查询词典 strength-increasing

The residual stress σ〓 in the weld center is always as high as the yield strength σ〓 for both the strength undermatching and overmatching when the yield strengthσ〓 is lower.

母材屈服强度σ〓较低时，如低碳钢，低强匹配（焊缝屈服强度σ〓＜母材屈服强度σ〓）和高强匹配时焊缝中心纵向残余应力σ〓均能达到焊缝屈服强度σ〓。

The contact fatigue strength was measured after the 20CrNi2Mo and 15CrNi6 steel used asdragging gear on quasi high speed locomotive was carburized and quenched as well as peened,com-pared with that of 20CrMnMo steel.The results shown that the contact fatigue strength limits of thesethree types of steel carburized and quenched essentially same,and the contact fatigue strength Iimit hasbeen increased by 5 porcent after peening,and that the failure appoarances of all contact fatiguespecimen were delamination ...

对20CRrNi2Mo、15CrNi6及20CrMnMo渗碳淬火齿轮及15CrNi6渗碳淬火＋喷丸处理齿轮进行了弯曲疲劳试验，介绍了齿轮试件的设计与加工、试验装置与夹具、试验方法及试验数据的统计处理，试验结果表明，20CrNi2Mo和15CrNi6渗碳淬火齿轮在R＝0.99时的σFlim分别为530MPa和375MPa，与20CrMnMo渗碳淬火齿轮相比，弯曲疲劳强度分别提高80％和27％。15CrNi6经渗碳淬火＋喷丸处理齿轮在R＝0.99时的σFlim为490MPa，比未喷丸处理者提高30％。

By the analysis of the characteristic and restriction of the gear components ,this paper upbuilds the characteristic model based on the restriction and actualizes data transmission and information sharing among CAD.CAE and CAPP .This paper analyzes the general principle of parameter determination and strength check about gear and researches the algorithmic of gear strength check based on the characteristic .This paper introduces expert knowledge into respective procedure of CAD.CAE and CAPP and actualizes the intellectualization in design process .strength analysis and process planning .

以齿轮类零件作为研究对象，在分析了其特征及约束的基础上，利用数据库技术和图形单元建模技术，建立了基于约束的特征模型，实现了CAD／CAE／CAPP之间的数据传输和信息共享；分析了齿轮参数确定、强度校核的一般原则，进行基于特征的齿轮强度校核的算法研究；将专家知识融入在CAD、CAE、CAPP各个过程中实现了设计过程、强度分析和工艺分析的智能化。

Measured the basic physical parameters of unsaturated soils in Three Gorges Reservoir area; 2 measured the initial sample matric suction using the unsaturated triaxial testing system, which can be used to evaluate the unsaturated soil strength and stress; 3 the drying and moisture absorption experiments were executed using the Tempe apparatus, and got the Soil-Water Characteristic Curve, permeability coefficients of every stress level were simulated according to the parameters from the SWCC; 4 the unsaturated soil strength tests were carried out using the GDS triaxial testing system, then got the Mohr circle and shear strength parameters; the results from different stress paths were compared; meanwhile, the axial strain-stress ratio-volume strain curve of different matric suction and different radial pressure was got, as well as their relationship; The research, which provided the necessary data and reference for Three Gorges Reservoir area geologic disaster, is the basic component of Three Gorges Reservoir geologic disaster prevention and research, and experimental results will be used directly in the project.

1量测了三峡库区非饱和土的基本物性参数； 2用非饱和土三轴试验仪量测了试样的初始基质吸力，为评估非饱和土的强度和应力水平提供参考； 3用Tempe仪和体积压力板仪进行了非饱和土的干燥和吸湿试验，得到了土-水特征曲线，并根据其参数拟合出各级吸力状态下对应的渗透系数； 4用GDS三轴仪进行了强度试验，得到了Mohr圆和抗剪强度参数；并比较分析了不同应力路径下试验结果；同时得到不同吸力和不同围压下轴向应变-应力比-体应变的关系曲线和其相互关系。该研究是三峡库区地质灾害防治研究工作的基础性工作，其结果将直接应用到工程实际中，为三峡库区地质灾害提供必要的数据和参考。

On the base of large amount of tests, this thesis analyzes the impacts of testing period, fiber dosage and cement dosage upon the compressive strength, splitting tensile strength, compressive resilient modulus, flexural strength and flexural elastic modulus of polypropylene fiber cement stabilized macadam, and the corresponding impact rule was found.

