查询词典 strength-giving

2Research of strength characteristic for high bending concreteWe researched the bending strength, compression stength and cleavage strength characteristics of different type, different design strength and different age HBSPC , and analyzed the relations of of the strength of different HBSPC,we also analysised the influence regulation for HBSPC strength by the the admix amount and feeding sequence.

2高抗折强度路面混凝土强度特性研究。研究不同类型、不同掺量和不同龄期HBSPC的抗折强度、抗压强度和劈裂强度特性，并分析HBSPC不同强度之间的关系。

To attain the same strength grade, the content of cement in cement fly-ash stabilized hoggin has reduced by 0.5~1% comparing with cement stabilized hoggin. This material has a capability of adapting with different aggregate's gradation and the 4.75mm passing rate can reduce to 30%. Through the studying about the mechanical property of cement fly-ash stabilized hoggin, this manuscript discover that the material has good strength growing performance that its 90d strength growing rate is 385% and its splitting strength that the 7d splitting strength is 0.347MPa and the 90d splitting strength is 0.700MPa accord with requirement in the norm.

粉煤灰处于最佳掺量时，通过粉煤灰的填充、活性等作用，使材料在达到相同强度等级，水泥剂量降低0.5～1%；并且对集料级配具有更好的适应性能且能使集料4.75mm以下通过率降低至30%左右；而且能有效提高材料的强度增长率，90d强度增长率高达385%左右；同时，降低回弹模量16%左右，对材料的抗裂性能有显著的改善作用。

The best strength area of the consciousness ability various index signs of the development sport also does not fulfill same alike, among them the best strength area of the synthesize consciousness ability as average heart rate mostly at 125～145 times/ min, the best strength area of the elbow joint kinesthesia directions consciousness ability is an average heart rate mostly at 130～148 times/ min, the best strength area of the depth consciousness ability for average the heart rate mostly at 132～147 times/ min, the best strength area of time consciousness ability is an average heart rate mostly at 126～138 times/ of the min

3发展运动知觉能力各项指标的最佳强度区也不尽相同，其中综合知觉能力的最佳强度区为平均心率大致在125～145次/min，肘关节动觉方位知觉能力的最佳强度区为平均心率大致在130～148次/min，深度知觉能力的最佳强度区为平均心率大致在132～147次/min，时间知觉能力的最佳强度区为平均心率大致在126～138次/min之间。

To develop manpower in harmony, we confirm the object of parol education in kindergarten: the object of solid-state strength development should make the physiological quality, the knowledge reserve and the cultivation accumulation develop unitedly; the object of active strength development includes the development of physical strength, intellect and mental strength of children; based on the solid-state strength and active strength ,we should develop the parol creative power of children.

对幼儿人力整体协调关联、和谐发展的关注，使我们确定了幼儿言语教育人力开发目标：固性力发展目标要使幼儿言语方面的生理素质、知识储备和修养积累得到充分而和谐的发展；活性力发展目标包括开发幼儿的体力、智力和心力；在固性力和活性力的基础之上，开发幼儿的言语创造力。

Effects of dry temperature and dry time on properties of heat cured sand and the relationship with binder composition are as follows:sands bonded by binders that are not modified have high strength when dry temperature is high and dry time is long,but their anti-wettability power is poor . Sands bonded by binders that are modified by B but not modified by M can be dried quickly and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M but not modified by B can also be dried quickly to obtain maximum strength,then the strength becomes lower when they are dried continually for more time. and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M as well as by B at the same time can be dried quickly to obtain maximum strength at low temperature and short time. But the anti-wettability of sand mold is best when they are dried at high temperature and long time.

烘干温度和烘干时间对热硬砂性能的影响及其与粘结剂改性的关系是：未经改性剂B和改性剂M改性的粘结剂砂，脱水速度较慢，烘干温度越高，时间越长，则硬化强度也越高，但未经改性的粘结剂热硬砂的抗吸湿性较差；经改性剂B而不经改性剂M改性的粘结剂热硬砂，烘干硬化速度较快，强度也高，但在高湿度下的抗吸湿性不好；经改性剂M改性而不经改性剂B改性的粘结剂热硬砂，烘干时强度先随烘干时间升高至最大值后，继续烘干时强度又出现下降；经改性剂B和经改性剂M共同改性的粘结剂热硬砂能在短时间和较低的烘干温度下就可烘干到最高强度，即烘干脱水的速度较快，但试样的抗吸湿性差，若在更高温度和更长时间下烘干，试样的抗吸湿性得到改善，综合考虑烘干强度和抗吸湿性要求，对于φ30×30mm试样，理想的烘干温度是200℃，烘干时间20分钟。

These tests include colour fastness to rubbing/crocking, light, perspiration, water, chlorinated water and seawater; strength tests, namely of tensile strength, tearing strength, seam strength, slippage characteristics, bursting strength etc.; pilling resistance; oil repellence; soil release; air permeability; water vapour permeability; abrasion resistance; water repellence; zipper strength, durability and operability; velcro shearing and peeling; snap fastener security; and the corrosion of metallic finishes, etc.

