查询词典 sulfur chloride

A novel fluorescent acrylamide monomer, N-(4-Benzooxazol-2-yl-phenyl)- acrylamide, was prepared from o-aminophenol, p-aminobenzoic acid and acryloyl chloride, with polyphosphoric acid as dehydrating agent and triethylamine as deacidification agent.

以邻氨基苯酚、对氨基苯甲酸和丙烯酰氯为原料，以多聚磷酸为脱水剂、三乙胺为脱酸剂，研制了一种新的荧光丙烯酰胺单体N-[4-（苯并噁唑-2-）苯基]丙烯酰胺。

The experiment results indicate that the best preparation condition is the sodium silicate concentration of 0.97 mol/L, the molar ratio of Al/Fe of 2:1~4:1, and the molar ratio of SiO2/ of 2:(2+1) at 30~40℃ for 20~30 min with activation pH of 5.0~6.0. At pH of 6~11, polysilicate aluminum ferrite chloride has the best flocculation performance.

研究结果表明：当硅酸钠浓度为0.97mol/L，Si/为2：(2+1)、Al/Fe为2：1~4：1时，熟化温度30~40℃、pH为5~6、熟化时间20~30min的条件下，制备的聚硅酸氯化铝铁对于pH为6~11的生活污水的混凝处理效果最佳。

In order to match the requirements of water treatment engineering, considerable attention was paid to develop composite inorganic polymer flocculants during recent years, which are represented by polyaluminum silicate chloride, polysilicate ferrite and polysilicate ferric aluminum.

受水处理工程需要的牵引，以聚硅氯化铝、聚硅酸铁及聚硅酸铁铝为代表的三大类新型复合无机高分子絮凝剂的开发研制及应用研究近年来受到格外的关注，取得了不少新成果。

A preparation method of polysilicate polyferric chloride flocculant by leaching ferric tailings with hydrochloric acid pickling wastewater ,was studied,and the reasonable preparation craft and technological conditions were determined.

研究了以盐酸酸洗废液分解铁尾矿制备聚硅酸聚氯化铁复合絮凝剂的方法，确定了合理的制备工艺和工艺条件。

Polysilicate aluminum chloride flocculants of various molar ratio of Al to Si are prepared. The influence of ingredient molar ratio, pH value of waste water and the adding amount of flocculant is investigated in treating simulant rolling emulsion.

制备了不同Al/Si摩尔比的聚硅氯化铝，实验考察了成分摩尔比、废水pH值、药剂投加量对除油效果的影响。

Wastewater treatment by modified polysilicic aluminum chloride.

结果表明，最佳制备条件为：pH值5~6，SiO2浓度2.5%，温度20~30℃，Al/Si摩尔比1.0。

By using the hydrochloric acid pickling wastewater and scrap iron asraw materials ,the polysilicic acid - polyferric chloride flocculant isprepared under different conditions.

以盐酸酸洗废液和废铁屑为原料，制备了聚硅酸聚合氯化铁复合型絮凝剂，研究了聚铁中铁浓度、聚合硅酸浓度、聚合硅酸pH值、n∶n及复合熟化时间等因素对絮凝性能的影响。

Polypropylene plastic board ripple or polyvinylidene fluoride; polyvinyl chloride and other board material, and metal plate packing structure similar to, in order to enhance the mass transfer efficiency, the board may be openings .

塑料板波纹填料用聚丙烯或聚偏氟乙烯；聚氯乙烯等板材料制成，与金属板波纹填料结构相似，为提高传质效率，板上可开孔。

Colored concrete C30 was used in the exterior eaves and part of the inner eaves of a new embassy with floor area of 30,000m^2, the first domestic project that widely adopts colored concrete, The raw materials were white Portland cement, waterreductive colored powder of non-calcium chloride, flying ash, mixed active pozzuolana mineral and fiber.

某新建使馆工程建筑面积3万m^2，其外檐和部分内檐采用C30彩色建筑混凝土，为国内首次大面积设汁采用彩色混凝土的工程。原材料采用白色硅酸盐水泥、不含氯化钙且具减水作用的彩色粉、粉煤灰、火山灰活性矿物掺合料、纤维等，经反复试验后确定水灰比为0.41。

The average removal efficiency of TP and COD was 28.76% and 8% after cloth media filter without coagulation, and TP removal was influenced by the influent water quality. However, precoagulation with coagulants of ferric chloride, PAFC, PAC, the average removal efficiency of TP was 63.58%, 60.13% and 66.94% respectively, and no influence of TP removal can be found by the influent water quality. The average removal efficiency of COD was of 17.7%,26.3% and 27.7%,SS was 70.7%,64.3% and 49.1%.

当不投加混凝剂时，滤布滤池对TP和COD的平均去除率为28.76%和8%，其中TP的去除效果受进水水质影响较大；当投加氯化铁、聚合氯化铝铁与聚合氯化铝强化滤布滤池时，滤布滤池对TP的平均去除率分别为63.58%、60.13%和66.94%，TP去除效果受进水水质影响较小；对SS的平均去除率分别为70.7%、64.3%和49.1%；对COD平均去除率分别为17.7%、26.3%和27.7%。

The Porsche Owner: But it's my car!

可，这是我的车呀。

LOX_83}{Oh, another bunch of wackos.

{LOX_83}{呃，又一群怪人。