查询词典 spray-wash

It's lucky that daubers will aperiodically organize some specialized graffiti activities so the enthusiasts can gather in some certain place and spray together towards those specific walls with their airbrush spray guns , that scene is quite spectacular.

好在有涂鸦者会不定期地组织一些专门的涂鸦活动，爱好者聚集在专门的场所，对着专门的墙体用喷枪一齐随性喷射，场面通常十分壮观。

Chassis seals model batholith to seal model to be different from general antirust processing, be a kind of tall adherent sex flexible spray of rubber tree fat is on chassis, because of its spray or diaphragm of substance of approximate balata form is formed after brushing besmear, make chassis and outside completely cut off, not easy and weather-shack, fall off, can prolong automobile body life.

底盘封塑底盘封塑不同于一般的防锈处理，是将一种高附着性的柔性橡胶树脂喷涂在底盘上，因其喷涂或刷涂后形成近似橡胶状物质保护膜，使底盘与外界隔绝，不易干裂、脱落，可延长车身寿命。

A new criterium based on the ratio of local spray dragging force to local smoke buoyancy was proposed to analyze the stability of smoke under sprinkler spray.

对水喷淋作用时液滴与烟气层的相互作用过程进行分析，采用单位体积液滴拖曳力与烟气浮力的比值作为参数，建立了水喷淋作用时烟气层稳定性的判断方法。

Based on the operational principle of spray desuperheater and several typical desuperheaters,a new type spray desuperheater was designed.

根据喷水减温器的工作原理，结合减温器的几种典型结构形式，设计了一种新型喷水减温器。

The results show that, firstly, Stellera chamaejasme L, which rely on their developed axial root system in the 10～40cm soil layer to occupy the competitive priority of volume, length, surface area and so on, in the case of their adaptive faculty to poor surroundings resulting from fruit picking, trampling and overgrazing as well as with the phenomenon of restrained growth among various plants, gradually become the dominant plant in the herbaceous community; secondly, this kind of degraded grassland has not displayed any general characteristic of degradation such as surface exposure, accumulative quantity of vegetation reduced, water loss, soil erosion and so on, therefor, it should be dealt with distinguishingly; thirdly, if"Stellera chamaejasme L Killer"and"Oxytropis ochrocephala Killer"invented by CAS are taken advantage of respectively in the bloom period of Stellera chamaejasme L and at the beginning of florescence of Oxytropis ochrocephala bunge by ultra-low volume spray of 1. 05L/hm〓 and 1. 35～165L/hm〓 dosage separately, the death rates of poisonous herbs may achieve above 95% and 92% correspondently; fourthly, this technology with the characteristics of high work efficiency, exclusive selectivity and convenient operation, is safe to non-target plants and other animals, and has no toxic or side-effect to environment; furthermore, an execution of"Stellera chamaejasme L Killer"spray and a two-year grazing prohibition can be effectively applied on degraded grasslands of"Weed and Poisonous plants Type".

结果表明：狼毒凭借发达的轴根系在10～40cm土层中形成的体积、长度、表面积等竞争优势，以及对采食、践踏、过度放牧所形成的不良环境的适应能力和异株克生现象的存在，逐步成为草群中的优势植物；毒杂草型退化草地没有表现出地表裸露、植物蓄积量减少、水土流失等一般性退化特征，对该类草地的治理应区别对待；应用中科院研制的'灭狼毒'和'灭棘豆'分别在狼毒盛花期和黄花棘豆初花期，以1.05L/hm〓、1.35～165L/hm〓的施用量超低容量喷雾，毒草的死亡率可达到95％、92％以上；该技术具有工效高、选择性专一、灭效高、操作简便，对非靶标植物和其它动物安全，对环境无毒副作用的特点；采用喷施'灭狼毒'+短期禁牧措施，可以有效治理毒杂草型退化草地。

To set and audit inspection report of EMPT, inspection report of import, inspection report of shipment, analysis report of size and tolerance, galvanization inspection report, salt spray testing report, throw pill and shake pill and spray examination report etc.

制定和审核产品EMPT送样检测报告、过程检验报告、入库检验报告、出货检验报告、尺寸公差分析报告、电镀检验报告、盐雾试验报告、抛丸/振模/喷塑等检验单。

Do spray test after installing spray nozzles, if sprayed water is froglike, as accords with design requirements.

水雾喷头安装后进行充水喷淋试验，喷水达到雾状，效果符合设计要求。

To study technology of spray drying in decompression and freeze for making microcapsule of cyminum essential oil,choice and combination of wall material,dose of core material filled,homogeneization pressure,times and pivotal parameters of spray drying in decompression and freeze were respectively in vestigated.

介绍了喷雾减压冷冻干燥法生产孜然精油微胶囊的工艺技术，通过实验分别对壁材的选择组合、心材的填加量、均质压力次数及喷雾减压冷冻干燥法各项参数的研究，最终确定了最佳的工艺条件，微胶囊产品达到了预期的效果。

Methods AH dry powder inhalation was prepared by spray-drying method. Following spray-drying, resultant powders were characterized using scanning electron microscopy and laser diffraction, and the aerosolisation performance was determined using twin-stage liquid impinger. The process conditions were optimized with orthogonal design combined with multi-index test. The powder yield, aerodynamic diameter, angle of repose and respirable fraction were used as indices for orthogonal design.

采用喷雾干燥法制备盐酸氨溴索干粉吸入剂，采用双层液体碰撞器测定盐酸氨溴索干粉吸入剂体外沉积率，扫描电镜观察粉粒的形态，激光粒度测定仪测定粒径大小，以产品收率、粉末的空气动力学径、休止角及体外沉积率为考察指标，通过正交设计结合多指标综合评价法优化最佳制备工艺。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80～100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100～300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能，且合金内的V元素会向表面富集，因此，钛合金真空热处理和表面涂层的烧结温度不能过高，即应低于其相转变点；通过对生物活性梯度涂层的组成和结构的设计，分析和计算了梯度涂层内的应力大小和分布，结果表明：对于本研究，当成分分布系数n=1.5时，可以获得较合理的涂层力学性能，即在沉积开始时，采用富含BG颗粒的悬浮液，以便在钛合金侧获得同底层BG有良好过渡的富BG涂层；梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定，改变成分分布系数，只能改变涂层内应力变化的趋势；涂层的厚薄不影响涂层内的应力分布规律，但涂层越薄，涂层内的应力变化越快，但这并不意味着涂层越厚越好，因为涂层越厚，涂层允许的变形越小，对于应用于弯曲受力部位的涂层而言，涂层应薄一点为好(50μm)；而对于仅纯受剪切应力的部位，如牙根种植体，涂层可适当加厚(80～100μm)；通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现，它们在水溶液体系中很难发生电沉积；在无水乙醇溶液中，HA颗粒带正电，可在阴极钛合金片上发生均匀的电泳沉积，而BG颗粒则带负电荷；利用复分解反应法，可以制得100～300nm的HA，通过诱导HA在BG颗粒表面结晶，可对BG颗粒进行表面包覆，获得了被HA包覆的BG颗粒，改变了BG颗粒表面的带电特性，使BG和HA颗粒在无水乙醇中均带上正电荷，从而实现了HA和BG颗粒在阴极上的共沉积。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。