查询词典 steady state

By regression of experimental data, therules of the linkage between these factors, which will provide a theoretical basis for designing BBP with different scales.3 Using thermal analysis technology and dynamic thermogravimetry, the paper studies combustion kinetic characteristics of 3 types of agricultural crops at different rate of temperature rise, and thus, achieved dynamic parameters of these fuels at different rate of temperature, established dynamic model of straw combustion, which reflects the dynamic process in the fast combustion area.4 Characteristics of straw briquette combustion was experimented, focusing on the impact of straw type, temperature, air supply, and density, diameter, and weight of briquette on the combustion speed, and the following conclusions were drawn:(1) combustion of straw briquette fuel is static permeation diffusion combustion;(2) temperature has a larger impact on the speed of straw briquette combustion than air supply; the higher the combustion temperature is, the faster volatilizable component separates out, and the less steady the combustion is;(3) density of briquette fuel has impact on the speed of volatilizable component separation and therefore the combustion speed;(4) increase of diameter and weight of briquette fuel increases the average combustion speed in the initial stage, and that in the later stages is comparatively steady;(5) the proportion of volatilizable component in straw briquette fuel is high, therefore, the temperature control during combustion under the rational ventilation condition is essential to ensure its safe combustion.5 Using the above-mentioned results of experiments and theoretical analysis, and based on thought of hydraulic driven and bi-direction compression, the hydraulic system and compression parts of the HBP BBP are re-designed in terms of industrialization.

利用热分析技术，采用动态热重实验法，对我国的三大农作物秸秆在不同升温速率下的燃烧动力学特性进行了较系统的研究。得到了各原料在不同升温速率下的动力学参数；建立了秸秆燃烧的动力学模型，该模型反映了秸秆迅速燃烧区的动力学过程。 4 对秸秆成型燃料的燃烧特性进行了试验研究。着重研究了秸秆河南农业大学博士学位论文巫的种类、温度、空气供给量、成型燃料密度、直径、质量对成型燃料燃烧速度的影响并得出如下主要结论：①秸秆成型燃料的燃烧方式属于静态渗透式扩散燃烧。②秸秆成型燃料燃烧速度受温度的影响大于通风量燃烧速度的影响：燃烧温度越高，挥发分析出速度越快，燃烧平稳性愈差。③成型燃料密度影响成型燃料挥发分的析出速度，影响燃烧速度。④成型燃料直径和质量的增加，使得燃烧初期的平均燃烧速度增大，中后期的平均燃烧速度相对平稳。⑤秸秆成型燃料含挥发分比例高，因此合理配风下的控温燃烧是保证其完全燃烧的关键。 5运用已取得的试验和理论分析结果，以液压驱动、双向成型为基础，从产业化的角度对HBP型成型机进行了液压系统和成型部件的改进设计；同时采用了二级预压机构，使该成型机的生产率达到 500kg.hd；单位能耗 60kwh。上'左右，磨损件修复周期 300小时左右，基本解决了影响生物质固化技术在国内推广的技术难题。

ON a brisk autumn afternoon, in the shadow of the marble arch in Washington Square Park, a couple visiting from Ohio walked along holding hands like two teenagers going steady, decades after "going steady" went out of vogue.

一个轻松的秋日午后，在华盛顿广场公园大理石拱门旁边，一对来自于俄亥俄州的夫妻手牵手在漫步，如同两个相互深爱的年轻人，但十年后的&深爱&已经缺少了一些时尚。

After the incident of "911", international situation especially the fluctuation of geo-strategic structure and form in the Pacific Asia region, make the strategic situation of Chinese peripherally took place deeply, peripherally the indetermination increment in the neighboring geo-environment, totally present the land steady seas move, the land appeases sea tight" up with the complicated situation of the north is steady, south and, the east is , the west is heavy".

