查询词典 static load

Is clear about above the saccharorrhea medical history for 5 years to doubt examines the coronary disease person 71 examples,in 2 weeks successively line of Pakistan phenol butylamine load-static state cardic muscle raster display and movement ultrasonic cardiogram.

结果：美他多辛治疗酒精性脂肪肝可明显改善患者的临床症状，总有效率为94.7%，与对照组相比有显著性差异（P＜0.05）。结论：美他多辛可有效改善酒精性脂肪肝患者的临床症状和肝功能，可降低血脂，且无严重不良反应，值得临床推广。

Based on the HSPICE simulations, the proposed trigger has full swing, no static current. And it's transmission delay has little influence by load captance. With these characteristics, this circuit is very suitable for lower voltage and low power, high speed applications.

该电路采用0.6μm的CMOS工艺设计，并通过HSPICE验证，表明这种施密特触发器具有全摆幅输出、几乎不存在静态功耗、传输延迟几乎与负载无关等优点，比较适合在低电压、低功耗、高速便携设备中应用。

The aerostatic stability analysis of the gantries and main arch ribs under wind load is accomplished by ANSYS program. Firstly, the CFD module of ANSYS is used to compute the aerostatic force coefficients of arch ribs sections. And then, the static and stability analysis of gantries and main arch ribs under several construction statuses is completed.

门式膺架和主拱肋的静风稳定性分析利用ANSYS程序进行，首先通过ANSYS的CFD模块计算主拱肋断面的静力三分力系数，然后对门式膺架和主拱肋进行各种施工状态下的静力和稳定性分析。

Researching the static performance of angle-contact ball bearings in this paper, the load and deformation characteristics of the rolling bearing under axial and radial loads are studied by using the quasi-dynamic method on the basis of Hertzian contact theory.

研究角接触球轴承的静态性能时，本文主要在Hertz接触理论的基础上采用拟动力学方法，研究了轴向和径向载荷作用下滚动轴承的承载和变形特性，推导了轴承的轴向和径向刚度公式，并进行了实例计算。

Incurrent research, aiming at the rupture problem engendered in the shooting process of acertain 5.56mm automatic rifle, the strain and stress distributions on the cartridge caseunder the action of axial pull have been analyzed. Based on the theories of elastic-plasticmechanics and contact mechanics, a mathematic and physical model of the cartridge-caseand chamber system has been set up; and based on the platform of the general softwarepackage APDL of ANSYS for finite element analysis, a parameterized model of thecartridge-case and chamber system has also been established. The method for nonlinearFEA has been adopted to analyze the stress distribution on the entire cartridge-case andchamber system, and the method of contact element has been employed to investigate thecontact stress between the cartridge case and chamber, and then the influences of frictioncoefficient and locking space on the static and dynamic stress and strain response of thecartridge case and chamber to the action of power gas have also been discussed. On thebasis of a lot of numerical tests, a kind of element Plane13, which is concentrated incoupled computation of heat and construction, has been used finally to simulate thetransient response of the cartridge-case and chamber system to the power gas. Throughloading the temporary thermal characteristics of explosive gas in the procedure of emulate, the corresponding transient thermal stress distributed on the entire system under thecombined load of transient thermal stress and transient pressure has been obtained. Owingto these comprehensive considerations, the numerical results obtained in this paperrepresent the actual situations comparatively exactly.

本文针对某5.56mm自动步枪在工作中出现断壳的问题，分析了弹壳在轴向拉力作用下的应力应变；基于弹塑性力学及接触理论，建立了弹壳弹膛系统的数学、物理学模型，在通用有限元ANSYS软件的参数化建模工具APDL平台上，建立了弹壳弹膛系统的参数化模型；采用非线性有限元法计算了弹壳弹膛系统的整体应力，引入接触单元法分析弹壳和弹膛的接触压力，探讨了在不同的摩擦系数和不同的闭锁间隙对弹壳弹膛静、动态响应的影响；本文进行了大量的尝试，最后确定采用热、结构耦合单元Plane13，在计算中加载了火药气体的温度历程，成功的获得了弹壳弹膛系统在瞬态的热载荷和瞬态的压力载荷同时作用下弹壳弹膛系统的热应力数值解，考虑因素全面，比较真实的反映了弹壳弹膛系统在火药气体压力和热载荷下作用的情况。

Both of conventional continuous medium mechanics and noncontiguous medium mechanics, having strong pertinence, can abstract and simplify the rock model in research procedure, in which the rock body lying over the coal face can be considered as a static beam or board to leave out the push changes and the changes of property and load during the stability of overlying rock deformation has lost. Hence the derived profile equation is only the approximate expression of final subsidence of surface after the mining finished, and it is difficult to obtain the dynamic subsidence process of rock body.

传统的连续介质力学和非连续介质力学均具有针对性，在研究过程中将岩体模型抽象简化，将工作面上方的岩体看成是一静止的梁、板，省略了工作面的推进变化及覆岩在变形失稳时的性质和载荷的变化，得出的剖面方程仅是开采结束后地表的最终沉陷近似表达式，难以得到岩体的动态沉陷的过程。

The effect of static aeroelastic distortion to the aerodynamic characteristic for a real high-aspect ratio sweepforward wing of composite material under different load statuses was analyzed. The integrated design method combined aerodynamic with structural was adopted in this analysis using associated computational fluid dynamics program FLUENT and computational structual dynamics program NASTRAN.

针对－真实复合材料大展弦比前掠机翼，采用气动／结构一体化的分析方法，利用计算流体动力学软件FLUENT和计算结构动力学软件NASTRAN联合求解，研究了在不同载荷情况下大展弦比柔性机翼静气动弹性变形对机翼气动特性的影响。

The static analysis for the flat reflector of interferometer in unassembled and assembled is studied by finite element method, horizontal and vertical placement under gravity load is analyzed. The calculated PV and RMS values are used to determine whether the distortion and the structure of fixation are reasonable or not.

应用有限元方法对干涉仪的装配前后的平面反射镜进行了静力学分析，对其在重力作用下水平和垂直放置时进行了分析，通过计算镜面变形的PV值和RMS值来评价是否超差及固定反射镜的结构是否合理。

Then wind-induced-vibration response of guyed mast is simplified to that of quasi-static wind load.

于是，结构的风振响应简化为相对简单的拟静力风荷载响应。

The explanation to that is rather simple: in a static posture, the load falls on the same muscles and they are overstrained.

原因很简单：姿势固定，负重落在同一肌肉群，造成过度疲劳。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。