查询词典 static object

Mechanical seal assembly: In the dynamic and static loop mirror coating on the 20th floor cleaner lubricants; add lubricant bearing guided, first gently positioning ring static load bearing guide; longer shaft add the oil, the mechanical seal part of the dynamic ring gently into the shaft, the hand-push retractable seal ring should be able to freely (Note that dynamic and static part of the anti-ring to the assembly site to be in place).

机械密封装配：在动、静环镜面上涂一层洁净的20号润滑油；导轴承座抹上润滑油，先把静环轻轻定位装入导轴承座；再在泵轴上抹上润滑油，把机械密封的动环部分轻轻装入泵轴上，用手轻推密封环应能伸缩自如（注重动、静环部分的防转部位需装配到位）。

In the literature, many static and dynamic hedgings are proposed to solve this hedging problem. Since dynamic hedging comprises more relocation opportunities than static one, it is usually superior to static hedging in terms of risk reduction.

文献上常以静态避险或动态避险处理此避险问题，但静态避险不易规避大部分的期末风险，而动态避险虽可透过连续交易与变动其避险部位以降低期末风险，但也因此需要付出较多的交易成本。

The static, modal and harmonic analysis was performed in ANSYS; static capacitance, natural frequencies for the short circuit case and the open circuit (anti-resonance) case, dynamic resistance, frequency at half-power point, dynamic inductance and mechanical quality factor were computed via static, modal analysis and harmonic analysis.

为了加速低频超声雾化栽培喷头的设计制造进程、降低研发成本，该文提出了其阻抗的测试原理电路图，建立了阻抗分析的有限元模型，在大型通用有限元分析软件ANSYS中进行了静态分析、模态分析和谐响应分析。

The Company is a professional long-term production of a variety of conductive fabric, lining, bags material manufacturers, anti-static function tests through national authorities through the existing anti-static polyester has more than 20 kinds of varieties, polyester, plain weave, twill , knitting cloth anti-static, conductive wire spacing from 0.25CM to 2.54CM, lattice and has two kinds of notes, a variety of suitable electronic factory, hospital, pharmaceutical factory, the carbon, oil, electricity and clean workshops, and other business make overalls, the Company spun mainly Japan, the United States Solutia two kinds of conductive yarn, permanent within the wash.

本公司是专业长年生产各种导电面料，里料，箱包料的生产厂家，防静电功能通过国家权威机构测试通过，现有防静电品种二十多种有涤纶，涤棉，平纹，斜纹，针织防静电布，导电丝间隔从0.25CM到2.54CM，有格子和条子二种，适合各种，电子厂，医院，药品厂，工碳，油田，电力和各种洁净车间，等企业界做工作服，本公司主要采用日本中纺，美国首诺二种导电纱，永久性内洗。

The article elaborated anything is first static electricity balanced and the static electricity balanced condition as well as under the static electricity equilibrium condition conductor charge distribution situation proof.

文章先论述了什么是静电平衡和静电平衡的条件以及在静电平衡条件下的导体的电荷分布情况的论证。

The state-of-the-art of chemical process and equipment intensificationtechniques is reviewed. A novel concept of compact industrial furnace isproposed, in which tube with static mixer for partly intensification is determined. 2 A virtual engineering scale-up approach is put forward. The key points toimprove the scaling-up efficiency include two tools: one is rapid generationtechniques for computational models in which a re-use library is built, the otheris rapid prototyping manufacturing, employed for rapid generation forexperimental models.3 The tube is the key component for industrial furnace. Material microstructure,high temperature strength, and casting process of the tube with static mixer arediscussed as compared with those of traditional tube. Some special features ofthe static mixer tube are demonstrated.4 An evaluation method of velocity-based disturbance effect of fluid field wasproposed.

主要内容包括： 1、总结了化工过程强化技术的现状和强化研究的途径，提出了紧凑式工业炉的概念，确定用静态混合式炉管进行局部强化。2、提出了静态混合式炉管应用的虚拟工程放大研究方法，指出研究中提高效率的关键是计算模型快速生成技术和实验模型的快速原型制造。3、对工业炉的关键部位——炉管，从材料成分、强度、制造等方面对静态混合式炉管的设计、制造进行了分析，与常规炉管对比，说明了静态混合式炉管的独特性和要求。4、应用快速原型方法，迅速、准确地得到了符合精度、强度要求的静态混合式炉管模型，产品的精度和强度完全符合要求，提高了模型制造效率。5、应用计算流体动力学方法，进行静态混合式炉管的工程放大研究。

At the initial observation of leakage, judge on the leaking part of the foundation, and then manually set car observation, if the leakage were no significant changes in static and dynamic sealing ring has questions; such as disk when leakage can be concluded that there is significant change are moving , static friction ring problem exist; such as leakage of medium along the jet axis, the actin ring seal problem exist mostly, leakage to the surrounding medium or from the water spray cooling holes in the leakage, the many for the static seal ring failure.

