查询词典 stability region

For some rock slopes, which have not distinct failure surface, but have complicated structure or load on the top and so on, a stability analysis of this type slopes by finite element method is presented, the failure surface is defined by certain rule or strain zone from the computed model, and then the safety factor of the rock slope is abtained by finite element method and limit equilibrium methodAt last, using ANSYS , a famous commercial finite element analysis software, a example of high-steep slope which is bearing the load of the LongGe Mansion is presented, the stability of this slope is studied, as a paradign the the stability evalution of complicated high-steep slope under the action of load of building , the chapter gives some meritable reference in stability assessment of rock slopes using numerical simulation by three-dimension elastic-plastic finite element.

并用有限单元法建立边坡的具体模型，应用折减边坡岩体参数、逐级施加荷载等与边坡工作环境相似的方法进行模拟计算，根据计算结果，采用一定的判别准则或图形可视化方法，确定出边坡的滑裂面，再采用刚体极限平衡法或有限单元法计算其安全系数；最后，通过某一工程实例，用大型有限元程序对边坡在建筑物荷载作用下的稳定性进行分析研究，并以此作为计算分析复杂高边坡在高层建筑物作用下的稳定性评价的一个范例，在采用有限元弹塑性数值模拟岩质边坡稳定性方面提供一些有价值的参考。

A new method and the principle is presented for plotting the critical metacentric height curve which meets IMOs intact stability criteria and weather criteria,and the critical metacentric height curve which meets 1976 SOLAS intact stability criteria. And the critical metacentric height curve is used in the Stability check of bulk grain carriers in accordance with the stability rules for bulk grain carriers.

本文还具体给出了满足IMO完整稳性和天气衡准的临界初稳性高度的求作方法，以及满足1976 SOLAS公约散装谷物船舶的稳性衡准要求的临界初稳性高度的原理和求作方法，并将由此得到的临界初稳性高度曲线综合运用到散装谷物船舶的稳性校核。

In this paper, the effect of wheat juice boil on the nonbiological stability, biological stability, flavor stability and foam stability of beer are discussed.

本文论述了麦汁煮沸对啤酒非生物稳定性、啤酒生物稳定性、啤酒风味稳定性和泡沫稳定性的影响。

The results show that: from the subcircuit that is furthest to the heat source to the nearest one,the stability of DRS becomes gradually worse;the stability of RRS is symmetrical,with the subcircuit in the middle of the pipe-network having the worst stability,while,the nearer to the two ends,the better the stability of the subcircuits is.

结果表明，异程系统从离热源最近的支路到最远支路，稳定性依次变差；同程系统的稳定性具有对称性，网路中部的支路稳定性最差，越往两端，支路的稳定性越好；从总体上讲，同程系统的稳定性差于异程系统。

The concept of air floating decrease coefficient was introduced and thecomputing method about correlative parameters and stability indications of staticstability were studied considering the geometry parameters, air pressure and differentdrafts. Based on the theoretical methods of the statics of the ship, computing methodon static stability of steel cylinder block is given, the stability properties of thestructure block made up of four steel cylinders whose diameter is 10.5m werecalculated under six kinds of drafts and different aeration heights, the initialmetacenetric height of the structure block was obtained, and the stability wasevaluated under different floating conditions.

本文考虑气浮钢筒组块的几何参数、充气压力，及不同的吃水，引入气浮力折减系数的概念，研究与静稳性有关的参数和稳性指标的计算方法，基于船舶静力学的理论方法，提出了钢筒组块静稳性的计算方法，计算了四个直径10.5m的钢筒组成的结构模块在6种不同吃水及不同充气高度下的稳性指标，得到了模块的初稳性高，评估了不同浮态下的稳性。

In the dissertation, a new stabilization method, equal-density method was adopted to prepare modified asphalts with storage stability at high temperature. In this method, a compound was prepared by premixing polymer and filler, and the compound was mixed with asphalt to prepare Polymer-Modified Asphalt by changing the ratio of polymer and filler. The asphalts with good storage stability were formed with the addition of filler, by regulating the density difference between polymer and asphalt. With identifying the effect of composition factor and the technique conditions on mechanical properties of polymer/filler compound and the molecular distribution of the polymer, identifying the effect of composition factor and the technique conditions on the properties and structure of polymer/filler modified asphalt, Styrene-Butadiene-Styrene copolymer, Low Density PolyEthylene, Styrene-Ethylene-Butadiene-Styrene block copolymer modified asphalts with good storage stability and performance were prepared. Rheological method, gel content analysis and swelling measurement were adopted to elucidate the interaction between the polymer and filler. Filler reduced the difference between the polymer and asphalt with the premixing technique, which led to the improvement of the storage stability of the modified asphalts. The thermo-oxidative aging process of base asphalt and PMA were studied and the effect of antioxidant additives on the base asphalt and PMA were analyzed.

本论文采用等密度方法，即预先混合聚合物与填料制备复合物，复合物在沥青中会吸收油份而溶胀，改变填料的用量从而调节聚合物与沥青的密度差异的方法，制备出高温贮存稳定的改性沥青，并研究了工艺条件和配方因素对聚合物/填料复合物力学和聚合物分子量分布的影响，系统考察了工艺条件和配方因素对聚合物/填料改性沥青性能与形态结构的影响，研制出性能优良、高温贮存稳定的苯乙烯-丁二烯-苯乙烯三嵌段共聚物、氢化SBS、低密度聚乙烯改性沥青，并通过流变学分析方法及凝胶和溶胀测试探讨了聚合物与填料的相互作用，指出经过预混工艺填料改变了聚合物与沥青的密度差异，以此说明聚合物/填料改性沥青高温贮存稳定的原因；研究了基质沥青和聚合物改性沥青热氧老化过程，并分析了抗氧剂对基质沥青及聚合物改性沥青的影响，探讨了抗氧剂提高沥青耐老化性能的原因。

At the same time, the paper uses the spot price expression based on security region, which takes the consideration of transmission line thermal stability constraint and static voltage stability constraint and transient stability constraint simultaneously, thus the main security constraints of power system can be considered comprehensively in the security cost allocation.

