查询词典 static load

It is meaning to research on the compressive characteristic of concrete small hollow block walls with concrete core columns in order to make use of the material well and improve characteristic of the walls.To concrete small hollow block walls, five modes of block walls of different ratio of height to width have been made. The Characteristic of the block walls of different ratio of height to width with horizontal load and vertical load have been analyzed.

对不同的高宽比的砌块砌体墙在不同的竖向荷载作用下的水平抗剪性能进行了数值分析，计算了墙体的水平开裂荷载和破坏荷载，模拟了墙体从开裂到破坏的全过程，分析了不同的竖向荷载和不同的高宽比对墙体水平抗剪性能的影响。

Based on the analysis of the experimental results of flue gas temperature distribution in horizontal flue in a 300MW pulverized coal tangentially fired boiler at variable load, the characteristics of the flue gas temperature distribution in horizontal flue of this boiler at variable load are summarized in this paper.

通过对某 3 0 0 MW四角布置切圆燃烧锅炉在变负荷工况下水平烟道内烟温分布的现场试验结果的分析，指出了四角布置切圆燃烧锅炉水平烟道内烟温分布的特点及其随负荷变化的规律。

The shipper would need to either floor load it evenly across side to side and front to back by not stacking high or , load it in then block and brace .

该托运人需要将货物平均装载在地板上，使每块地方平均受力(货柜的侧面连着另一个的侧面，前面连着另一个的后面)，不能堆积太高，装载时用石块和柱子支撑。

In accordance with axle load and speed and average deceleration on the basis of stopping brake energy and average axle braking power,it is calculated and compared braking heat load of different railway cars.

文中根据轴重、速度和紧急制动能力，对不同客货车辆的制动热负荷从停车制动能量和平均轴制动功率两方面进行了计算比较。

Aiming at this problem, firstly, calculation formulae of utilization adhesion coefficient after installment of retarder were detailedly deduced. Then braking force distribution ratio , braking intensity and vehicle full-load parameters were taken as variables and inequalities which are about of retarder braking force , braking force distribution ratio , braking intensity and vehicle full-load parameters were established based on the ECE Law. The range of corresponding to any , as well as the most optimal matching between them, were obtained by solving these inequalities.

为此，论文在推导了安装缓速器后前、后轴利用附着系数、的计算公式基础上，基于ECE法规要求，以制动力分配比、制动强度及车辆满载参数为变量，建立了缓速器制动力关于车辆制动力分配比、制动强度和满载参数之间的多元不等式组，通过求解多元不等式组获得缓速器制动力与制动力分配比之间的取值关系，并从中得到二者之间的最优匹配。

DETERMINATION OF BREAKING LOAD AND KNOT BREAKING LOAD OF NETTING YARNS.

鱼网用线的断裂强度和打结处的断裂强度的测定方法

Depending on the class society there are differentsafety factors between SWL Proof load and Breaking load points.

定现有的绑扎件的破断负荷是在同一水平上的所得到的安全工作负荷也是不同的。

Determination of the breaking load and elongation at the breaking load.

断裂强度和断裂伸长率的测定

For sizes 30 thru 175 metric tons,breaking load is 5.4 times the working load limit.

注释：最大验证负荷为2倍工作极限 30t-175t破断负荷为5 4倍工作极限负荷；。

Note: 1. Except for basic load, we also produce JF35 series tie downs with breaking load of 2000kg.

注：1。除基本型负荷外，还生产破断负荷2000kg的JF35系列捆绑带。

Some of them were ligated to the plasmid vector pCR 2.1 andsequenced,respectively.

将所获DNA片段克隆到pCR2.1载体进行测序，并与基因组数据库进行同源性比较。

Thinking since Google owns Blogger, I would be able to escalate this issue to the support team.

自谷歌的思考拥有Blogger的，我将能够缓解这一问题的支持团队。