查询词典 spray

After the \4ear resistant alloy with high melting point is sprayed on the prototype, the spray formed layer is backupped, the prototype is separated from the spray layer, the post processing is completed, and a high precision perdurable metal tool is finally produced.

在该原型表面熔射高熔点耐磨合金后，通过对熔射层背衬补强、并将原型与熔射层分离以及后处理，即可制得高精度耐久金属模具。

Shenyang Research Institute of Chemical Industry, Shenyang 110021, China Abstract: Spectrophotometric analysis showed that the peak absorbance for food dye of Allura Red and biological dye of Ponceau-G occurred at 501 and 510 nm. In sunlight after 2, 4, 6, 8, 10 hours, the decomposition rates of Allura Red and Ponceau G were between 2.4 to 5.8% and 3.4 to 10.8%, so they are stable in sunlight. The recovery rates on cottons and glasses were very high, so they are easily recoveried from targets. Further studies showed that the recovery rates of two dyes on the leaves of wheat, cabbage, cucumber and tomato were different, so it need previously determine the recovery rate of tracer on the target crop to adjust the result. Field experiment showed it was easy to measure the pesticide spray distribution of high volume spay and low volume spray to use Allura Red and Ponceau-G as tracers.

沈阳化工研究院，沈阳 110021 摘要：光谱分析表明，食品染色剂诱惑红和生物染色剂丽春红-G的最大吸收波长分别为501 nm和510 nm ；在连续2、4、6、8、10 h阳光照射下，分解率分别在2.4%~5.8%和3.4%~10.8%之间，见光稳定性良好；两种染色剂在棉花叶片和玻璃片上的洗脱回收率都很高，说明易于从靶标上洗脱下来；进一步测定表明，两种染色剂在小麦、甘蓝、黄瓜、番茄叶片上的洗脱回收率各不相同，所以对准备进行测试的作物应先做一次洗脱回收率试验，用以校正测试结果；田间应用表明，用两种染色剂做示踪剂，可以方便地测定常量喷雾和低容量喷雾过程中农药在麦田的沉积分布情况。

Among patients who'd suffered a cough caused by postnasal drip for an average of seven years, a combo of an antihistamine spray and a steroid spray brought relief for 76 percent of subjects.

在饱受鼻涕倒流而引发的咳嗽平均达到七年左右的病人之中，抗组织胺喷雾剂与类固醇喷雾剂的组合给76%的病人减轻了痛苦。

A comparative study of porosity, oxide coontents, bond strength and wear resistance of 3Cr13 stainless steel coatings deposited by high velocity and regular arc spray processes was carried out. An orthogonal and rotational regression experimental method and an ordinary single-factor experimental method were adopted to evaluate the coating hardness with respect to the effect of processing parameters. The quantitative formula of processing patameters with coating hardness was obtained by means of microcomputer.The results show that, compared with the regular arc spray process, a dense?

对比研究了3Cr13不锈钢高速电弧喷涂涂层和普通电弧喷涂涂层的孔隙率、氧化物含量、涂层结合强度和滑动磨损性能，并采用多因素正交旋转回归设计和单因素对比试验的方法研究了高速电弧喷涂工艺参数对3Cr13不锈钢涂层显微硬度的影响，用微机回归得到了喷涂工艺参数与涂层硬度之间的定量关系式。

The results show that, compared with the regular arc spray process, a dense coating with lower porosity, higher bond strength and higher oxide contents were produced by a newly developed high velocity arc wire spray process.

结果表明，和普通电弧喷涂涂层相比，高速电弧喷涂涂层组织致密、孔隙率低、涂层氧化物含量增多，涂层－基体界面结合强度大于40？

The influences of superheater spray desuperheating and reheater spray desuperheating on thermal economy of a 600MW unit were calculated.

以某600 MW机组为例，分别计算过热器喷水减温和再热器喷水减温在不同减温水来源的情况下对机组热经济性的影响。

Some sub-models of the original KIVA code were modified, by introducing into the Kelvin-Helmholtz and Rayleigh-Taylor model for spray breakup, the multiple laminar and turbulent characteristic timescale combustion model, the heat transfer model of Han and Reitz, the Hiroyasu and Nagle soot model and the improved Shell auto-ignition model were added to the original KIVA, to improve the predictions of engine spray, ignition, combustion, gas/wall heat transfer and emissions.

为提高模拟精度对标准的KIVA程序进行了改进，引入KH-RT雾化模型、层流和湍流多重特征时间尺度燃烧模型、Han和Reitz传热模型以及Hiroyasu和Nagle碳烟排放模型来模拟柴油机多次脉冲喷雾、燃烧、壁面传热及排放过程，同时增添改进的Shell自燃模型来模拟着火过程。

The results show that the microstructures of these three kinds of coating are different from those of the matrix (20 steel). The wear resistance of the flame spray coating is 4. 9 times that of the matrix. This is caused by the existance of hard noncrystal microparticals. The wear resistance of the coating by flame spray welding is 6. 3 times that of the matrix. The reason is that the fine crystal grains can be formed and the solution strengthening, dispersion hardening can be induced by these alloy elements. The resistance of the laser remelt coating is 8. 8 times that of the matrix. This is due to the solution strengthening, dispersion hardening and the existence of very hard dendritic crystal, eutectic and martensite in the microstructure.

作者指出，喷涂层由于层内有一定数量高硬度的合金非晶质点存在，其耐磨性是钢基体的4.9倍；喷熔层内合金晶化产生的晶粒细小，合金元素能起固溶强化作用，也能生成化合物产生弥散硬化作用，故此耐磨性是钢基体的6.3倍；激光涂敷层除所含合金元素产生的固溶强化和弥散硬化作用外，表层组织为高硬度的枝晶+共晶和马氏体，故其耐磨性是钢基体的8.8倍。

Based on the tentatively study on vaporing drift loss of spray irrigation in Maowusu sandlot we draw a conclusion that wind speed and the relative humidity of air are the important factors to influnce loss of spray irrigation in there .

对毛乌素沙地喷灌条件下蒸发漂移损失进行了试验研究，经数据分析，得出风速和空气相对湿度是影响当地灌水损失的重要因素，当风速

Based on the tentatively study on vaporing-drift loss of spray irrigation in Maowusu sandlot,we draw a conclusion that wind speed and the relative humidity of air are the important factors to influnce loss of spray irrigation in there.

近年来，喷灌技术已成为解决干旱与半干旱地区缺水问题的重要节水技术措施。作为衡量喷灌工程可行性与有效性的重要指标，喷洒水利用系数也受到研究者的广泛关注。

The circulation, consumption and reproduction of the trilogy have not only testified to its historical significance and literariness, but also invested it with new meanings.

该三部曲的流通、消费与再生产不仅验证了其历史意义及文学性，而切还赋予它以新的意义。

If he thought that he could buy me off, he would be wrong.

如果他认为他可以收买我，那他就大错特错了。