9·11&事件后，国际局势特别是亚太地区地缘战略格局的变动，使中国周边地缘战略形势发生了深刻的变化，周边地缘环境中的不确定性增加，总体上呈现&陆稳海动、陆缓海紧&和&北稳、南和、东急、西重的复杂态势。

The Earth's atmosphere seeks a steady oxygen level much as a thermostat hones in on a steady temperature.

地球大气寻求稳定的氧含量，与恒温器寻求稳定的温度非常相似。

The Earth's atmosphere seeks a steady oxygen level much as a thermostat hones in on a steady temperature.

地球大气寻求氧气水平稳定，就像恒温器保持稳定的气温。

The yearly export amount is 40-50tons, that have been sold to Thailand, Philippines Singapore, Malaysia, South Korea, Japan etc. countries and areas, they are selling very good in domestic and international market with steady price. Export 1 Kg of antler is equal to the profit of exporting 2 tons to 4 tons of soybean. to 4 tons of xport arket with steady price..re rouped and listed into the plan Shuangyang Deer Development Co.

鹿茸是我国传统的出口商品，年出口量40—50吨，远销泰国、菲律宾、新加坡、马来西亚、韩国、日本等国家和地区，在国内和国际市场上销路好，价格坚挺，出口1公斤鹿茸相当于出口2吨大豆或4吨玉米的效益。

In this paper, as a typical lewis acid, anhydrous aluminum (AlCl_3) was used as the catalyst to get PP/PS blends compatibilized by in-situ Fridel-Crafts alkylation. The effects on PP and PS components of AlCl_3 were investigated first, mainly by rheology, including steady rheology method and dynamic rheology method. Then the in-situ reactions in PP/PS alloys under different conditions were executed and studied in detail by selective Soxhlet solvent extraction. And at the same time, the evolutions of phase structures of PP/PS and the resulted PP/PS/AlCl_3 alloys were investigated by SEM and SALS. The steady and dynamic rheological behaviors of in-situ compatibilized PP/PS alloys were obtained systematically.

本文选用典型路易斯酸无水氯化铝(AlCl_3)作为催化剂，利用烷基化反应机理，对PP/PS合金直接进行原位催化反应增容，以流变学方法(包括静态流变和动态流变学方法)为主，详细探讨无水AlCl_3对PP/PS合金体系中PP和PS两组分的影响，并在此基础上进一步系统研究无水AlCl_3原位催化增容PP/PS合金的相结构演变及增容反应特征，然后对不同原位催化增容条件下获得增容合金材料的流变行为特征作了深入探讨。

The inflow rate along the wellbore is not equivalent, but distributes like"U"shape, and inflow rate of the two ends is higher than that of the middle part. When the inflow reaches its pseudo steady flowing, the distribution shape of flowing keeps steady.

5井筒压降80％出现在距水平井跟端50％的井长内，沿水平井简单位长度的流入量并不相等，沿井筒形成U形流入分布，在水平井的两端的流入比井筒中部的流入相对要高，一旦达到拟稳态流动，沿井筒的流入分布形状基本保持不变。

This paper presents the modeling with the state space averaging method, and steady state theoretical analyses of the converter.

