查询词典 subcutaneous injection

This company mainly produces: Conductive materials, anti-static masterbatch, PP, PE, PS, PC, ABS; main target customers are, and anti-static conductive PP injection molding, hollow boards, turnover boxes, sheet: PE film blowing, blow molding , blowpipe, EPE; PS sheet, injection molding: ABS sheet, injection molding; PC extrusion, injection molding.

本公司主要生产：导电原料、防静电母料、 PP 、 PE 、 PS 、 PC 、 ABS ；主要针对的客户是导电及防静电 PP 注塑、中空板、周转箱、片材： PE 吹膜、吹塑、吹管、珍珠棉； PS 片材、注塑： ABS 片材、注塑； PC 押出、注塑。

The notable proliferation was not observed by eyes in the local of injection. The infiltration of inflammation cells and mild proliferation of fibrocyte around dura mater was observed by HE stained in 4 and 8 weeks after injection. Infiltration and exudation of inflammation cells was observed by HE stained in epidural nerve root. Compared with group A, no changes of group B, C and D were observed under specific stained. Proliferation of type Ⅱ collagen fibers around dura mater was seen under immunohistochemical stained in 4 and 8 weeks after injection. There is no significant demyelination changes under LFB stained. The thickness and shape of the myelin sheath in epidural nerve root was not regular under transmission electronic microscopy in 4 and 8 weeks after injection. Fibroblast was also seen there. In nerve endometrium, macrophage could be seen under TEM, myelinated nerve fiber changed significantly, but nonmyelinated nerve fiber changed mildly. When 8 weeks, the changes of group D is smaller than the group B and C.

给药局部肉眼观察未见明显的纤维组织增生；HE染色可见B、C、D三组给药后四周及八周时硬膜内外均有炎细胞浸润，纤维细胞轻度增生，硬膜外神经根内有炎细胞浸润及炎性渗出；特殊染色B、C、D三组同A组相比未见有脊髓及神经根的改变；免疫组化染色，给药后四周及八周时，硬膜内外均有Ⅱ型胶原纤维增生；固兰染色B、C、D三组未见有明显脱髓鞘改变，与A组相比无明显异常改变；电镜观察B、C、D三组在给药后的四周及八周时，表现为硬膜外神经根内髓鞘厚薄不一，形状不规则，可见成纤维细胞，神经内膜中可见有巨噬细胞；粗大的有髓神经纤维变化明显，无髓神经纤维受累较轻；八周时电镜下D组改变较B、C两组为轻。

In order to control effectively the appearance of casing damage well, the author suggests that the injection to production ratio and injection pressure should be controlled by infilling adjustment, cycle water injection and decreasing injection rate.

建议通过加密调整、周期注水和降低注水量等方法，控制注采比和注水压力，从而达到抑制套损井的产生的目的。

Following the puncture of zona pellucida with two holes by injection pipette that contained donor nuclei or cells, the injection pipette was pulled back to the perivitelline space while the negative pressure was increased in the holding pipette until the polar body and karyoplasm were wiped off completely. Then a reconstructed embryo was completed by the direct injection of the donor nucleus or cell without pulling out the injection pipette.

首先以预先吸有细胞核或细胞的注射针在固定于持卵针上的卵母细胞透明带上穿刺两个孔，然后一边缓慢地将注射针回拔至卵周隙中，一边逐渐增加持卵针中的负压，直至极体与目标核质被完整吸入持卵针中而完成去核，最后在不拔出注射针的情况下直接注射细胞核或完整细胞进而完成重构胚的构建。

An injection mechanism for an injection molding machine, including a front plate carrying an injection cylinder; a guide rod arranged fixedly relative to the front plate and having a longitudinal guiding axis; a movable plate arranged movably relative to the front plate along the guiding axis and carrying an injection screw; and a rear plate arranged at a location opposite to the front plate with the movable plate disposed therebetween.

一用于注射成型机的注射机构，包括：一支承压射缸的前板；一相对于所述前板固定布置并限定出一纵向导轴的导杆；一沿所述导轴相对于前板可动布置并支承注射螺杆的可动板；一布置在与所述前板相对位置上的后板，可动板布置在它们之间。

According to Pharmacopoeia of the Peoples Republic of China and the relevant technical provisions of TCM, natural medicine, injection intermediates were tested by quality and safety tests. The results of acute toxicity test, local muscle stimulation test, sensitivity test, hemolysis test proved the injection of polysaccharide extracted from ABM was safe and can be used via intramuscular injection and intravenous injection.

在上述研究的基础上对姬松茸多糖注射液的生产工艺进行了设计，初步制得注射液成品，根据《中华人民共和国药典》和《中药、天然药物相关的技术指导原则》对注射液的中间体进行质量安全性试验：急性毒性试验、肌肉局部刺激试验、过敏试验和溶血试验，试验结果均符合相关规定，表明姬松茸多糖注射液可以用于肌肉注射和静脉注射，无毒副作用，不会产生不良后果。

For the injection unit hanged on the fixed mould, the injection force can be act on the mould directly featuring obviation of the trasmit segment of injection force, shortening the injection unit length and reducing the vibration during the work.