在初步观察泄漏量、判断泄漏部位的基础上，再手动盘车观察，若泄漏量无明显变化则静、动环密封圈有问题；如盘车时泄漏量有明显变化则可断定是动、静环摩擦副存在问题；如泄漏介质沿轴向喷射，则动环密封圈存在问题居多，泄漏介质向四周喷射或从水冷却孔中漏出，则多为静环密封圈失效。

Leakage in the initial observation to determine the basis of the leakage site, and then manually set car observation, if the leakage were no significant changes in static and dynamic sealing ring problem; such as the disk when there are significant changes in leakage can be concluded that the dynamic , static friction ring problems; such as leakage of medium along the jet axis, while moving most of Central ring problems, leakage to the surrounding medium or from the water spray cooling holes in the leakage, the seal ring for static failure.

在初步观察泄漏量、判断泄漏部位的基础上，再手动盘车观察，若泄漏量无明显变化则静、动环密封圈有问题；如盘车时泄漏量有明显变化则可断定是动、静环摩擦副存在问题；如泄漏介质沿轴向喷射，则动环密封圈存在问题居多，泄漏介质向四周喷射或从水冷却孔中漏出，则多为静环密封圈失效。

Leakage in the initial observation to determine the basis of the leakage site, and then manually set car observation, if the leakage were no significant changes in static and dynamic sealing ring problem; such as the disk when there are significant changes in leakage can be concluded that the dynamic , static friction ring problems; such as leakage of medium along the jet axis, while moving most of Central ring problems, leakage to the surrounding medium or from the water spray cooling holes in the leakage, the seal ring for static failure.

在初步察看泄漏量、断定泄露部位的基本上，再手动盘车视察，若泄漏量无显明变更则静、动环密封圈有问题；如盘车时泄漏量有显著变更则可判断是动、静环摩擦副存在问题；如泄漏介质沿轴向喷射，则动环密封圈存在问题居多，泄漏介质向四周喷射或从水冷却孔中漏出，则多为静环密封圈失效。

Leakage in the initial observation to determine the basis of the leakage site, and then manually set car observation, if the leakage were no significant changes in static and dynamic sealing ring problem; such as the disk when there are significant changes in leakage can be concluded that the dynamic , static friction ring problems; such as leakage of medium along the jet axis, w你好le moving most of Central ring problems, leakage to the surrounding medium or from the water spray cooling holes in the leakage, the seal ring for static failure.

杂质泵安装静试时泄漏机械弥缝安装调试好后，一般要进行静试，察看泄漏量如泄漏量较小，多为动环或静环弥缝圈存在问题；泄漏量较大时，则表白动、静环磨擦副间存在问题在开端察看泄漏量、判断泄漏部位的根蒂根基上，再手动盘车察看，若泄漏量无明显变化则静、动环弥缝圈有问题；如盘车时泄漏量有明显变化则可下定论是动、静环磨擦副存在问题；如泄漏介质沿轴向喷洒，则动环弥缝圈存在问题居多，泄漏介质向四周喷洒或从水冷却孔中漏出，则多为静环弥缝圈失效此外，泄漏通道也可同时存在，但一般有主次区分，只要察看细致，认识结构，一定能正确判断

Article 144 The Government of the Hong Kong Special Administrative Region shall maintain the policy previously practised in Hong Kong in respect of subventions for non-governmental organizations in fields such as education, medicine and health, culture, art, recreation, sports, social welfare and social

第一百四十四条香港特别行政区政府保持原在香港实行的对教育、医疗卫生、文化、艺术、康乐、体育、社会福利、社会工作等方面的民间团体机构的资助政策。原在香港各资助机构任职的人员均可根据原有制度继续受聘。

Small wonder, then, that the Chinese spend more in the shop than any other group of foreign visitors do .

这样的小惊喜，使中国顾客比任何国家的人消费得更多。