查询词典 stress accent

The results show that new residual stress is about 6MPa under air-cooled normalizing; due to chilling effect of surface quenching, the temperature differences between coarse bar and thin bar in stress frame, and between surface and core of the coarse bar are tremendous; in quenching process, the stress of the certain areas in the coarse bar is maximum at 2s, more than 420MPa, the stress frame casting has the bigger possibilities of fracture.

结果表明，正火空冷时新产生的残余热应力约6MPa；淬火时由于表面激冷作用，应力框在粗细杆间及粗杆的表面和芯部都有巨大温差；铸件在淬火的过程中，粗杆的某些部位在2s时等效应力达到最大，超过了420MPa，极有可能导致铸件断裂。

General clue of this paper is simulating wood stress field change in initial cutting stage and working out weighted boundary condition of cutting tools first,and then based on which, finding out shear stress and maximal effective stress when wood cut-ted.Meanwhile,finite element comparative analysis is proceeded on distortion and stress field by changing tool orthogonal rake.

本课题的总体思路是通过大型有限元软件ANSYS来模拟切削初始阶段中木材的应力场变化，进而得出刀具受力的边界条件，依此为基础求出木材受切时的剪应力及最大等效应力，同时通过变化刀具前角分别对受切工件的变形及应力场进行有限元比较分析，从而确定刀具的优化前角；优化前角确定后，再通过对刀具进行强度校核确定后角优化值。

From FEM, the contact stress obeys the semi-ellipse distribution and the Mises stress and shear stress are also consistent with contact mechanics theory, but there exists offset or deflection in the symmetric lines of stress distribution, which originates from tooth bending deformation.

由有限元方法得到的渐开线轮齿的接触应力符合Hertz理论中的半椭圆分布规律，Mises应力和剪应力分布也符合接触力学理论，但应力分布的对称中心存在偏离或者偏斜现象，分析认为，是由于轮齿弯曲变形造成的。

When a sudden power failure or accident or normal pump stops when the pump stops, the valve inlet water velocity to reduce stress Agency, the valve plate also fall, when its velocity is zero (that is, inlet flow rate is zero Department), large valve plate because of its own gravity and rapidly turn off (time 3s ~ 5s), the majority of water to prevent backflow, when the valve before and after the formation of a water pressure, water stress, on the one hand through the small valve at the bottom of the three slot for pressure relief vent pressure. 4 water stress from the bypass tube into the cavity patch up the control room (this process for the suction pressure chamber that can effectively absorb the energy of water), when water stress on cavity than inferior vena cava, the pressure of water promote the diaphragm down mobile , the current cavity pressure of water being squeezed out all the small valve plate slowly drop back to standby status, the process time to ease closure adjustable (3s ~ 150s), then the valve has been fully closed, watertight.

当突然停电或事故停泵或正常停泵时，阀门进水口处压力水流速降低，大阀板也随之下降，当其流速为零时，大阀板由于自身重力而迅速关闭（时间3s～5s），可防止大部分水倒流，此时阀门前后形成一种水压差，压力水一方面通过小阀板底部的三条泄压槽进行泄压。4）压力水从旁通管进入膜片控制室上腔（此过程为吸压腔，能有效吸收一部分水能量），当上腔压力水大于下腔时，压力水推动膜片往下移动，当下腔压力水全部被挤出来时，小阀板缓缓下降，恢复到待机状态，此过程中缓闭时间可调节（3s～150s），届时阀板已全部关闭，滴水不漏。

The results showed that the maximum secondary stress of upper chord located in the panel adjacent to roof ridge with the value exceeding primary stress,and the secondary stress in end panel is relatively smaller with the value of one third of the primary stress.

分析结果表明，上弦杆的次应力最大值在邻近屋脊的节间，最大可达到主应力的一倍以上，而端节间次应力相对较小，最大可达到主应力的1/3。

In this modified model, the effect of the stress concentration on the end stress in the fiber end region is considered, the average matrix strain is used to substitute for the so-called far field strain in the previous shear lag model. The change of the deformation states from elasticity to plasticity is considered and the interfacial shear stress and fiber axial stress are derived.

修正的模型合理考虑了纤维根区域应力集中对根应力的影响；用基体平均应变代替了经典剪切滞后模型中的远场应变；考虑了基体变形状态从弹性到塑性的变化，给出了塑性区上的表面剪切应力和纤维轴向应力的表达式。

The forms of fatigue cracks in bore of gun barrel are considered as edge cracks and semi-elliptical cracks. The stress intensity factors of gun barrel are calculated using a weight function method under the autofrettaged residual stress, thermal stress and assemblage stress.

