查询词典 strength-increasing

Those novel methods include the determination of damage tolerance ,interface bonding strength,the elastic modulus and bending strength of coatings,nondestructively measuring the local strength of glass,depth-sensing indentation method,and prediction of properties via the residual trail.

介绍了陶瓷、玻璃等脆性材料力学性能评价的一些非常规技术，包括：脆性材料的损伤容限、层状材料和镀膜材料的力学性能和界面强度测试、材料表面局部强度的非破坏性测试，弹性模量和能量耗散能力的估评、残余痕迹预测材料性能等。

The strength training of sprinters should be based on their own characteristics and the development of maximum strength and speed strength should be stressed.

不同运动水平运动员在不同发展阶段的生理生化指标是发展最大力量、速度力量的负荷强度定量依据。

When used in thermoplastic and thermosetting resin such as phenol aldehyde, polyester, epoxy, PBT, polyamide, carbonate, it can greatly improve dry and wet bending strength, compression strength, shear strength and other physical mechanical properties and wet electric properties, also improve the wetting property and dispersion of stuffing into polymer.

应用于矿物填充的酚醛、聚酯、环氧、PBT、聚酰胺、碳酸酯等热塑性和热固性树脂，能大幅度提高增强塑料的干湿态抗弯强度、抗压强度、剪切强度等物理力学性能和湿态电气性能，并改善填料在聚合物中的润湿性和分散性。

When the strength of the magnetizing field is lower than 40-50 oersteds, the curve showing the dependence of internal friction on magnetic field strength is almost flat, and becomes steeper for a higher field strength.

当磁场强度小於40—50奥时，内耗随着磁场强度而变化的曲线几乎是平的，其后则变化较快，在超过约150奥时，内耗的变化又渐越平缓，最后达到一个差不多恒定的最大值。

The strengths of the plain wood rose along with the compression ratio, while the bending strength and MOE lowered as it reached the maximum compression ratio; the plain wood compressed (33%) and heated 10h with 180℃. its bending strength lowered 40%, MOE lost about 50% and hardness lowered 12% than heated 0.5h; the properties not to be compressed after impregnated with PF resin. had a slow rising with the resin concentration, and compressed (33%) after impregnated with PF resin (30%). its bending strength, MOE and hardness increased 82.9%, 98% and 152% respectively.

三倍体毛白杨素材压缩后，其静曲强度和抗弯弹性模量均随压缩率的增大而提高，但接近最大压缩率时均下降；素材压缩（压缩率为33%）后以180℃空气加热处理10 h，静曲强度比同温度压缩保温0.5 h时下降约40%，抗弯弹性模量下降近50%，表面硬度下降约12%；用PF树脂浸渍处理后不经压缩，随PF树脂含量增加木材静曲强度提高幅度不大；用30%PF树脂浸渍后，当压缩率为33%时，其静曲强度、抗弯弹性模量和表面硬度分别比未压缩素材增加82.9%，98%和152%。

In order to research the ship ultimate strength, the ultimate strength of stiffened panel must be considered. And the web buckling and the stiffener tripping are the two main failure forms of stiffened panel. Based on the two main failure forms in this paper, according to the six failure modes of stiffened panel, the ultimate strength is solved by programming, and the failure mode is presented.

船体梁可近似看作是由加筋板组成的薄壁箱型结构，要研究船舶的极限强度，必须考虑加筋板的临界应力，而腹板屈曲和扶强材侧倾是加筋板的两种主要失效模式，本文在分析这两种失效模式的基础上，根据加筋板的六种失效模式，编程求解加筋板的临界应力，并给出其失效模式。

According to the results of this study, the ultimate strength of pin-bone interface increased as the moment arm decreased and torque increased. When the pin-bone angle approached 90°, the ultimate strength was the largest and as the angle decreased, the ultimate strength decreased. There was no significant difference between rigidity and torque, but rigidity decreased as the skull-bone angle decreased.

结果发现钉骨界面的极限强度在头圈距离颅骨的力臂短时较高，且随著所用扭力的增加而增加，当头钉与头骨表面的夹角成垂直时最强，随著夹角越趋锐角而渐减，钉骨界面的刚性与扭力并无明显关系但与夹角有关，夹角垂直时刚性最高，而后随著夹角渐趋锐角而递减。

The experimental results show that the estimated strength of cylindrical specimens and core specimens taken from plate-like specimens under the condition of saturated surface-dry were good and the difference between the estimated strength and the measured strength is within 10%. For the plate-like specimens used in this study, measured the surface P-wave and internal P-wave, and investigate the difference between surface P-wave and internal P-wave velocities. Firstly, the internal P-wave velocity was recovered to the saturated surface-dry condition.

实验结果显示，350 kgf/cm2自充填混凝土及早强混凝土之圆柱试体及版试体所进行波速－强度关系曲线验证结果良好；而将圆柱试体及版试体套入粗骨材含量波速－强度关系式所得结果，其圆柱试体28天超音波强度预估差异约10%，显示试体28天处於面乾内饱和状态，以粗骨材含量配合波速量测来预估强度之结果良好。

The process method of kaolin was introduced using A-151 and ester titanate coupling agent. Effect of dosage of A-151 and ester titanate coupling agent on stretch strength and modulus, bending strength and modulus , impact strength of UPR was investigated.

介绍了用A - 15 1与钛酸酯偶联剂处理高岭土的方法，研究了处理剂的用量与偶联高岭土的加入量对UPR的拉伸强度和模量、弯曲强度和模量以及冲击强度的影响。

They used limestone of different quality and large-fluctuant-range waste stone in proportion and substituted a part of clay with clay stone to produce cement. And the physical performance of the produced Portland cement was improved greatly-28 d strength increased from 50.4MPa to 54.5MPa, and output of the rotary kiln increased. Moreover, the company also tried to use green shale as admixture to produce compound cement and successfully produced compound Portland cement with a little low early strength and a little higher 28d strength than slag Portland cement. And the cement cost decreased 19.59 yuan per ton.

将CaO含量波动范围较宽的废石与不同品位石灰石按比例搭配使用，将其粘土质特性的废石替代部分粘土生产；而且生产的硅酸盐水泥熟料物理性能有较大提高，28d强度由原来的50.4 MPa提高到54.5 MPa，窑产量也有一定的提高；此外，该公司还进行了将绿色页岩作混合材生产复合水泥的生产探索，成功生产出了早期强度略低，但28d强度略高于矿渣硅酸盐水泥的复合硅酸盐水泥，且使水泥生产成本降低19.59元/t。

The basic concept of FOP can be summarized as to further optimize effective prescription according to the standard of curative effects and with the aid of modern science and technology and theories of traditional Chinese medicine.

其基本内涵可概括为：以确有疗效的中药复方为研究对象，以现代科学技术和传统中医药理论为技术支持，以该复方所治病证的药效响应为评价标准，以优化重组疗效更优的新复方为研究目的。

Ever since our world has been a world, native forests have been indiscriminately exploited by man.

自从我们的世界一直是世界原生森林被任意剥削人。