查询词典 strontium process

The process,using strontium nitrate and ammonium bicarbonate as raw materials to develop and produce high purity strontium carbonate is introduced.

介绍了以硝酸锶和碳酸氢铵为原料，研制生产高纯碳酸锶的工艺过程。

The principle and process conditions for the production of high purity strontium carbonate from celestite by catalytic converting method are studied.

研究了催化转化法由天青石制备高纯碳酸锶的生产原理和工艺控制条件，有效地克服了传统生产方法中转化率较低、三废污染严重、能耗高、生产复杂等种种弊端。

In the one half part, according to the strontium nature, thermodynamic calculation of correlative reaction and the principle of the vacuum aluminothermy reduction process, with the laboratory findings of preparation strontium by vacuum aluminothermy reduction compared and analyzed in different parameter conditions, a variety of factors which effect the decomposition rate of SrCO_3 and the percent reduction of strontia are gotten out. The factors include that the decomposition rate of SrCO_3 is influenced by different addition and pressure. They also include that the percent reduction of strontia is influenced by excess coefficient of reducing agent aluminium powder, the particle size of raw material or reducing agent, the pressure of barbecuing, temperature and reduction time. According to those, we can draw the conclusion as follows:(1) Decomposition temperature of SrCO_3 is decreased by adding carbon and alumina in different degree.(2) With quantitative carbon added under the vacuum condition, the decomposition temperature of SrCO_3 is decreased obviously, which can fall 150℃ compared with atmospheric pressure.(3) In keeping 1150℃ of 2.5h, under the 5Pa vacuum condition, the decomposition rate of SrCO_3 nearly keeps in 99% steadily.

在前半部分的真空铝热还原法中，根据锶的性质、相关反应的热力学计算及真空铝热还原法原理，通过对不同参数条件下的真空铝热还原法生产金属锶的实验结果的分析比较，得出了影响SrCO_3的分解率和氧化锶的还原率的种种因素，具体因素包括不同添加剂、不同气压对SrCO_3分解率的影响，还原剂铝粉的过量系数、原料与还原剂的粒度、制团压力、温度和还原时间等对氧化锶还原率的影响，得出具体结论如下：(1)添加碳和Al_2O_3能不同程度的降低SrCO_3的分解温度；(2)真空条件下加入一定量的碳可显著降低SrCO_3的分解温度，比之常压下可降低150℃之多；(3)在1150℃恒温2.5h、真空度达到5Pa的条件下，SrCO_3的分解率几乎保持稳定在99％；(4)氧化锶的还原率随还原剂过量系数的增大而增大，但是趋势越来越小，当过量系数超过25％后，氧化锶的还原率几乎不再增加；(5)氧化锶的还原率随原料与还原剂的粒度的变细而增加；(6)氧化锶的还原率随制团压力的增加而增加，但超过一定值后，氧化锶的还原率反而会下降；(7)氧化锶的还原率随还原温度的升高而增加；(8)氧化锶的还原率随还原时间延长而增加，在本实验条件下，超过2.5h趋于稳定。

NEW STRONTIUM SALTS OF SULPHONIC ACIDS, A PROCESS FOR THEIR

磺酸类的新锶盐，它们的制备方法和包含它们的药物组合物

Ba0.7Sr0.3TiO3 powders are successfully prepared by the hydrothermal process where barium chloride, strontium chloride and titanium chloride are used as raw materials at 240℃ for 10 hours.

利用水热法研究了BST前驱物的初始配比、矿化剂NaOH过量浓度、水热时间和温度等条件对合成Ba0.7Sr0.3TiO3粉体的影响。

Collected the products at different special situation on the curve of thermal evolution, examined it by field-emission scanning electron microscope to analyze the situation of strontium molybdate's growth process.

根据不同pH值体系中监测得的热谱线的特殊位置取样进行SEM测试，分析SrMoO4的生长情况。

In order to study the changing process of Barium strontium titanate Ba(subscript xSr(subscript 1-x) TiO3, BST from cubic phase to the tetragonal phase with Ba doping and the ferroelectric characteristic of BST, the total energy of BST with different mole ratio of Ba/Sr when Ba doped was calculated and the fine structure determined, based on general gradient approximation, by means of ultrasoft pseudopotentials plane wave method.

为了研究钛酸锶(SrTiO3， ST)中随Ba的掺入，其晶体从顺电相到铁电相的变化过程及四方相钛酸锶钡Ba(下标 xSr(下标 1-x)TiO3， BST的铁电性。在广义梯度近似下，利用超软赝势平面波方法计算了不同Ba/Sr摩尔比BST的总能量，确定了BST的精细结构。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。