3武器身管内表面的疲劳裂纹考虑为边裂纹和半椭圆型表面裂纹两种形式，用权函数方法研究了身管在自紧残余应力、温度应力和装配应力作用下的应力强度因子。

Applied with test of potted plant and measurement absorbency for study physiological response of activity of cell defense enzymes and lipid peroxidation of slash pine's half-sib under water stress. There are 7 families comparison with general slash pine. The contents of superoxide dismutase, catalase, antioxidant, malondialdehyde and the rate of superoxide anion(-O2) generating are mensurated under normal water condition while soil water content is 70% and light water stress while soil water content is 55% to 60% and medium water stress while soil water content is 35% to 40% and heavy water stress while soil water content is 20% to 25%. The test result indicate that either water grads or families of contents of SOD,CAT,AsA,MDA are mighty notable difference. The rate of -O2 generating is notable difference within families. The rate of -O2 generating is mighty notable difference within water grades.

为研究湿地松优良半同胞家系保护酶及脂质过氧化作用对水分逆境的生理响应，采用盆栽试验和吸光度测定结合的方法，以普通湿地松种子为对照，测定了七个湿地松半同胞家系在正常水分状态（土壤相对含水量为70%）、弱度水分胁迫（土壤相对含水量为55%~60%）、中度水分胁迫（土壤相对含水量为35%~40%）和强度水分胁迫（土壤相对含水量为20%~25%）条件下的SOD、CAT、AsA、MDA的含量和-O2产生速率，研究结果表明：无论是不同水分梯度还是不同家系水平，SOD、CAT、AsA活性和MDA含量的差异均达极显著水平，不同家系水平间-O2产生速率有显著差异，不同水分梯度间-O2产生速率差异达极显著水平。

A 3D lithosphere model of the Indo-Australian plate is constructed and numerical simulation of the tectonic stress field of the Indo-Australian plate is performed by using the pseudo-3D finite element method and adopting the WSM2000 observed stress data and stress state as constraints, and then the influence of the boundary forces applied at the Indo-Australian plate on the intraplate stress field is discussed.

本文采用伪三维有限元方法，利用 WSM2000观测应力场数据的应力取向和应力状态作为主要约束，建立了印度—澳大利亚板块岩石层三维模型，对印度—澳大利亚板块构造应力场进行了数值模拟，进而探讨印度—澳大利亚板块所受边界力对板块内部应力场的影响。

Home position shear tests of slope rock, point loading tests and indoor AMD simulation action tests in XingQiao concave slope had show shearing strength and coherence between body layers of quartz sandstone decrease by 13.2%~21.3% after attacked by AMD, the angle of internal friction between layers is decreased by 5.0%~7.5%, in general, AMD affects the rocks mechanical property at range of 60~100m interior the perpendicular slop. Data analysis shows: 1 The actions to slope are major focused on zone of weakness, shearing strength of slope foot and AMD centre are reduced by 52% and 64.7% separately. 2 The explosion stress wave of long distance field has obviously increasing influence to disturbance amplitude value of slope with increasing of the slope height and distance, the response of the top of slope and fault region are obvious as well as damage effect; the foot of slope is with smallest disturbance amplitude value, the disturbance amplitude value of the step close to free face is obviously bigger than the interior of slope. 3 With the coupling effect of the AMD and explosion loading, the stress distribution inside of slope mainly presents characters of explosion stress field; the area affected by AMD becomes a weak area of shearing stress.

新桥深凹露天矿边坡岩体的原位剪切试验、点载荷试验、室内模拟AMD作用试验表明：AMD蚀化后的石英砂岩，岩体层面间的抗剪强度和粘聚力减小的幅值约为13.2%~21.3%；层面间内摩擦角减小幅值在5.0%~7.5%之间；AMD一般影响垂直边坡体内部在60~100m范围内的岩体力学性质数值分析表明：AMD对边坡体的作用主要集中在弱化区域内，边坡体的底脚和AMD作用中心区域的剪切应力减少了52.0%和64.7%；(2)随着边坡体高度和距离的增加，远场爆炸应力波对边坡扰动幅值的增加趋势明显，边坡顶部和断层部位的响应突出，损伤效应明显；边坡底脚扰动幅值最小，临空面附近台阶的扰动幅值明显大于边坡体内部；(3)AMD与爆破荷载耦合作用后，边坡体内部的应力分布主要呈现出爆炸应力场的特征，AMD影响区域形成了一个剪切应力弱区。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"