同时，该文使用基于安全域的节点电价表达式，其中计及了输电线路热稳定约束、系统的静态电压稳定约束和暂态稳定约束，使安全成本的分摊能综合考虑电力系统中主要的安全约束。

The UV and IR spectroscopic studies of the monomer films showed that the photoreaction ratio of monomer (about 50%) was higher than the corresponding photosensitive polymer (about 10%, PVCi). The polarized IR spectra proved that obvious anisotropic absorption was displayed in the irradiated photosensitive film. With polarizing microscopy method, we found that these kinds of photoalignment films exhibited good alignment ability, and the stability of the photoalignment film could reach about 100℃. 2 A photosensitive self-assembled monolayer was fabricated that contained photo-cycloadditable groups, such as, coumarin and cinnamate. The reaction process were detected by contact angle method because the IR absorption of monolayer was very weak. The photosensitive self-assembled monolayer promote uniform alignment of nematic liquid crystals by LPUV, and it thermal stability could reach about 130℃. 3 A cationic bolaform amphiphiles was synthesized that had two photosensitive double bonds, and can be polymerized by ultraviolet. A layer-by-layer self-assembled deposition film was prepared in aqueous solution by using this material and poly (sodium 4-styrenesulfonate). The UV-Vis. spectra proved that the multilayers film was uniform and layer-by-layer. When LPUV irradiated the film, the photopolymerizable double bond underwent [2+2] cycloaddition, and the production of the reaction distributed along the polarized direction of incident LPUV. Polarized UV-Vis. spectra indicated that the irradiated self-assembled multiplayer film was anisotropic, and the dichromic ration is about 0.09, it is higher than the spin-coating method of photosensitive polymer or monomer. We used this anisotropic film as alignment layer of nematic liquid crystals, and obtained a uniform and stability alignment result, the static contrast ratio is about 100, which is very close to application of liquid crystal device. This thesis is an instance that the photochemical material was used in the physics region of liquid crystals, the route that was from photosensitive monomer, self-assembled monolayer film to self-assembled multiplayer film was undergone, by this logical research method photoailgnment of liquid crystal was extended and consummated.

围绕上述思路开展了如下工作：1合成了三种可进行光二聚反应的光敏小分子单体，LPUV 辐照制作了光控取向膜；用紫外-可见光谱法和红外光谱法分析了薄膜中的光化学反应，发现小分子的光反应程度可达到50%以上，至少比光敏高分子高出5倍；薄膜的偏振红外光谱证实，经过LPUV 辐照后薄膜出现了明显的各向异性；将小分子光控取向膜制成液晶器件，在偏光显微镜下观察看到均匀一致的液晶取向；并且热稳定性达到100℃左右，接近实用化要求。2制备了含肉桂酸、香豆素基团的自组装单层膜；采用接触角的方法监测自组装反应的动力学过程；紫外-可见光谱证实了自组装单层膜在石英基板表面形成；自组装单层膜经LPUV 辐照后能诱导液晶均匀取向，而且热稳定性可达130℃，热稳定性进一步提高。3合成了含有光敏双键的双季铵盐，在水溶液状态下将它和聚乙烯基苯磺酸钠沉积生成layer-by-layer 自组装多层膜，紫外-可见光谱证实这是一个逐层均匀的沉积；在LPUV 照射下，自组装膜中的光敏双键按照偏振方向发生[2+2]环加成反应，形成取向膜，用二向色性值评价的分子取向度高于高分子及小分子光控取向膜的水平；实验证明用自组装多层膜制成的液晶器件亮暗态均匀，静态对比度约为100，达到实用化器件的水平。

The paper relying on project practice of the express highway from Taiyuan to Changzhi of Shanxi Province, according to demanding of "Technical Specifications for Construction of Highway Asphait Pavements ", combining with own region climate characteristic and concrete design, and construction request, it has carried out SBS modified studying on shell-90# asphalt, so drawing a conclusion: 1. Having studied the quantity of SBS modifier"s effect on the temperature sensibility, the high temperature stability, the low temperature resistance to cracking , elasticity and the durability of asphalt ,meanwhile, having studied the quantity of SBS modifier"s effect on the water stability, the high temperature stability , the low temperature resistance to cracking of asphalt mixture, having compared SBS modified bitumens various function. As a result ,when the amount of SBS added is 5%, every function is comparatively even.

本论文依托山西省太—长高速公路建设的工程实践，按照《沥青路面施工技术规范》的要求，结合本地区的气候特点和具体设计、施工要求，对壳牌90#沥青进行了SBS改性研究，得到如下结论：(1)研究了SBS改性剂用量对沥青的温度敏感性、高温稳定性、低温抗裂性、弹性及耐久性的影响，同时研究了改性剂用量对沥青混合料的高温稳定性、低温抗裂性和水稳定性的影响，比较了SBS改性沥青的各项性能，结果表明当SBS掺加量为5%时，各性能较为均衡。

We also discussed the estimation of stability region of discrete singular systems with delay, and presented several region estimaitons for uniform stabiity and asymptotic stability, respectively.

我们还研究了离散滞后广义系统稳定域的定量估计，分别给出了系统一致稳定区域和渐进稳定区域的估计公式。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48