查询词典 speed change

The paper induces and analyzes research method of the tooth, including Method line of the tooth theory,Envlopment theory, Camus theory, Circling cluster theory and so on.Based on the past theories,the new measure to deduce the chain wheel tooth equation of roller chain at high speed,Circling cluster and envlopment theory,is proposed by analyzing basic concept of equidistant curve and Willis theory.Following the presentation of drawing lessons from traditional roller chainof the change of stanza line distance. A new type of roller chain at high speed is given in the paper.The paper studies deeply structural characteristics, the change of stanza line distance,separation between plank and bore and so on.According to design requst of roller chain at high speed and the study ofH_y--V_0 tooth chain,the impossibility that Quasi-conjugage engagement theory isrealized by the engagement of roller chain at high speed from the aspect of theory is decribed.

作者综述了高速滚子链国内外研究现状，并进行了以下研究工作：归纳分析了齿形法线法理论、包络法理论、卡姆士定理、圆族法理论等齿形研究方法，在此基础上，结合齿形啮合基本定律，分析了等距曲线的基本概念，提出了一种推导高速滚子链链轮齿廓方程的新方法—圆族包络法；在借鉴普通变节距滚子链的基础上，本文提出了一种新型的高速滚子链链条，深入研究了高速滚子链链条结构特性及其变节距、板孔中心分离等特性。

Theobserved strain is 10~2 times as local point strain at the same observed stress.This indicates that macroscopical symmetrical rock is quasi-brittle materialwith microcosmic heterogeneousness and its macroscopical mechanicalbehavior is the results of reciprocity and magnification between microcosmiccharacteristic, not simple sum.(4) The degree of irregularity of strain increases with the number of cycle.But degree of irregularity of transverse strain fluctuates larger at the samecycle. Moreover degree of irregularity of transverse strain is larger than that ofaxial strain. This shows that deformation and failure of rock is process ofevolvement of small crack. Small crack evolves from even and out-of-orderstatus to heterogeneous and ordinal status.(5) Ultrasonic speed decreases with the number of cycle. The decreasecourse is such: Firstly, ultrasonic speed fluctuates in a steady scope in somecycles; And then ultrasonic speed quickly decreases to a certain more smallvalue; Afterwards in succedent cycles, ultrasonic speed fluctuates about thevalue. That is to say, ultrasonic speed fluctuates and decreases at intervals ofcycles. In deformation process of rock, quantitative change and qualitativechange of its small crack evolvement carry through crosswise.(6) Strength and modulus of rock decrease with exponential function asscale of specimens increases.

同一表观应力下，局部点应变与表观应变相差可达2个数量级，表明宏观上均匀的岩石是具有细观特征的准脆性材料，其宏观力学行为是细观特征相互作用、放大的综合结果，而不是简单的叠加；(4)岩样轴向应变不均匀程度和横向应变不均匀程度随循环次数的增加渐进增大，但是在同一个循环内，横向应变离散系数随应力的变化波动较大，且同一循环级别下，横向应变不均匀程度大于轴向应变不均匀程度，表明岩石内部微裂纹的演化是岩石变形破坏的本质特征，这一演化表现为微裂纹从均匀无序分布逐渐向非均匀有序发展；(5)随循环次数的增加，所有岩样内部超声波速会出现衰减，衰减过程表现为在某几次循环内超声波速在某一相对范围内波动，然后急剧减小到某一较小值，在随后的循环内，超声波速又会保持在这一较小值附近波动，即超声波速表现为波动和急剧减小间隔形式衰减，表明从宏观看来平稳的岩石变形过程，内部结构演化过程(微裂纹发展及其相互作用)却表现为均匀量变和突发质变不断交叉进行的现象；(6)岩石强度和弹性模量随尺度增大呈指数函数规律减小。

We cannt get result on how to change course and speed to make collision avoidance, this can help little on collision avoidance decision.The article aims at the default on Radar simulator and implements the standard result on Radar simulator by making use of MCU.the main production is below:First, we calculate how to chang course and speed on the destine point by MCU. We get the new course and new speed on the destine point,we get the point to resume original course and speed, we get the distance and azimuth to resume original course and speed on given course and speed, the six essential: DCPA, TCPA, distance, azimuth,real speed and real course.

