查询词典 subcutaneous injection
- 与 subcutaneous injection 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
RESULTS:①MRI scanning from coronal section: after 10 mL contrast-medium injection, in the center of medial knee joint, high visual signal was seen in the cavity of joint; after 15 mL contrast-medium injection, scanning between femora and patella, high visual signals were observed; after 20 mL contrast-medium injection, scanning by posterior internal and external condyle of knee, high visual signals were found in 80% of internal and external recess of posterosuperior of thighbone.
结果:①在膝关节冠状面MRI扫描:注入10 mL对比剂时,经膝关节内侧中点处,关节腔内均可见高信号;注入15 mL对比剂时,经股骨和髌骨间,关节腔内均可见高信号;20 mL对比剂时,经股骨内、外侧髁后缘处,80%股骨后上内、外侧隐窝内出现高信号。
-
a three steps sequence therapy was designed for patients suffered post dural puncture headache total 45 cases:step one,patient keep supine recumbence,and intravenous injection of ringer's solution 1000ml with intramuscular injection of tramadol 100mg was administrated. if pdph could not relieve within 24hr,the next step should be use. step two,drinking a cup of coffee three times a day for patients who were allowed to eating or intravenous injection ketamine 0.5mg/kg for patient in fasting diet.
选择椎管内麻醉后发生头痛的病例共45例,按设定的序贯疗法分别为a:去枕平卧1d,每天补液量增加1000ml平衡液,肌注曲马多100mg,无效时进入b和c;b:能进食者给予市售咖啡饮品,每天三次;c:不能进食者静脉注射氯胺酮0.5mg/kg,连用2d;以上治疗无效时进入d:行硬膜外填充自体血10ml。
-
In order to obtain the injection samarium cobaltmagnets with high performance, high injection temperature, mould temperate andquickly injection speed must be needed.
为了获得性能较高的注射成型钐钴磁体,需要较高的取向磁场,较高的注塑温度和注塑压力。
-
Methods Thirty-six Wistar rats were randomly divided into four groups: group Ⅰ received intraperitoneal injection of L-thyroxine for 42 days to establish a model of thyrotoxic myopathy; group Ⅱ was treated with XYQJT for 30 days after L-thyroxine intraperitoneal injection; group Ⅲ was given normal saline for 30 days after L-thyroxine intraperitoneal injection as control; group IV served as normal control group.
方法36只健康雌性Wistar大鼠随机分为4组:甲亢肌病模型组10只,腹腔注射甲状腺激素钠盐每天1次,共42d;中药治疗组10只,腹腔注射甲状腺激素钠盐42d后,灌服消瘿强肌汤30d;生理盐水对照组10只,腹腔注射甲状腺激素钠盐42d后,灌服生理盐水30d。
-
Results: pcDNA3.1+/TSP-1-Ⅰ veinal injection has stronger TSP-ltype Ⅰ repeat band than that of directly injection into myocardium (P<0.05), while veinal injection of pcDNA3.1-/anti-TSP-1-Ⅰ has a slightly weak TSP-1 typeⅠ repeat band (P<0.05), Western blot obtained the same result.
成功构建pcDNA3.1+/TSP-1-Ⅰ、pcDNA3.1-/anti-TSP-1-Ⅰ。作为血管新生抑制基因,在体外,TSP-1Ⅰ型重复序列基因编码的TSP-1Ⅰ型重复序列多肽,能够抑制ECV304细胞生长和增殖,其抑制机制与TSP-1Ⅰ型重复序列诱导ECV304细胞凋亡相关。
-
Squalene/Arlacel A(4:1)–MDP was used as adjuvant. First injection with 500 ug antigen was given to each animal, and three injection once two weeks with 250 ug antigen were followed. Serum Anti-ZP antibody response was evaluated by ELISA once two weeks. In eighth week after first injection, all female monkeys were encaged wi
在高等灵长类动物免疫研究证明去糖基卵透明带抗原免疫能产生抗生育作用,但不会引起卵巢功能紊乱等不良反应,糖基是导致免疫动物卵巢功能紊乱成分,为选择卵透明带抗原,用重组基因技术发展卵透明带避孕疫苗提供依据。
-
Next, regarding question two, because present uses the injection contraceptive the method to maintain this population the stability, moreover already did not have the individual to move away or the situation which poaches, for this reason we transform this populations stability to ask this population every years newborn baby quantity to subtract this year death individual the quantity differential value; Moreover from this population year quantity with this year the end of the years quantity differential value, when tends 0, namely thought that this community individual quantity is stable, thus the question stability problem transforms to ask simple targets optimization problems model building; Carries on using MATLAB to the model obtains, obtains, when did not consider when uncertainty factor influence must inject the medicine female animal quantity is 276 heads, but when had considered after twin and by duplicate injection these two uncertainty factor influence, obtains must inject the medicine female animal quantity is 352 heads, including 110 are by the duplicate injection.
