查询词典 stability conditions

In different conditions on fluidized state and stability of conical fluidized bed. The conlusions are: the conical angel of the conical fluidized bed is 20°, the fluidized state havesmall difference in conical distributor and distributor plate. The angle of conical bed increase,the fluidized state will have big difference. The angle is 60°and the conical as distributor, themass of fluidized is less, the most of material is the bottom of conical bed. The effect ofdistributor plate is much better than the conical distributor. Sawdust and rice hull can fluidize.The annular gap of conical distributor different, the angle of conical bed is same, the fluidizedquality of 10mm annular gap is better than the other conical distributors. The annular gap ismore wide, the conical bed have more slugging phenomenon and the pressure fluctuate is turnbig.In the experiment the flow of 2％and 4％distributor plates don\'t easy to control, becausethe pressure is very big and the pressure fluctuate of conical bed is too big.

在不同的条件下对锥形床的流化状态和稳定性进行了研究，结果得出：锥形床的锥角为20度时，分布锥和分布板的流化状态相差不明显，随着锥形床锥角的增大，分布锥和分布板的流化现象会出现明显的变化，锥形床锥角越大，分布锥的流化状态变化越明显，流化的的物料越少，大量物料都聚集在锥形床底部，而分布板在加料量少的情况下，能流化起来。10mm、15mm和20mm环隙分布锥在锥形床锥角相同条件下，10mm环隙分布锥的流化质量要好于其它两个分布锥，环隙越大越容易出现腾涌现象的产生，压降波动范围增大。2％、4％和6％开孔率分布板在本实验测定时，2％和4％开孔率分布板的流量不容易调节，同时产生的压降波动范围也很大，比较来说，6％开孔率分布板流化质量好些。

The research were carried out under the different conditions of the sun light, heating water bath, pH value and metal compand to study the stability of the curcumin and its lipsomes.

分别在不同光照、加热、pH及不同的金属离子条件下考察了姜黄素及其脂质体的稳定性以及对其影响程度。

By comparing the error correction capability and stability under different signal-to-noise ratio conditions, and packet loss rate of the block code and the convolutional code in the same signal-to-noise ratio condition, the results show that correcting ability of this algorithm is better than that of other method under the low delay condition, and it can adapt the different network delay condition.

通过对比在不同的信噪比条件下卷积码的纠错能力和稳定性，以及在相同信噪比的情况下对分组码和卷积码的丢包率，说明本文算法的纠错能力在低解码延迟条件下好于现有方法，能适应不同的网络延迟条件。

In order to compare the oxidative stability of cold press ed oil with the supercritical carbon dioxide extracted oil under light and dark conditions, the Peroxidative Value was evaluated with Sensory Evaluation.

为了比较冷榨制取与超临界CO2萃取的核桃油的氧化稳定性，测定了它们在黑暗和光照条件下的过氧化值，并进行了感官品评。

The preparative technique of solid lubricant is cold-press sintering method.The micro-structure , friction surface, lubricant transfer film surface of base material was characterized by SEM; XRD was used to do phase analysis. The degrees of crystallinity of pure PTFE under the different conditions of water cooling, air cooling and furnace-varying cooling were made comparison by XRD. The thermal stability of pure PTFE and solid lubricant was analyzed by DSC-TG; The composition and valence state of elements in the surface of carbon fiber ,solid lubricant before and after friction test and lubricant transfer film were characterized by XPS; The frictional property of solid lubricant was tested by pin and disk test rig .