3在大量试验的基础上分析了试验龄期、纤维掺量、水泥掺量对聚丙烯纤维水泥稳定碎石抗压强度、劈裂抗拉强度、抗压回弹模量、抗弯拉强度和抗弯拉弹性模量等的影响，并得出了相应的影响规律。

When the self-etched adhesives (Contax, Clearfil TRI-S Bond) were used for the surface treatment of sclerotic dentin, the results of thermal circlings showed that, for Contax, 5,000 times thermal circlings did not weakened the bond strength, while the bond strength after 10,000 times thermal circlings significantly lower than that before circling; for Clearfil TRI-S Bond, 5,000 times thermal circlings significantly weakened the bond strength, while 10,000 times thermal circlings weakened it further.

选择自酸蚀系统粘接剂Contax和Clearfil TRI-S Bond粘接非龋性硬化牙本质，分别测量冷热循环0次，5000次及10000次时的微拉伸粘接强度，结果显示：Contax粘接剂冷热循环5000次后粘接强度无明显下降，而循环10000次后粘接强度明显下降；Clearfil TRI-S Bond粘接冷热循环5000次后粘接强度明显下降，循环10000次后粘接强度进一步下降。

From the result of this study,it has been found that the strength of back musculature was relatively weak among the extensors of the trunk,and the phenomenon of a certain "unbalance" has been found in the strength of trunk and neck muscle group. Greco-Roman style wrestlers ; strength of truck and neck muscle group

为此 ，我们采用世界上较为先进的人体躯干及颈部力量测试系统对备战 2 0 0 4年雅典奥运会的中国国家队运动员躯干和颈部肌群的力量进行了测试和分析，以期为今后该项目的运动员选材和力量训练工作提供一定参

By comparing the method with the traditional strength training, the authors found theordinary speed strength and rapid speed strength of the flexors and extensors of the lower limbs of theexperiment group had been raised significantly.

通过对振动刺激力量法和传统力量训练方法的比较研究，发现附加全身振动刺激的实验组下肢三大关节屈伸肌肌群的一般和快速力量在实验后明显提高，其增长幅度明显大于对照组，组间比较具有显著性差异。

Through the authorized strength of construction organization design, can consider all-sidedly the various specific execution conditions that will build project , foster strengths and circumvent weaknesses land will decide reasonable the programme of construction, determine construction order, construction method and labour organization, reasonably comprehensive arrangement will be under construction surely progress plan; To build the design scheme of project the reasonability on economy, the scientificness on technology with in enforcement the possibility on project expounds and proves offer basis; To build the unit planned and construction enterprise construction working plan and enforcement of authorized strength of capital construction of authorized strength to be under construction prepare to work to plan offer basis; Can will build construction and the design of project;, the construction organization work of technology and all construction arrangements of economy, front and rear and construction enterprise and specific project more combine closely; Can the construction unit and cooperation unit, department and department that directly attends , stage and stage and course - the relation between course coordinate better.

通过施工组织设计的编制，可以全面考虑拟建工程的各种具体施工条件，扬长避短地拟定合理的施工方案，确定施工顺序、施工方法和劳动组织，合理地统筹安排拟定施工进度计划；为拟建工程的设计方案在经济上的合理性，在技术上的科学性和在实施工程上的可能性进行论证提供依据；为建设单位编制基本建设计划和施工企业编制施工工作计划及实施施工准备工作计划提供依据；可以把拟建工程的设计与施工；、技术与经济、前方与后方和施工企业的全部施工安排与具体工程的施工组织工作更紧密地结合起来；可以把直接参加的施工单位与协作单位、部门与部门、阶段与阶段、过程-与过程之间的关系更好地协调起来。

Of the fiber tested in the first phase , the researchers determined that a hook-shaped wire of regular strength 1.2 in.(30mm) long and 0.022in(0.55mm) in diameter, as well as a hook-shaped wire of high strength 0.015 in.(0.38mm) in diameter ,offered the highest strength and ductility .

该纤维测试在第一阶段，研究人员发现，一钩异型钢丝的经常实力1.2英寸长和0.022in （ 0.55毫米），直径，以及作为一个钩异型钢丝高强度0.015英寸（ 0.38毫米）在直径，提供了最高的强度和韧性。

The basic concept of FOP can be summarized as to further optimize effective prescription according to the standard of curative effects and with the aid of modern science and technology and theories of traditional Chinese medicine.

其基本内涵可概括为：以确有疗效的中药复方为研究对象，以现代科学技术和传统中医药理论为技术支持，以该复方所治病证的药效响应为评价标准，以优化重组疗效更优的新复方为研究目的。

Ever since our world has been a world, native forests have been indiscriminately exploited by man.

自从我们的世界一直是世界原生森林被任意剥削人。