其次,对于问题二由于现在采用注射避孕药的方法来维持该种群的稳定,而且已经没有个体被运走或被偷猎的情况,为此我们把该种群的稳定性转化为求该种群每年的新生幼仔的数量减去该年死亡个体的数量的差值;另外从该种群年头的数量与该年年底的数量的差值,当趋于0时,即认为该群落的个体数量是稳定的,从而把问题的稳定性问题转化为求单目标的最优化问题建立模型;利用MATLAB对模型进行求得,得出当不考虑不确定性因素影响时要注射药物的雌性动物数量为276头,而当考虑了双胞胎和被重复注射这两个不确定性因素影响后,得到要注射药物的雌性动物数量为352头,其中有110头是被重复注射的。
-
The contents of solid particles of the produced water are higher than those of the injection water obviously, which shows the destroying effect of the injection water on formations is mainly washing action currently and the injection water has a strong washing and schlepping effect on clay mineral.
在井眼扩大机理方面,对油田采出水和注入水的化学组成进行了分析和对比,根据离子浓度、固相含量的变化判断注入水对胶结物的破坏方式,并应用X射线衍射技术进一步探究胶结物的变化状况。
-
The aim to force analysis of high pressure water injection string is to research various effects exerted on water injection string in different phases according to water injection conditions, and how such effects influence string loads and deformations to identify siring working states and ensure string to he efficient and reasonable situations.
进行高压注水管柱受力分析的目的就是根据注水条件研究注水管柱在不同过程中的各类效应,以及这些效应对管柱产生的受力和变形规律,从而明确注水管柱的工作状态,保障注水管柱有效合理地工作。
-
In the high efficiency oil removal technology aspect, the theory study and application experiment of air sparged liquid-liquid hydrocyclone was carried out, enlightened by the air sparged solid-liquid hydrocyclone. Firstly, the strength and movement of dispersed phase was analyzed in theory, it was proved that the air bubble-oil drop polymer trend to move to the axes of hydrocyclone. Secondly, using CFD method, the characteristics of oil-air-water flow field were studied, including velocity distribution, pressure distribution, turbulent motion energy and its dissipation distribution. The characteristics and separation effect under different air injection methods were simulated. Thirdly, the separation ex-periment of air sparged liquid-liquid hydrocyclone was carried out at Lab. The major structure parameters of the hydrocyclone were optimized, the reasonable air injection method and performance parameters were determined through 4 groups of air injection experiments.
首先,对气携旋流场中分散相粒子的受力及运动进行了理论分析,证明了气泡与油滴形成的聚合体,更易于向轴心运动;其次,应用CFD方法,研究了油-气-水三相流场的速度分布、压力分布、湍动能及其耗散率分布特性,对不同注气方式的流场特性及分离效果进行了数值模拟;第三,开展了气携液-液旋流分离特性室内研究,优化了旋流器的主要结构参数,对四种注气方式的分离效率进行了对比,确定了合理的注气方式和操作参数;最后,在油田现场开展了处理聚驱采出污水工艺试验,确定了工艺运行参数,评价了处理效果。
- 相关中文对照歌词
- Lethal Injection
- Injection Of You
- Keep On Bringing Me Down
- Burn The Earth
- Do You Like My New Car?
- In My Veins
- Love Resurrection
- Dead On Arrival
- Ouest Side
- One Four Five
- 推荐网络例句
-
You can snipe the second and third union leaders from this position.
您可以鹬第二和第三工会领袖从这一立场出发。
-
Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.
针对当前XML数据流质量检测存在的不足,提出构建XML键的矢量矩阵作为窗口,利用矢量积小波变换多级分解与重构XML数据流,再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法,满足XML数据流质量重构时实时检测的要求,保证XML数据的约束性、一致性与完整性;为了更好的适应网络负载,采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。
-
This is a very big challenge to developers especially that Ajax is constantly changing.
这对开发者来说是一个非常大的挑战,尤其是需要不断变化的Ajax。