查询词典 striking of arc

During the Cenozoic, the evolution of the sag might be divided into three stages: during the Eocene, because of regional extension effect of the NW-SE-striking, it was a ramp depression controlled by the Cangdong fault; during the Oligocene, it might have subjected to the combined effects of the NW-SE-striking regional extension and the dextral slipping of the NNE-striking deep fracture zone; during the Neocene and the Quaternary, though the regional extension had mainly stopped, the dextral slipping continued. Inside the slip zone, the local, SN-striking extension related to the dextral slipping became more and more apparent.

新生代演化分为3个时期：NW-SE向区域伸展作用，凹陷是一个由沧东断层控制的断坡凹陷；渐新世，凹陷受NW-SE区域伸展和NNE向深断裂带右旋走滑的共同作用；晚第三纪到第四纪，区域伸展作用基本停止，走滑作用仍在继续，由走滑作用导致的SN向局部伸展作用显得更加突出。

It is the first time that no additional anode was adopted in the magnetic macroparticles filter. At the same time the auto-re-igniting system was designed for vacuum cathodic arc deposition instrument. It ignites the arc with an electronic component with high voltage and can auto distinguish weather the arc dies out or is on during the deposition via a main power supply feedback unit. The energy for igniting the arc is very less and thus can successfully prevent the film being contaminated.

设计制造的电子式真空阴极弧离子镀引弧器成功地实现了高压脉冲引弧，可以多次重复使用，所用能量较小，可以有效防止对所镀膜的污染，引弧可靠，能够自动识别电弧是否引燃，能够在熄弧后自动重新引弧，重新引弧的速度快，有效防止了熄弧引起的气压波动，使镀膜过程中气压非常稳定。

According to spectral characteristics of the HCVAW arc in a body, energy factor which value equals to the ratio of two spectral lines' intensity, was defined.When τ's value was less than 0.1, the HCVAW arc was exhibitive of diffusedshape with lower energy density instinct; and when τ's value was higher than 0.5,the arc was a fine-constricted arc with higher energy density.

从积聚态电弧的谱线空间分布来看，阳极材料为水冷铜板时，自空心阴极端面到阳极工件，氩原子谱线相对辐射强度具有比氩一次离子谱线相对辐射强度更快的减弱趋势，最大辐射强度均出现在距空心阴极端面2mm左右的位置。

The characteristic of primary arc is analyzed, and the dynamic model of primary arc is established. The line differential equation including primary arc voltage is constructed, and the parameter estimation technique is used to estimate the voltage amplitude of primary arc, so as to determine the fault type and realize adaptive three-pole-autoreclosure.

分析了一次电弧的特点，建立了一次电弧的动态模型，利用一次电弧的特点建立了包含电弧电压的超高压输电线路相间短路的线路微分方程，通过参数估计的方法求得故障点的电弧电压，以判断故障类型，实现自适应三相重合闸。

In the proposed formulation, the fluid jump arc of Second order Fluid Stochastic Petri nets, which takes deterministic jump height, is introduced for the sake of modeling impulse rewards. In order to model non-Markovian stochastic systems, the fluid jump arc is combined with the flush-out arc. As a result the fluid jump arc as a modeling primitive has the function of emptying in zero time the existing fluid from the continuous place connected with it.

为方便利用该机制建模冲量回报，引入二阶流体随机 Petri 网中的流体跳跃弧，跳跃弧的跳跃高度取确定值；为方便建模非马尔科夫随机系统，将清空弧与流体跳跃弧结合，使得流体跳跃弧作为建模原语直接具有瞬间内清空与之相联接的连续库所的功能。

Plasma cutting machine work, the first plasma arc ignition by high-frequency oscillator excited between the electrode and the inner wall of the gas nozzle, resulting in high-frequency discharge, the gas ionization and the formation of local small arc, this small arc by the compressed air role, from the nozzle to ignite plasmon in the arc, spark generator, which is the main task.

等离子切割机工作时，首先要引燃等离子弧，由高频振荡器激发电极与喷嘴内壁之间的气体，产生高频放电，使气体局部电离而形成小弧，这一小弧受压缩空气的作用，从喷嘴喷出以引燃等离于弧，这是火花发生器主要的任务。

Through the comparative analysis that: the arc-tooth flow of hydraulic performance is better than the arc, Adopting optimize the design parameters of the structure, reducing the flow rate of 0 regions, and strengthen vortices regions, improved irrigation arc tooth for hydraulic performance and anticlogging ability, irrigation design recommended by arc-tooth flow structure.

通过对比分析认为：弧齿形流道水力性能优于弧形流道，可以通过结构参数优化设计，减小0流速区域，强化旋涡区，提高弧齿形灌水器的水力性能与扰堵塞能力，灌水器设计中推荐采用弧齿形流道结构形式。

Based on the results of the experiments, analyzing arc reignition probability and stagnation time of each arc-quenching chamber, a new type arc-quenching chamber with splitter plates, which holds stronger ability of arc quenching compared with the old ones, is designed.

分析了每种灭弧室的电弧重燃几率及电弧停滞时间等性能参数，基于试验的结果，设计了一种灭弧性能明显优于原灭弧室的新型栅片灭弧结构。

Through testing practically and calculating theoretically, this paper has evaluated generally the energy consumption of the SCR arc welding power source?the DC arc welding generator and the inverter arc welding power source for manual arc welding machine used in production.

通过实际测试与理论计算，对晶闸管整流电源弧焊机、直流弧焊发电机和逆变电源弧焊机等生产中常用的焊条电弧焊焊机的耗电量情况进行了综合评价。

It can be concluded from the above experiment results that for the auxiliaryheated arc plasma generator, an area which has uniform temperature distribution andhigher temperature. In this area, the diameter of the key arc root increases and thiscondition is beneficial to reduce the cathode erosion. At the same time, it is animportant segment for the secondary arc to rotate on the cathode surface and to heatthe surface for the auxiliary heated arc plasma generator.

总结上面的实验结果可以看出：在辅助加热电弧等离子体发生器中，利用辅助电弧对阴极表面的加热作用，能够在阴极表面形成一个温度较高且分布均匀的区域；在温度较高的区域内，主弧弧根直径增大，这种情形有利于减小阴极烧损；同时，辅助电弧旋转加热阴极表面是辅助加热电弧等离子体发生器的一个重要环节。

We got alerted a couple of times while we were down south that HETs were on the way to bring us back up north because things were going to go hot again, but it was just rumors.

南下的途中我们不只一次得到警告说重型装备运输车将拉着我们重新北上，因为局势正在变得重新紧张起来，但这只是谣传。

It's the one where they find the ghost in the salt mine.

这一集是演他们在盐矿找到鬼