本论文针对当前雷达模拟器标绘训练中的不足，实现了利用单片机进行雷达模拟器标绘标准值的计算，主要成果有以下方面：首先，利用单片机计算得到了在预定点改变航向和改变航速的计算，求得预定点改向的新航向C_N和预定点变速的新速度V_N，恢复原航向和原航速的时机点的计算；在给定避碰的新航向、航速的条件下，计算出恢复原航向／航速的时机点H的距离R_H和方位θ_H；目标船的六要素，即DCPA、TCPA、距离R、方位θ、真航速V_T和真航向C_T。

In order to improve the tower crane working efficiency, windlass mechanism has a set of gear change mechanism, are devided into high speed,mid speed and low speed, the gear change mechanism gained three speed through connecting 2 DLM5-40A and 1 DLM5-63A brake, control 3 brake by LHK switch,when it with the function of low-speed heavy-load, get through the model DLM5-63A brake; when it with the function of mid-speed mid-load and high-speed light-load, get through the model two DLM4-40A brake, and the operator can choice the good position as the weight of the goods, when change the speed, must be cut off the motor, 26 FUSAN CONSTRUCTION MACHINERY CO.,LTD PDF 文件使用"pdfFactory Pro"试用版本创建 www.fineprint.cn FUSHAN TOWER CRANE OPERATINGINSTRUCTIONS-QTZ125G(FS6016) no change speed when driving it.

为了提高塔机的工作效率，卷扬机构设有一套变速装置，分重，中，轻三档，变档装置是通过分别接通两个 DLM5-40A 和一个 DLM5-63A 电磁离合器来获得三种速度。用转换开关 LHK 控制三个电磁离合器，重载低速时，接通 DLM5-63A 电磁离合器，中载中速和轻载高速时，分别接通其余两个 DLM5-40A 电磁离合器，司机可根据物品的重量选择合适的档位，换档时，必须使电机断电，不允许在电机运行过程中换档。

Possible speed means that in the good climatic and traffic condition, the automobile is only influenced by the geometry line shape of the highway; the driver with skilled technology drives the travel speed that the automobile may reach while going along certain highway.Possible speed is decided by geometry line shape of the road mainly, its change can reflect the change state of the line shape of the road, and the geometry line shape of the road play a very important role to emergence of the traffic accident, so the change of the possible speed can reflect the security state of the road.

可能速度主要由道路的几何线形决定，它的变化可以反映道路线形的变化状况，而道路的几何线形条件对交通事故的发生起着举足轻重的作用，因此可能速度的变化情况能够直观的体现道路的安全状况。

Paper-making process changes such as change of pulp network speed ratio (pulp network speed ratio refers to the flow speed and screen flow velocity ratio), pulp filler for the change, the proportion of the changes will affect the internal structure of the paper.

造纸工艺的改变如浆网速比的改变(浆网速比是指浆流速量与网流速量之比)、浆种的改变、加添料比例的改变，城市感化纸弛的本质布局。

If the axial flow pump are used for diesel or gasoline engine power, and can change the size of variable-speed throttle; if the axial flow pump with the power machine is linked to the use of triangular belt or flat belt drives the overhead, you can change to variable speed drive pulley diameter, the replacement of driving wheel or the driven wheel can be, the purpose is to change the transmission ratio.

如果轴流泵是采用柴油机或汽油机作动力的，可改变油门大小来变速；如果轴流泵与动力机相联是采用三角皮带或平皮带间接传动装置的，则可以改变传动皮带轮直径来变速，更换主动轮或从动轮都可以，目的是改变传动速比。

Reducing mechanism includes silicon control, gear, worm and gear, the reducing mechanism is three-stage converter speed-change gear, and turnover mechanism makes housing seat invert by worm and gear.

减速机构是由可控硅、齿轮、蜗轮蜗杆配合完成，减速箱中的减速机构是三级变速机构，而翻转机构是通过蜗轮蜗杆带动箱体翻转。

When the system starts, the speed outer ring saturats non-functional, the current inner ring plays a major role to regulate the starting current to maintain the maximum so that the speed linear change, to reach a given value; when it operates steadily, the speed negative feedback from the outer ring plays a major role ,to let the speed changes with the given speed voltage , at the same time the current inner ring regulates the armature current of motor adjustment to balance the load current.

该系统起动时，转速外环饱和不起作用，电流内环起主要作用，调节起动电流保持最大值，使转速线性变化，迅速达到给定值；稳态运行时，转速负反馈外环起主要作用，使转速随转速给定电压的变化而变化，电流内环跟随转速外环调节电机的电枢电流以平衡负载电流。

Fourth, real estate prices have gone up speed change.

第四，房地产价格上升速度的变化。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。