查询词典 suction chamber

When gear-driven, the suction chamber side gear teeth withdraw mutually place the space between teeth volume increases gradually, pressure drop, the liquid enters the space between teeth under the differential pressure function.

齿轮转动时，吸入腔侧轮齿相互脱开处的齿间容积逐渐增大，压力降低，液体在压差作用下进入齿间。

The suction chamber with discharges the cavity is gnaws the vanishing line depending on two gears to separate.

吸入腔与排出腔是靠两个齿轮的啮合线来隔开的。

It is for an idealshape suction chamber of campaniform inlet duct.

是钟形进水流道理想的吸水室形状。

In combination with the design of campaniform inlet duct in a certain pumping station of the East Line of South-to-North Water Transfer Project, three different shape suction chamber hydraulic models arid experimet apparatus were designed for testing on hydraulic loss.

结合南水北调东线某泵站钟形进水流道的设计，设计和制作了3种不同形状吸水室模型流道并进行水工试验，测试了流道水力损失。

To study on the turbulent flow in a centrifugal pump with vaned diffusers, based on CFD method, three-dimensional turbulent flow field in suction chamber, impeller and diversion shell was calculated at three different operating conditions, and the velocity and pressure distribution in diversion shell were obtained.

以带有空间导叶的离心泵为研究对象，通过CFD方法，在三种工况下，对包括吸入室、叶轮和导流壳在内的全三维湍流场进行数值计算，获得了导流壳内的速度分布和压力分布。

The outlet of the introduction passage is located closer to the valve plate than to the wall of the suction chamber.

导入通道出口与阀片的距离比与吸入腔壁的距离小。

As the rotor continues to rotate, suction chamber volume increases, this part of the gas will be the second expansion.

随着转子的继续转动，吸气腔容积的增大，这部分气体将进行第二次膨胀。

Projection on end of suction chamber.

装上吸入体末端的垫圈(1220)。

The introduction passage extends from a wall of the rear housing across a discharge chamber to a suction chamber.

导入通道从后部外壳的壁穿过排出腔延伸至吸入腔。

Double entry sealing ring is used to reduce the water leakage from pump pressure chamber back to the suction chamber.

双吸密封环用以减少水泵压力室的水漏回吸水室。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。