查询词典 superimposed load

Results: Before the fixed bridge was applied, under vertical load, the high-stress region was near around the apical of periodontal ligament with mainly compressive stresses. Under oblique load, the high-stress region was near around the cervical of periodontal ligament with both tensile and compressive stresses. After the fixed prosthodontics, stress and strain distributions were similar with that when the fixed bridge was not applied. But the maximum stress, strain and displacement increased apparently. The stresses in exterior surface of periodontal ligament were larger than that of interior surface; this character of periodontal ligament under vertical load was more obvious than that under oblique load.

结果：固定桥修复前，垂直载荷下，基牙牙周膜的应力以压应力为主，应力集中在根尖；斜向载荷下，基牙牙周膜的应力主要是拉应力和压应力，应力集中在唇、舌颈缘；固定桥修复后，基牙牙周膜的应力和应变分布规律与修复前相似，但最大应力、应变值都明显增大；牙周膜内表面的应力大于牙周膜外表面；垂直载荷时，牙周膜内、外表面的应力差异更为显著。

The paper summarizes theories and practices concerning data mining at the beginning. According to actual conditions of data forecasting, the paper particularizes two basic tasks in data mining, namely, exploring data analysis and forecasting modeling for classification, and employs them in load forecasting practically. Then a special short-term load-forecasting arithmetic is forwarded based on the former work, which can efficiently take into account weather effects on the load, and hence improve the accuracy of load forecasting.

本文概述了数据挖掘技术的有关内容；并针对负荷预测的实际情况，详细介绍了数据挖掘中的两个基本任务：探索性数据分析和用于分类的预测建模，并将其运用于负荷预测之中；根据所得结果提出了一种基于数据挖掘的短期负荷预测算法，该算法能够有效的考虑气象因素对负荷的影响，从而提高了负荷预测的精度。

Note: Proof load is 2 times the working load limit, breaking load is 6 times the working load limit.

注释：最大验证负荷为2倍工作极限负荷，最小破断负荷为6倍工作极限负荷。

Fault current greater than the breaking load switching capacity, must ensure that fuse load switch can be dissolved up the rear sub-gates; when the fault current is less than the breaking load switching capacity, ensure the sub-gate and fuse load switch does not move.

故障电流大于负荷开关的开断能力时，必须保证熔断器溶断后负荷开关才能分闸；当故障电流小于负荷开关的开断能力时，保证负荷开关分闸而熔断器不动作。

Two situations are evaluated: In the first one, the load is a typical rectifier load with high crest factor, while, in the second one, this load is in parallel with a resistive load.

在两种情况下的评估：在第1 ，负荷是一个典型的整流负荷与高波峰因数，而在第二个1 ，这个包袱是在同向平行电阻负载。

C. Load Modelling and Allocation Function The load modelling and allocation function adjusts the load values at network load points to match the actual measuredloads recorded at the feeder head of the feeding substation.

C。 负荷 Modelling 和配置功能负荷 modelling 和配置功能调整负荷价值在网络负荷指出相配在逐渐强烈的分局饲养者头被记录的真实 measuredloads 。

Load resistance can adjust the size of load resistance by adjusting the tightness of friction belt of the tensioning adjustment device,Load resistance value can display directly through the load device.

套在阻力轮上的摩擦带与阻力轮产生摩擦形成负荷阻力，负荷阻力可以通过张紧调节装置调节摩擦带的松紧度来调节负荷阻力的大小，负荷阻力值又可以通过负荷指示装置显示出来。

The results of its 1D test demonstrate that the MARED code is suitable for simulating implosions on different devices and with a wide range of load parameters. Combination of the wire-array Z-pinch experiment simulation and analysis shows that under the same load conditions, the X-ray radiation power produced by the tungsten wire-array implosion is much greater than the power generated by the aluminum wire array. With the same load current, the greater load mass gains the lower X-ray power.

结合丝阵Z箍缩实验的数值模拟和分析表明：相同负载质量条件下，钨丝阵内爆产生的X光辐射功率远大于铝丝阵产生的X光功率；相同负载电流条件下，负载质量越大，计算得到X光功率越低；X光功率随着负载电流增加而增加。

For the condition where both outlet states of cold plate are at superheated states, the mass flowrate for the fixed heating load is marginally higher than that of the smaller heating load, and the difference is insensitive to the rise of heating load. For this situation, the effect of accelerational pressure is negligible, and it is mainly attributed to two-phase/single-phase distribution pertaining to the effect of heating load.

若两冷板的出口均为过热状态下，固定热负载一端的流量会略多於施加瓦数较高的一端，且其差异量会随热负载不同而缓慢增加，在此一状况下，则加速度压降可以忽略不计，其原因在於单相／两相流在热负载下单相区与两相区所占的比重不同所致。

First, CLBAC, a central load balance mechanism based on AC is proposed in this paper to increase security. Second, a distributed load balance mechanism is proposed. In DLB, each user can pre-estimate the actual load of each cell by means of virtual distributed coordination function, and then access the cell whose load is the lightest.

本文首先提出基于接入控制器的集中式负载均衡策略以提高网络安全性，然后提出分布式负载均衡策略：各用户在接入网络的时侯，首先采用虚拟的分布式协调功能预测各小区的实时负载，然后接入负载最轻的小区。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"