压射系统由两活塞杆悬挂在定模上，将压力直接作用在模具上，避免压射力传递环节，缩短压射系统的长度，减少其工作时的震动。

Intravoneous injection of 0.5mg/kgBW jingsongling cause the 60 minutesrelaxation of goat gastric motor.The effects of jingsongling on the gastric motor ofgoat is major of effects of α2 -adrenoceptor agonist,as well as that of α1 -adrenoceptor agonist,the effects of α1 -adrenoceptor agonist concentrate at thecardic and pylorus;the function of α2 -adrenoceptor exit widely at cardic,pylorus,rumen,reticulum,omasum and abomasum,the function at different part is not the same.The lowestdose of jingsonglinginhibiting the amplitude and frequency of the gastricmyoelectric is 0.01mg/kgBW;the influence of jingsonglingto the gastricmotility of goat is dose-dependent,and the amplitude regain after the frequency ofgastric myoelectriv wave.When the goat revived,the gastric motor function is notreach the level of the normal;the major reason ofjingsongling cause the goat gastricrelaxation is the amplitude renew slowly.The intravoneous injection ofjingsonglingfirst,after 5 minutes,intravoneous injection the antagonist,the effect of prazosin and idazoxan mixed is best,which can fast reversal of theinhibition of jingsongling on the gastric motor of goat,the effects of idazoxan isgood,and the prazosin block the effection of jingsongling is better than that ofxylazine,especially at cardia and pylorus.When intravoneous injection of0.5mg/kgBW idazoxan and/or prazosin only,the amplitude of gastric myoelectric ingoat increases at a certain degree,but the frequency is not changed.

静脉注射0.5mk/kgBW的静松灵引起山羊胃蠕动弛缓长达60分钟；静脉注射0.5mg/kgBW的静松灵对山羊胃蠕动机能的影响是以α2肾上腺素受体作用为主的，兼有α1肾上腺素受体的作用，而且静松灵的α1肾上腺素受体的作用主要集中在幽门和贲门；α2肾上腺素受体的作用广泛存在于贲门、瘤胃、网胃、瓣胃、皱胃和幽门中，不同部位间有功能上的差异；静注0.01mg/kgBW的静松灵是对山羊的贲门、瘤胃、网胃、瓣胃、皱胃和幽门的肌电波频率和振幅均产生影响的最低剂量；静注一定剂量的静松灵对山羊胃蠕动的抑制作用与剂量呈相关性；而且山羊胃肌电波振幅的恢复比肌电波频率的恢复慢；苏醒时山羊的胃蠕动机能尚未恢复到正常状态；静松灵引起山羊胃弛缓的主要原因是由于胃肌电波的振幅恢复慢；静注0.5mg/kgBW的静松灵，5分钟后静注0.5mg/kgBW的拮抗剂时，咪唑克生+哌唑嗪的作用最好，能迅速地逆转静松灵对山羊胃蠕动的抑制作用，咪唑克生也有很强的拮抗作用，而哌唑嗪对静松灵的拮抗效果好于对隆朋的拮抗；单独静注0.5mg/kgBW的咪唑克生和/或哌唑嗪时，山羊的瘤胃、网胃、瓣胃、皱胃、贲门和幽门的肌电波振幅有一定程度的增强，而肌电波频率未见变化。

Through the trial regression to the ratio of unit injection well control area,unit well control area and injection-production well number ratio and shirr formula and unit injection well volume rate of change increasing with unit injection well control area decreasing,then Waterflooding reservoir macroscopica well spacing density formula c.

油藏工程理论及现场实践均表明，注水开发低渗油藏其注水方式和注采井数比对注水波及体积及水驱采收率有较大影响，通过对注水井水驱控制面积、单井控制面积与注采井数比进行了试探性回归分析，再结合谢尔卡乔夫公式，推导出了水驱采收率、驱油效率、井网指数、注采井数比与井网密度的关系式，从而建立了水驱油藏宏观井网密度公式。

This technology has its own character. Some technologies, such as inside vat injection, outside vat injection, spiccato injection, continuum injection, etc, which have different influence on motorcycle, have different characters. Take the Honda GL1200 motorcycle for a case, we can learn about the system.

传统的化油器供油系统虽然在机械设计结构等多方面得到了改进和完善，但随着现代摩托车发动机性能的提高，暴露出化油器的缺点，不能满足发动机的要求。

You can snipe the second and third union leaders from this position.

您可以鹬第二和第三工会领袖从这一立场出发。

Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.

针对当前XML数据流质量检测存在的不足，提出构建XML键的矢量矩阵作为窗口，利用矢量积小波变换多级分解与重构XML数据流，再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法，满足XML数据流质量重构时实时检测的要求，保证XML数据的约束性、一致性与完整性；为了更好的适应网络负载，采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。