这些测试包括磨擦、日晒、汗液、水、氯水和海水的色牢度；强度，即拉伸强度、撕裂强度、接缝强度、滑移特性、破裂强度等；抗起球特性；防油性；防污性；透气性；水气通透性；耐磨性；防水性；拉链的强度、耐用性和运作顺畅性；尼龙搭扣剪切力和剥离力；按扣强度；金属饰物的耐腐蚀性等。

This paper emphasized on the strength testing of paper-bag which was produced by Foshan Sanshui KelunPaper.Inc. The test was done according to the Chinese Standards（GB/T453—2002、 GB/T450—2002、GB9774—2002 etc.）.It showed that , the average CD ensile strength of a single paper is 2.96KN/m, above the normal value of 2.0 KN/m; The average MD ensile strength of a single paper is 3.88 KN/m, above the normal value of 3.8 KN/m; The combined CD ensile strength is 7.88 KN/m, above the normal value of 6.0 KN/m; The combined MD ensile strength is 11.91 KN/m, above the normal value of 11.4 KN/m.

本文针对佛山三水科伦纸业公司生产的纸袋进行了强度方面的测试，根据国家标准（GB/T453—2002、GB/T450—2002、GB9774—2002等），借鉴厂内已有的检测方法，测出了该厂生产用纸单层的横向抗张强度的平均值为2.96 KN/m，高于行业经验值2.0 KN/m；纵向抗张强度平均值为3.88 KN/m，高于行业经验值3.8 KN/m；组合横向抗张强度为7.88 KN/m，高于行业经验值6.0 KN/m；组合纵向抗张强度为11.91 KN/m，高于行业经验值11.4 KN/m。

Finally, the GPSE strength criterion for rock is verified by polyaxial test data of brittle rocks. The strength criterion for rock can be widely used to brittle rocks and allows for a good description of the several effects of stresses mentioned above, nonlinear characteristics of strength and marked difference for tensile strength and compression strength.

最后，通过对不同种类岩石多轴试验结果的验证分析，表明该准则能够较为合理地描述上述4种效应，而且能够反映非线性强度特征和拉压强度的显著区别，可广泛地适用于各种性岩石。

Results of the computation under the same welding temperature field show that the longitudinal residual stresses in the weld are as high as the yield strength of the plate in the strength and TEC evenmatched joints, lower than the yield strength of the plate in the strength evenmatched and TEC undermatched joints. It also has something to do with the strain hardening exponent of the weld metal in the strength evenmatched and TEC overmatched joints.

计算结果表明：等强等胀匹配的焊缝区纵向残余拉应力水平高达母材的屈服强度，等强低胀匹配的焊缝区纵向残余应力水平低于母材屈服强度，等强高胀匹配的焊缝区纵向残余应力水平还与焊缝应变硬化指数有关。

Through comprehensive comparison,during the growth from 1 age-degree bamboo to 2 age-degree bamboo,density, mechanical strength(except maximum tensile strength etc.),fraction of bundle sheath,cell wall ratio,crystallinity,cellulose content and lignin content increase rate are the greatest.3age-degree bamboo has higher strength,strength and gravity ratio andcrystallinity are the biggest,fraction of parenchyma is small and insect-resistant.2 degree bamboo has the greatest mechanical strength,but its strength andgravity ratio is not the highest and its crystallinity is lower than 3 age-degreebamboo due to its greatest fraction of parenchyma,loss tangent value is thebiggest.Its creep character is not good and is easily eaten by moth.

通过综合比较，竹材从1度竹到2度竹生长过程中，密度、力学强度、纤维束比量、胞壁率、结晶度、纤维素含量、木质素含量等指标增加幅度是最大的。3度竹强度较高，强重比、结晶度最高，薄壁组织含量较小，相对抗虫蛀，材质最好，适合材用。4度竹结晶度下降引起强度的下降，但薄壁组织组织比量最小，相对最抗虫蛀。2度竹力学强度最大，但是强重比并不是最大，结晶度比3度竹低，由于薄壁组织组织比量最大，内耗值最大，蠕变性能较差，同时相对易遭虫蛀。

The basic concept of FOP can be summarized as to further optimize effective prescription according to the standard of curative effects and with the aid of modern science and technology and theories of traditional Chinese medicine.

其基本内涵可概括为：以确有疗效的中药复方为研究对象，以现代科学技术和传统中医药理论为技术支持，以该复方所治病证的药效响应为评价标准，以优化重组疗效更优的新复方为研究目的。

Ever since our world has been a world, native forests have been indiscriminately exploited by man.

自从我们的世界一直是世界原生森林被任意剥削人。