查询词典 steel structure

The examination of the steel bar corrosion and the determination of the corrosion condition may provides the foundation data of the reinforced concrete structure residuary load and the structure durability.

钢筋腐蚀检测和腐蚀状况判定可为钢筋混凝土结构的剩余载荷和结构耐久性提供基础数据。

STRUCTURE: Titanium and composites used extensively, with particular emphasis on corrosion resistance; fully articulated three-blade coaxial contrarotatmg rotors have all-composites blades with carbon fibre and glass fibre main spars, pockets (13 per blade) of Kevlar-type material, and filler similar to Nomex; blades have non-symmetrical aerofoil section; each has ground-adjustable tab; each lower blade carries adjustable vibration damper, comprising two dependent weights, on root section, with further vibration dampers in fuselage; tip light on each upper blade; blades fold manually outboard of all control mechanisms, to folded width within track of main landing gear; rotor hub is 50% titaniuin/50% steel; rotor brake standard; all-metal fuselage; composites tailcone; fixed incidence tailplane, elevators, fins and rudders have aluminium alloy structure, composites skins; fins toe inward approximately 25°; fixed leading-edge slat on each fin prevents airflow over fin stalling in crosswinds or at high yaw angles.

结构：钛和复合材料广泛使用，耐腐蚀性能与特别强调，充分阐明三叶片转子同轴contrarotatmg有碳纤维和玻璃纤维的主要棒材全复合材料桨叶，口袋（每刀片13）凯夫拉型材料，类似的Nomex纤维填料；叶片非对称机翼部分，每有地面可调选项卡，每降低叶片振动阻尼器进行调节，包括两部分依赖重根，在机身进一步减振装置；小费每个刀片上轻；刀片倍手动舷外所有控制机制，折叠宽度内的主起落架的轨道；转子中心为50％titaniuin/50％钢；转子制动标准；全金属机身，复合材料tailcone，固定发生机尾，电梯，蛙鞋和方向舵的铝合金结构，复合材料的皮肤；鳍鳍在每个脚趾向内约25 °；固定领先的板式翅片防止了侧风或气流停滞在高偏航角度。

The finite element analysis shows that the two kinds of trial designs meet demand.(3) Compared the static behavior of three kinds of designs with each other, the results show that using the steel web concrete combined box tie beam can reduce the structure internal force and is beneficial to structure stability.

采用波形钢腹板组合系梁和平钢腹板组合系梁进行了钢管混凝土拱梁组合桥的试设计，并进行对其有限元分析，结果表明两种试设计方案均满足受力性能要求。

Jacket platform was assumed as steel frame structure and multi-objective design method was performed. Total weight and stability of the structure and were selected to be optimal objectives.

以结构的总重量和结构构件的长细比为优化目标，以导管的平均直径和壁厚作为设计变量，考虑强度、刚度和稳定等约束条件。

The wind tunnel experiment,project argument,structure calculation analysis, calculation of the joint bearing capacity, calculation and experiment of the support-joint load carrying capacity of a super-span stretched stereoscopic steel pipe trussing are introduced- A normal usage period of the project after it had been built indicates that the major trussing and the supporting structure below have enough bearing capacity and deformability, and meet the demands of design code and actual usage.

摘要］介绍了某超大跨度伸臂立体管桁架结构的风洞试验、方案论证、结构计算分析、节点承载力验算、支座节点承载力验算和试验等。该结构建成后一段时期的正常使用表明，工程的主体桁架和下部承力结构具备较强的承载变形能力和可靠的安全度，满足设计规范和实际使用要求。

Results show that the hybrid structure is is provided with antiseismic behavior well . steel frame-corewall structure; shaking table test; antiseismic behavior

试验表明，这种结构具有良好的抗震性能，试验结果为规范修订和工程设计提供了参考依据。

How to ensure this new structure to be in elastic state under frequent earthqu ake, be mendable under design earthquake and not collapse under infrequent earthquake, especially the last item, is the problem to be solved imminently in engineering field. Center around this problem, 5 aspects of investigation are carried out as following:(1) The experiment of seismic performance of ASCCs in this new frame structure has not been reported, in order to study this problem, 9 ASCC specimens with shear steel plate are tested subjected to the horizontal low cyclic loading, in which, the shear span ratio is 3 and axial compression ratio is different. The hysteretic curves of 9 specimens are obtained. The seismic performance indexes such as energy dissipation, stiffness degradation, strength degradation, skeleton curves and ductility of this kind of column are acquired, and the seismic fortification measures including ultimate values of axial compression ratio under different seismic degree are suggested.

1新型框架结构中所采用的角钢混凝土柱抗震性能的试验研究尚未见报道，针对这一问题，本文进行了9根剪跨比为3、不同轴压比、采用钢板箍的角钢混凝土柱在水平低周反复荷载作用下的试验研究，获得了9根试验柱的滞回曲线，考察了该类柱的耗能、刚度退化、抗力衰减、骨架曲线及延性等抗震性能指标，建议了角钢混凝土柱在不同抗震等级下的轴压比限值等抗震构造措施。

The coatings formed on Q235 steel possess microcrystalline structure, with a thickness about 100 m. The micro-crystal line structure is achieved due to the high cooling rate during deposition. The quality of the coatings is enhanced by using Ar to protect samples from oxidation. The coatings are metallurgically bonded to the substrate without obvious interface.

采用振动式电脉冲沉积技术沉积涂层时，铝电极与工件瞬时接触放电，可以达到很高的温度，从而形成了铁铝金属间化合物涂层，而且涂层与基体为冶金结合；涂层冷却速度很快，由此获得微晶结构涂层；流动的氩气可有效地保护涂层的质量。

With an actual gymnasium of a long-span spatial steel-cable-membrane hybrid structure as the cal- culation model,both static and dynamic analyses were performed by employing the global analysis for the whole hybrid structure,and the substructural analysis for the truss arch substructure,and the cable-membrane substructure etc.,and the stresses and displacements of structural members were compared during global and substructural analyses.

在复杂的混合结构体系中，结构形态呈三维状态，在荷载作用下具有三维受力特征并呈空间工作'，，〕，结构之间的相互作用越来越不直观。同时，由于一些大跨度空间结构中包含了柔性部分，使结构的几何非线性行为成为必须考虑的因素，从而结构构件的内力改变与边界条件、荷载的变化关系就更加难以估计。

Researching of Design Method and Capability of Tube Structure Possessed Double Helix-Cantilever Trusswork;2. The results show that the structure meets performance requirements of design,columns and shear-walls,steel members of cantilever and.

计算分析结果显示，结构在中震作用下所有柱及剪力墙未发生屈服、悬挑部分钢结构及其支撑柱保持弹性，实现了性能设计提出的性能目标，说明基于性能的抗震设计提高了结构的抗震性能，保证了&大震不倒&的设防目标。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。