查询词典 spine of vertebra

After one year of low-calcium diet, the BMD of lumbar spine was measured again to ensure the eatablishment of osteoporosis animal model. According to the ladin square design, 20mg bBMP/fibrin sealant, 20mg bBMP and FS were injected into L4、L5、L6 vertebra respectively.

术后3个月时，①采用组织病理学对骨小梁结构进行组织病理学观察；②采用DEXA对腰椎椎体骨质的整体骨密度进行测量；③采用MicroCT对骨小梁微观三维结构进行分析；④采用生物力学实验评估椎体骨质的结构力学强度。

Methods: Injured patients of cervical spine was cayyied on X-ray inspection.,then according to the result of ADI and LADS ,next to CT or MRI inspection ,and that was to guide clinical diagonosis and treatment.To observe atlanto-dental interval (anterior arch of atlas posterior border to odontoid process anterior border) and odontoid process caster(included angle between axis of ordinate of odontoid process and axis of ordinate of odontoid vertebra) on the X-ray lateral projection.

对有颈部外伤史的病人常规行X线检查，然后根据寰齿间距和齿突侧块间隙的结果，行下一步CT检查或者MRI检查，指导临床治疗方法的选择。X线侧位片观察寰齿前间隙(为寰椎前弓后缘与齿突前缘距离)，齿状突后倾角(齿突纵轴与枢椎体纵轴的夹角)；开口正位片上测定齿突侧块间隙。

In some cases, the height of vertebra could be increased after the operation, however, it is not for the technology but for the posture of patients that the patients would pronate on the table and over-straight their bodies. In this situation, bone cement can be injected into the vertebras and enhance the int ensity, change the spine kyphosis, recover the spine physiological line, so it gets to the aim of treatment.

有时病椎术后高度增加，不是椎体成形术操作本身抬高椎体高度，而是在病人俯卧位时进行的体位引起过伸而复位，此时椎体内再加入骨水泥固化，使椎体固定在复位后的位置上，并且增加了耐压强度，同时改变了脊柱的后凸畸形，恢复了脊柱生理力线，这样就会达到治疗目的。

Results Mucopolysaccharidosis typeⅠ had characteristic X-ray changes of bones:①Enlarged skull and hook- shape Sella Turcica;②Short and thick phalanges and metacarpal Bones;③Dilated central part and thin ends of upper and lower limb bones;④Kyphosis deformity of spine, beak-shape stick out of anteroinferior margin of Kyphosis deformity vertebra;⑤Broadening ribs as paddle shape;⑥Shallow acetabulum and enlarged Acetabular Angle;⑦Prolonged femoral neck, Coxa Vara or coxa valga.

结果 粘多糖病Ⅰ型具有较典型的骨骼X线改变，(1)头大，蝶鞍呈乙型；(2)掌指骨粗短；(3)上、下肢骨中央膨胀两端变细；(4)脊椎后凸成角，后凸椎体前下缘成鸟嘴状突出，上下椎体呈卵圆形；(5)肋骨增宽呈船桨；(6)髋臼变浅，髋臼角增大；(7)股骨颈增长，髋内翻或外翻。

Methods Respectively analyzed the X-ray, CT and image post-processing manifestations of mucopolysaccharidosis type Ⅰ. Results Mucopolysaccharidosis typeⅠ had characteristic X-ray changes of bones:①Enlarged skull and hook- shape Sella Turcica;②Short and thick phalanges and metacarpal Bones;③Dilated central part and thin ends of upper and lower limb bones;④Kyphosis deformity of spine, beak-shape stick out of anteroinferior margin of Kyphosis deformity vertebra;⑤Broadening ribs as paddle shape;⑥Shallow acetabulum and enlarged Acetabular Angle;⑦Prolonged femoral neck, Coxa Vara or coxa valga.

结果 粘多糖病Ⅰ型具有较典型的骨骼X线改变，(1)头大，蝶鞍呈乙型；(2)掌指骨粗短；(3)上、下肢骨中央膨胀两端变细；(4)脊椎后凸成角，后凸椎体前下缘成鸟嘴状突出，上下椎体呈卵圆形；(5)肋骨增宽呈船桨；(6)髋臼变浅，髋臼角增大；(7)股骨颈增长，髋内翻或外翻。

For each patient, a 3D reconstruction of the spine was obtained from calibrated biplanar radiographs.3 The reconstructed models were then used to compute 4 indices of the thoracic segment: the Cobb angle, thoracic kyphosis (measured from T4–T12), axial rotation of the apical vertebra, and the orientation of the plane of maximum curvature with respect to the sagittal plane.22,2 Measurements of coronal and sagittal plane curvature were based on a curve fitted mathematically through the centers of the vertebrae.

对冠状面和矢状面的角度测量基于通过椎体中心的合适的曲度数学计算。

Spine specimens were fixed to the biomechanical elongation tester (Shimazu AGS-J, Japan) with the upper clipping at the vertebra dentata, T1 and T12 vertebra, the lower clipping at the superior part of thigh bone. Under the different states, keeping or removing psoas muscle, the extended stress (N/mm^2 )of different segments of spine at the flexed and extended positions of hip joint were measured respectively.

上端十字头分别夹枢椎、第1胸椎和第12胸椎，下端十字头夹股骨上部；分别作有腰大肌状态下和切断腰大肌状态下，股髋自屈曲位到过伸带动脊柱自屈曲位到过伸位拉伸试验，测定两种不同状态下脊柱各节段的伸展应力。

Strut-graft with an appropriate distraction after corpectomy plays an important role not only in regain and maintain the cervical spine lordotic curvatures but also in acquire the global immediate stability of the cervical spine. After single vertebra corpectomy, the proper range of distraction between the superior and inferior vertebra maybe among 4-6 millimeters.

中下颈椎单椎体次全切除减压后，适当高度的撑开植骨对恢复和维持颈椎曲度以及手术节段的即刻稳定性有重要作用，中下颈椎单椎体次全切除减压后支撑植骨的高度应该是在手术椎体的上位和下位椎体间高度的基础上再撑开4～6mm左右。

Objective. To stress the importance of the fusion angle of the occipitocervical spine based on an unusual case of upper-airway obstruction after a posterior fusion from the occipital bone to the second cervical vertebra (O-C2) in a flexed position.

目标：通过一例少见的后路枕骨与颈2在屈曲位融合术后出现上气道梗阻的病例强调枕颈脊柱融合角度的重要性。

Cases recovered completely, and some various complications occurred in 14 cases. Conclusion Harrington rod is an effective internal fixation device for the reduction of fracture and dislocation of vertebra with its longitudinal stress. This device corresponds to the biomechanics of the spinal column. But during the operation, complications should be avoided or diminished by performing strict aseptic technique, bending of the rod to a proper physiological curvature which corresponds to injured spine, doing posterior bone grafting and using corset support after operation.

结论哈氏棒是一种符合生物力学的内固定器材，具有较强的纵向撑开力，能使骨折脱位得到很好复位，但亦具有一些缺点，如术中能做到置钩前预制好骨孔，并将哈氏棒预弯成与伤段脊柱相应的生理弧度，加用钢丝固定双棒，行后路植骨融合，术后使用支架保护，严格无菌操作等，可大大降低并发症的发生。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。