查询词典 sprues

Now, I left little tiny sprues at the end of each blade in the mold.

现在，我离开小微型注口在每年年底的叶片在模具。

Once the cylinders were cast in metal the sprues were trimmed off and the part was ready for machining.

一旦气罐投在金属注口被削减小康和部分已经做好准备，加工。

This also results in a saving in material, because trimmed-of gates and sprues would be a complete loss of the thermosetting plastic.

这也在材料中造成储蓄，因为清理浇口和浇道会是热硬化性的塑料性物质的一个完全损失。

So, by looking at these parts I went a little crazy on trimming the sprues off and took bit more off some parts that I should have and this can be seen from the little light that goes on the sail.

因此，看这些部分我到有点疯狂的就精简注口关闭了一点小康的部分，我应该有，这可以看出，由小光的推移船帆。

It doesn't really matter when it comes to sizing sprues, runners, and gates, because both materials require about the same sizing.

因为两者的材料有关相同的尺寸矫正需要，所以当它到达尺寸矫正溶碴、转轮和闸的时候，它不真的有关系。

Gates and sprues are unnecessary.

浇口和浇道是不必要的。

The processes of sand casting are discussed in this section, including patterns, sprues and runners, design considerations, and casting allowance.

本节讨论砂型铸造工艺，包括型模，浇注口，浇道，设计考虑因素及铸造余量。

New "Heat loss into mold" property for hot runners/gates/sprues (previously hard-coded constant value).

热流道的模具热损失性能分析。早期版本仅仅定义为常量。

One benefit of thin-wall molding is that as wall sections drop, there is less material to cool. Cycle times can drop by 50%with aggressive wall-thickness reduction. Careful management of the melt-delivery system can keep runners and sprues from diminishing that cycle-time advantage.

模具的材料也应该被检查。P20钢在传统的应用中广大被使用，但是，由于薄壁注射的压力不断的增大，模具也必须做得更坚固。H-13钢和其它的坚韧的钢为薄壁的工具提供了额外的安全保证。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失