查询词典 sub-heading

Methods:Methods of scale technique,literature research,expertise consultation et al,based on Chinese medicine theory,via conceptualization of sub health and TCM syndrome,operationalization of sub health and TCM syndrome,come into being items,result,foreword,explain,coding,advance survey,the practical value,recension et al,fashion Questionnaire.

根据问卷设计的原理，结合文献研究和专家咨询等方法，并在中医基础理论指导下，通过亚健康以及亚健康中医基本证候概念的确定、操作化，问题与答案的产生，卷首语、填写说明的确定，问卷编码、预调查、信度、效度检验以及修订等过程，设计调查问卷。

It utilizes the bidirectional recursive relation between sub-pixel values and estimates each sub-pixel value from both directions of head-end and end-head.

根据亚像元递推公式的双向性，分别沿首-末和末-首两个方向各自递推出一组亚像元值，并将它们的平均值作为最终亚像元值。

Conclutions: Under ischemic condition, the decrease of Iks could prolong the mid-late repolarization phase of APD. It could cause EAD and then arouse TdP. Because the decrease of M cell was significantly greater than that of sub-endocardial myocytes and sub-epicardial myocytes, it could increase TDR. Cardiac arrhythmias could last due to reentrance that secondary the increase of TDR.

缺血时，心肌细胞的Iks电流减弱，使得细胞动作电位复极中后期延长，容易出现EAD并引发TdP；由于M细胞的Iks电流减弱程度明显大于心内、外膜细胞，造成心室跨壁复极离散度增加，有利于折返的发生，使得心律失常得以持续。

The shaker includes a dual mass flywheel and the rotate and pendulum driven mechanism; in the rotate and pendulum driven mechanism, the rotary cylinder body of the rotatable hydraulic rotary cylinder (8) is connected with the sub flywheel (15) connecting with the main flywheel (13) and a rotary cylinder shaft (4) at the same side through a transmission sleeve (11) connecting to the rotary cylinder right end cover (9); a torsional transducer (10) and a turbulence iron core of an angular sensor (12) are arranged on the sub flywheel shaft, a winding of the angular sensor is positioned on the transmission sleeve fixedly connected with the main flywheel.

该激振器包括双质量飞轮及其旋转和扭摆驱动机构；所述旋转和扭摆驱动机构，其旋转液压摆缸(8)的摆缸体通过与摆缸右端盖(9)相连的传动套(11)，在同侧与主飞轮(13)和与摆缸轴(4)相连的次飞轮(15)相连接；扭矩传感器(10)及摆角传感器(12)的扰流铁芯装在次飞轮的轴上，摆角传感器的线圈装在与主飞轮固连的传动套上。

There may also be a sub-genre within a sub-genre such as vocalese and scat singing in jazz.

而在一种子流派里面也会再包含有子流派，如爵士乐的子流派拟声唱法和音节演唱。

The detail procedure is that induct the control parameter δ and η to get specific 3D scattered points sub sets under in some conditions,then evaluate each scattered points sub set to extract the control points,and build up the boundary which is formed by the control point.

具体的过程，是通过引入控制参数δ和η，将满足相应条件的3D散乱点划分到相应的子集合中，然后对各个散乱点子集合进行判断，提取其各个子集上的控制点，构造各个子集的控制点构成的边界。

The music signal was divided into several sub-sections and the length of each section was equal to the duration of one semiquaver. The base frequency was obtained using one dimension DCT operated on each section. The extreme points of the musical notes were found by comparison with the adjacent sub-sections. And then, the musical scores were got using the principle of least derived notes.

采用离散余弦变换结合能量比对的手段，并提出了一种变化音最少法则：以十六分音符对应的时值作为步长，将乐曲信号分为若干个子段；对每个子段进行一维DCT操作，提取基音频率；对相邻子段进行能量比对，查找音符的端点；利用变化音最少法则，生成乐谱。

A new multiclass SVM algorithm based on binary tree was introduced on E-mail filtering. It could convert multiclass problem to binary classification by constructing binary tree. The idea of clustering first and classification later was adopted, and the largest similarity between testing sample and sub-category center and the separation measure of sub-categories were calculated, in oder to construct the optimal class hyperplane of decision-making nodes.

提出一种基于二叉树的多分类SVM算法用于电子邮件的分类与过滤，通过构建二叉树将多分类转化为二值分类，算法采用先聚类再分类的思想，计算测试样本与子类中心的最大相似度和子类间的分离度，以构造决策节点的最优分类超平面。

The main jobs of this paper are as followed: 1 The reuse of the frame design technology for aircraft assembly fixtures is researched. a frame line part library is built with the templet driven technology, the reuse of the frame line part come true by the tools for instantiation and instance modification. The design resources are effectively used, some repeating work is cut. 2 Two methods to obtain the assembly feature are proposed: the straight way by the Enumeration method and the indirect way by project features to the assembly plane. All of the assembly features of the frame and the adjustable bearings are obtained by these two methods which makes the frame automatic assembly technology for aircraft assembly fixtures come true. 3 The frame automatic assembly technology aircraft assembly fixtures based on assembly features is researched. A binary tree assembly model is used to express the assembly information of the frame for aircraft assembly fixtures, the automatic assembly between the frame, the aircraft and the adjustable bearing is completed within the three steps: distribute, obtain and evaluate assembly feature. Finally, the efficiency of the frame assembly design is proved. 4The frame interpart modeling technology for aircraft assembly fixtures is researched, the intersection methods are concluded and the arithmetic of the single-cut, double-cut and inter-cut intersection is proposed, the interpart fast modeling of the frame design for aircraft assembly fixture come true. 5Based on the researches mentioned before, a sub-system of frame fast design for aircraft assembly fixture is developed on CATIA. The sub-system is used to design the aircraft assembly fixtures in a large aeronautics corporation and make a good- effect.

论文的主要工作如下： 1研究了飞机装配型架骨架设计重用技术，在总结归纳骨架线框结构类型的基础上，应用模板驱动的方法建立了骨架线框库，通过骨架线框零件的实例化和离线编辑实现骨架线框的重用，有效利用设计资源，减少重复劳动； 2提出穷举几何对象的装配特征直接获取方法，遍历零件模型的几何对象，从中捕捉所需装配特征，该方法简捷、高效；提出向装配面投影的装配特征间接获取方法，该方法在现有特征基础上生成装配特征，解决了部分装配特征难以直接获取的问题； 3研究了基于装配特征的飞机装配型架骨架自动装配技术，采用一种二叉树装配模型表达骨架的装配关系，并通过装配特征的分配、获取和赋值三个步骤，实现了骨架分别与飞机产品和可调支承的自动装配，避免了繁琐的人工交互操作，提高了骨架设计的效率和规范化程度； 4研究了飞机装配型架骨架零件间建模技术，在总结归纳骨架元件相贯处理方式的基础上，提出了骨架元件单剪切相贯、双剪切相贯和互剪切相贯的实现算法，简化了骨架相贯处理的过程； 5基于以上研究，在CATIA平台上开发了飞机装配型架骨架快速设计子系统，并应用于某大型航空企业的装配型架设计，提高了设计效率和设计质量。

The results show that this spicule has the complex hiberarchy: the first tier is nano silica particles; the second tier is the sub-rounds within one silica round; the third tier is silica rounds composed of several parallel sub-rounds; the fourth tier is homocentric round structure with alternant deposition of silica and organic matrix.

结果表明，这种海绵骨针具有复杂的四级结构：第一级是纳米硅球；第二级是二氧化硅层内的亚层结构，第三级是单层二氧化硅层；第四级是二氧化硅－有机基质复合的同心圆结构。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。