该文运用状态空间平均法对这种新型拓扑进行建模和稳态理论分析。

PART 1 UNIT 1 B Electrical and Electronic Engineering Basics A Electrical Networks ———————————— 3 Three-phase Circuits A The Operational Amplifier ——————————— 5 UNIT 2 B Transistors A Logical Variables and Flip-flop —————————— 8 UNIT 3 B Binary Number System A Power Semiconductor Devices —————————— 11 UNIT 4 B Power Electronic Converters A Types of DC Motors —————————————15 UNIT 5 B Closed-loop Control of DC Drivers A AC Machines ———————————————19 UNIT 6 B Induction Motor Drive A Electric Power System ————————————22 UNIT 7 B PART 2 UNIT 1 B Power System Automation Control Theory A The World of Control ————————————27 —————29 The Transfer Function and the Laplace Transformation UNIT 2 B A Stability and the Time Response ————————— 30 Steady State————————————————— 31 A The Root Locus ————————————— 32 ————— 33 UNIT 3 B The Frequency Response Methods: Nyquist Diagrams UNIT 4 A The Frequency Response Methods: Bode Piots ————— 34 B Nonlinear Control System 37 UNIT 5 A Introduction to Modern Control Theory B State Equations 40 38 UNIT 6 A Controllability, Observability, and Stability B Optimum Control Systems UNIT 7 A Conventional and Intelligent Control B Artificial Neural Network Computer Control Technology A Computer Structure and Function 42 B Fundamentals of Computer and Networks 43 44 PART 3 UNIT 1 UNIT 2 A Interfaces to External Signals and Devices B The Applications of Computers 46 UNIT 3 A PLC Overview B PACs for Industrial Control, the Future of Control UNIT 4 A Fundamentals of Single-chip Microcomputer 49 B Understanding DSP and Its Uses 1 UNIT 5 A A First Look at Embedded Systems B Embedded Systems Design Process Control A A Process Control System B 50 PART 4 UNIT 1 Fundamentals of Process Control 52 53 UNIT 2 A Sensors and Transmitters B Final Control Elements and Controllers UNIT 3 A P Controllers and PI Controllers B PID Controllers and Other Controllers UNIT 4 A Indicating Instruments B Control Panels Control Based on Network and Information A Automation Networking Application Areas B Evolution of Control System Architecture PART 5 UNIT 1 UNIT 2 A Fundamental Issues in Networked Control Systems B Stability of NCSs with Network-induced Delay UNIT 3 A Fundamentals of the Database System B Virtual Manufacturing—A Growing Trend in Automation UNIT 4 A Concepts of Computer Integrated Manufacturing B Enterprise Resources Planning and Beyond Synthetic Applications of Automatic Technology A Recent Advances and Future Trends in Electrical Machine Drivers B System Evolution in Intelligent Buildings PART 6 UNIT 1 UNIT 2 A Industrial Robot B A General Introduction to Pattern Recognition UNIT 3 A Renewable Energy B Electric Vehicles UNIT 1 A

电路 2 电路或电网络由以某种方式连接的电阻器，电感器和电容器等元件组成。如果网络不包含能源，如电池或发电机，那么就被称作无源网络。换句话说，如果存在一个或多个能源，那么组合的结果为有源网络。在研究电网络的特性时，我们感兴趣的是确定电路中的电压和电流。因为网络由无源电路元件组成，所以必须首先定义这些元件的电特性。就电阻来说，电压-电流的关系由欧姆定律给出，欧姆定律指出：电阻两端的电压等于电阻上流过的电流乘以电阻值。在数学上表达为： u=iR (1-1A-1)式中 u=电压，伏特；i =电流，安培；R =电阻，欧姆。纯电感电压由法拉第定律定义，法拉第定律指出：电感两端的电压正比于流过电感的电流随时间的变化率。因此可得到：U=Ldi/dt 式中 di/dt =电流变化率，安培/秒； L =感应系数，享利。电容两端建立的电压正比于电容两极板上积累的电荷 q 。因为电荷的积累可表示为电荷增量 dq 的和或积分，因此得到的等式为 u=，式中电容量 C 是与电压和电荷相关的比例常数。由定义可知，电流等于电荷随时间的变化率，可表示为 i = dq/dt。因此电荷增量 dq 等于电流乘以相应的时间增量，或 dq = i dt，那么等式(1-1A-3)可写为式中 C =电容量，法拉。

Through comparing with the results by simulation to study the effects of theprojectile"s final velocity, the angle of rotation and the ballistic trajectory"s migration withdifferent projectile"s rotating speeds, different target"s moving speeds and differentpenetration angles.

通过比较数值模拟的结果来研究不同弹头转速、目标速度、侵彻角对侵彻过程中弹头最终速度、翻转角度和弹道偏移的影响。

I love stationery and all the accoutrement of writing.

我爱文具以及所有的书写的工具装备。