用SEM表征原料微观结构、摩擦表面及润滑转移膜表面形貌：用XRD进行原料物相分析，及比较水冷却、空气冷却、随炉冷却三种工艺条件下的纯聚四氟乙烯树脂的结晶度；用DSC-TG分析纯聚四氟乙烯树脂及固体润滑剂的热稳定性；用XPS表征碳纤维表面、固体润滑剂摩擦前后表面、润滑转移膜表面的元素组成、价态变化；用销盘式摩擦磨损试验机对固体润滑剂进行摩擦性能测试；采用专用的台架模拟试验机对固体润滑剂镶嵌轴承套与钢轴摩擦副间的摩擦磨损性能进行测定；用莱次偏光显微镜测试固体润滑剂的硬度；用材料试验机测试固体润滑剂的抗压强度等。

Japonica and the dark-adapted time would have some effects on the values of ERG of the compound eye of P. japonica. In the same conditions, the ERG value of the male adult was larger than the female;the ERG value of the adult on night was larger than the one in day;the ERG value would increase with the dark-adapted time and made stability in end.

白天和夜晚暗适应一定时间，在相同的相对光强度下，雄成虫的ERG值大于雌成虫；暗适应一定时间，在相同的相对光强度下，雌雄成虫的ERG值均为夜晚高于白天；无论是在白天还是在夜晚，雌雄成虫的ERG值均随暗适应时间的延长而增加，并最后达一平台。

Under the working conditions of alkaline zinc electrodes and in the range of charge and discharge potential, the composite inhibitors were proved to have good chemical and electrochemical stability themselves, and to keep their effect for a long time.

最后，通过双电层电容的测量、电化学阻抗谱、稳态极化曲线和红外光谱的分析，提出了复合代汞缓蚀剂的吸附行为理论、缓蚀作用机理和协同作用机理，很好地解释了实验的结果，并为进一步选择、设计复合代汞缓蚀剂提供了理论基础。

It is not enough to resolve all of the problems related to the hydraulic stability only to analyze the stable field in passing components. Finally, the paper numerically simulated the transient field in prototype's draft tube under different operating conditions by means of Reynolds stress turbulence model and analyzed the law of motion of vortex rope as well as the performance of low-frequency pressure pulsation and compared with field test results.

仅仅对机组的过流部件进行稳定场的CFD数值分析还不足以解决所有与水轮机水力稳定性有关的问题，因此在本论文的最后，采用雷诺应力湍流模型对真机尾水管在不同运行工况下进行了非稳定场的CFD数值解析，分析涡带的运动规律及其产生的低频压力脉动特性，并与真机的试验结果进行了比较，结果比较吻合。

High load high temperature resistant, good performance, and braking stability, mud in winter and bad conditions, the disc brake driving drum brake easier than in a relatively short period of time to stop the car

高负载时耐高温性能好，制动效果稳定，而且不怕泥水侵袭，在冬季和恶劣路况下行车，盘式制动比鼓式制动更容易在较短的时间内令车停下

High load high temperature resistant, good performance, and braking stability, mud in winter and bad conditions, the disc brake driving drum brake easier than in a relatively short period of time to stop the car Can collapse in vehicle principls shrinkage occurs when the frontal impact crushing forward, to ensure the shrinkage crew chest from harm CAE simulation technology for application of the original design, the change process, CAE analysis method and combining with engineering design, analysis and design, CAE and the integration of CAD most of the vehicle in the design phase problems can be resolved through simulation, can be in concept design phase is accurately forecast and control components and vehicle performance and reliability, thus in the development initial can make the future product performance and structure index guaranteed.

高负载时耐高温性能好，制动效果稳定，而且不怕泥水侵袭，在冬季和恶劣路况下行车，盘式制动比鼓式制动更容易在较短的时间内令车停下可溃缩式转向柱会在车辆发生正面碰撞的时候向前溃缩，以保证乘员胸部免受伤害 CAE仿真技术进行的全面应用，改变了原来的设计方法和流程，CAE分析和工程设计紧密结合，实现了分析与设计同步、CAE与CAD的一体化使车辆的大多数问题都可以在设计阶段通过仿真得到解决，可以在概念设计阶段就精确地预测和控制零部件乃至整车的性能和结构可靠性，从而在开发初期就能使未来产品性能和结构指标得到保证。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。