造成了液相中钙磷盐的沉积。
-
The result showed that the TiO_2 surface was changed after coating , and the property of surface variated from hydrophile to hydrophobic.
结果表明,钛白粉经过表面处理之后,表面性质发生变化,由亲水性转为亲油性。对已包覆无机物的钛白粉,偶联剂A和偶联剂B分别添加2%和3%时,相对效果最佳。
-
In this article, in allusion to the contamination of coating wastewater of automobile manufacturing which contains resin, surface active agent, heavy metal ion, oil, paint, dyestuff etc, especially the ELPO wastewater and painting wastewater which is complex, and has high concentration. we use separated pre-treatment, coagulating sedimentation, air flotation and sand filtration to treat coating wastewater and obtains good results: the removal rate of CODCr could be higher than 80%.
摘 要:本文针对汽车涂装废水中含有树脂、表面活性剂、重金属离子,Oil、颜料等污染物,特别是其中的电泳废水、喷漆废水成份复杂,浓度高,可生化性差的实际情况,采用分质处理、混凝沉淀、混凝气浮、砂滤等工艺对涂装废水进行处理,取得了良好效果:CODCr去除率大于80%。
- 推荐网络例句
-
It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.
从鲍尔点的形成原理出发,分析对称连杆曲线上鲍尔点的产生条件,提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。
-
The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.
集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品,年生产总值3000万美元,产品价廉物美、选料上乘、质量保证,深受国内外客户的青睐
-
The eˉtiology of hemospermia is complicate,but almost of hemospermia are benign.
血精的原因很,以良性病变为主。