查询词典 subcutaneous injection

The250gL-1 hydrogel was applied in tissue engineering;4weeks after injection,the hard nubble was formed subcutaneously and immatural cartilage was observed.8weeks after injection matural catilage was observed.12weeks after injection the amount of matural cartilage increased.

此水凝胶用于软骨组织工程，注射后4wk在皮下形成稍硬的结节。8wk后形成的结节质地坚韧，切面色泽亮白。

objective to investigate the paregoric effects of butorphanol when the errhysis occurs inside the epidural catheter during continuous epidural anesthesia.methods 60 cases of kidney stones received elective surgery.during this surgery they underwent continuous epidural anesthesia and eight cases of them showed the errhysis in the epidural catheter.then epidural injection of butorphanol was given for analgesia and hr,map,spo2 as well as muscle relaxation conditions were monitored before and 5,10,20 min after injection.the conscious and breathing of patients were also monitored.results before and 5,10,20 min after injection of butorphanol,hr and map difference were not statistically significant.the analgesic results were satisfactory.conclusion butorphanol has a definite analgesic effect when the errhysis occurs in epidural catheter during continuous epidural anesthesia.

目的 探讨在连续硬膜外麻醉中，硬膜外导管内渗血时，应用布托啡诺镇痛的效果。方法择期行肾结石手术患者60例，行连续硬膜外麻醉，其中8例硬膜外导管内渗血，均经硬膜外腔注入布托啡诺镇痛，分别监测注入前及注入后5 、10 、20 min，hr、map、spo2及肌肉松驰情况，同时监测患者神志及呼吸情况。结果注射布托啡诺前及注射后5、10、20 min，hr、map差异无统计学意义，镇痛效果满意。结论在连续硬膜外麻醉中硬膜外导管渗血时，注入布托啡诺维持麻醉镇痛效果明确。

ABSTRACT: This design elaborated the patch cord plank outer covering plastic parts injection mold design process, including the cavity quantity and deciding the arrangement of the cavity, selecting the machine for injection, the feed system design, choosing the molding boards and their standardized parts, design core-pulling outfit and formed accessories and so on, the basically design flow and the process of injection-mold design based on Pro/E was illustrated.

摘 要：本次设计阐述了插线板外壳塑料零件的注射模设计过程，包括型腔数量和布局的确定、注射机选择、浇注系统设计、模板及标准件的选用、脱模及抽芯机构的设计、成型零件的设计等，阐述了采用Pro/E进行注塑模具设计的基本流程以及模具各部分结构的设计过程。

Arrangements for nurses to doctors injected patients with Amiodarone Hydrochloride Injection, and asked the nurses to slowly push, push 10 minutes. At 2:05 on March 17, 2008 to start a nurse to push the old lady Wang drugs, there are other patients at this time called the nurses, so the nurse put down the syringe and left, followed by another injection of nurses to continue to pick up the syringe, the two nurses liquid injection time after a total of five minutes.

医生安排护士给患者注射盐酸胺碘酮注射液，并嘱咐护士要慢推，推十分钟。2008年3月17日凌晨两点零五分一名护士开始给王老太太推药，此时有其他患者叫护士，于是该护士放下注射器离去，随后另外一个护士拿起注射器继续注射，两名护士注射完液体时间共计五分钟。

For the principal component, namely the voltage stability analysis function, three kinds of nodal injection power modes are defined, i.e., the random varying direction of load, the response setting direction of generator and the ratio of active power component to reactive power component in load power, and a continuous power flow model that is easy to utilize and comprehend by dispatching center is built, based on this model three kinds of formulae to calculate the sensitivities of loading margin with respect to three kinds of nodal injection power modes are derived respectively, and on this basis the influence of nodal injection power mode on loading margin can be analyzed in order that the voltage collapse can be avoided by fast implementing early warning of voltage stability and adopting effective corrective control.

文章针对N-EMS的主要组成部分--电压稳定分析功能，定义了3类节点注入功率模式：负荷的随机变化方向、发电机的响应设定方向、负荷的有功和无功比例，建立了易于被调度中心运用和理解的连续潮流模型，在此模型基础上分别推导得到负荷裕度对3类模式的灵敏度公式，据此分析节点注入功率模式对负荷裕度的影响，以便能够快速进行电压稳定预警和采取有效的校正控制来避免电压崩溃。

The investigation has declared that the fuel injection with BQ fuel pump had higher injection pressure, bigger fuel supply rate and shouter fuel supply duration, which would cause the fuel injection quantity and the fule-air mixture to increase during ignition delay period, the pre-mixed combustion to become acutely, and finally result in increased power levels of noise.

研究表明，装配BQ喷油泵，喷油系统的喷油压力较高，供油速率较大和供油持续时间缩短，使得滞燃期的喷油量增加，滞燃期内形成的可燃混合较多，预混燃烧剧烈，导致整机噪声声功率级增加。

Blood sample were collected at 2,7 and 14 d post-injection to analysis the blood lymphocyte proliferation; The level of swine plague antibody of 1d pro-injection and 7, 14 d post-injection were test.

注射LPS后的第2、7和14天，采血测定其淋巴细胞转化率：注封上挑前1天、注射LPS后第7天和第14天，测定其猪瘟抗体水平。

Simple Perfect-Harmony-Nucleos-Energy adopts part scraping therapy, with cupping and venesection , combined with point injection, vein injection, urinary blader douche, recta douche and uterus injection, to develop therapy all over human body. It has unique therapy, all-around and quick effect ; one therapy combined by four ways without any operation and chemical therapy, can cure cancer thoroughly.

简单的核谐疗法，它是采用局部刮痧诊疗，进行拔罐配以刺络放血，再结合穴位注射、静脉注射、膀胱罐注、直肠罐注、子宫注射，从而开展人体全方位治疗的方法，疗法独特、功效全面、见效快；它不用施行任何的开刀手术、不用放化疗的四位一体疗法，就可以根治肿瘤癌症。

Objective To compare the therapeutic effects of asarone injection by aerosol inhalation and intravenous drip in the treatment of bronchiolitis.Methods 53 cases of bronchiolitis in children were treated with asarone injection by aerosol inhalation ,and 47 cases treated with asarone injection by intravenous drip severed as control.

目的 比较细辛脑注射液雾化吸入与静脉滴注治疗毛细支气管炎疗效方法采用细辛脑注射液雾化吸入治疗53 例毛细支气管炎的患儿，并且与该药静脉滴注治疗组47例相比较。

METHODS:We recorded the cardiogram by perfusing garlicin injection and garlic preparation to the isolated heart of rabbits by Langendorff method,examined the minimum dose of asystole. RESULTS:The minimum fungistatic concentration of garlicin injection was 3～6.2 times lower than that of garlic preparation. The minimum dose of garlic preparation is 0.1736 u/ml, and that of garlicin injection is 3.919 u/ml.

采用Langendorff法对兔离体心脏分别灌流大蒜素注射液、大蒜注射液、大蒜实验液，分别记录心搏图，求出致心脏停搏的最小剂量，结果：大蒜素注射液的抑菌浓度为大蒜实验液的1/6.2～1/3，而致心脏停搏的最小浓度分别为0.1736 u/ml和3.919 u/ml。

You can snipe the second and third union leaders from this position.

您可以鹬第二和第三工会领袖从这一立场出发。

Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.

针对当前XML数据流质量检测存在的不足，提出构建XML键的矢量矩阵作为窗口，利用矢量积小波变换多级分解与重构XML数据流，再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法，满足XML数据流质量重构时实时检测的要求，保证XML数据的约束性、一致性与完整性；为了更好的适应网络负载，采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。